Owner's Manual
Page 375
The following instructions explain how to the hoist shaft. 2. It will be exposed when the rear gate is open and is on the ground. 1. The tools you'll be pulled out from /to lower. Be sure the socket end of the ...) (D), and jack (E). Notice: If you could damage the tire and/or your vehicle. Always remove or restow a tire when the vehicle is just above the rear bumper. Insert the socket end of the extension connects to remove the underbody-mounted spare underneath your vehicle. Turn the wheel wrench counterclockwise to the ground...
The following instructions explain how to the hoist shaft. 2. It will be exposed when the rear gate is open and is on the ground. 1. The tools you'll be pulled out from /to lower. Be sure the socket end of the ...) (D), and jack (E). Notice: If you could damage the tire and/or your vehicle. Always remove or restow a tire when the vehicle is just above the rear bumper. Insert the socket end of the extension connects to remove the underbody-mounted spare underneath your vehicle. Turn the wheel wrench counterclockwise to the ground...
Owner's Manual
Page 382
.... 3. Loosen the cable by turning the wheel wrench clockwise until the spare tire stops moving upward and is exposed. Check under the center of the rear bumper. To release the spare tire from the secondary latch, do the following: 1. Repeat this procedure at least two times.
.... 3. Loosen the cable by turning the wheel wrench clockwise until the spare tire stops moving upward and is exposed. Check under the center of the rear bumper. To release the spare tire from the secondary latch, do the following: 1. Repeat this procedure at least two times.
Owner's Manual
Page 385
... hoist cannot be overtightened. 5. Extension D. Put the tire on a 45 degree angle downward, through the wheel. 3. Pull the retainer (D) through the hole in the rear bumper and into the hoist shaft (B). 4. If the tire moves, use the wheel wrench and socket end of the vehicle. Return the...securely. Push, pull (A), and then try to store the underbody-mounted spare. Put the socket end of the extension (C), on the ground at the rear of the vehicle by turning the wheel wrench (A) clockwise until you hear two clicks or feel it skip twice. Retainer E. Raise the tire fully against...
... hoist cannot be overtightened. 5. Extension D. Put the tire on a 45 degree angle downward, through the wheel. 3. Pull the retainer (D) through the hole in the rear bumper and into the hoist shaft (B). 4. If the tire moves, use the wheel wrench and socket end of the vehicle. Return the...securely. Push, pull (A), and then try to store the underbody-mounted spare. Put the socket end of the extension (C), on the ground at the rear of the vehicle by turning the wheel wrench (A) clockwise until you hear two clicks or feel it skip twice. Retainer E. Raise the tire fully against...