Operation Manual
Page 5
...handling the trimmer so that you can wind onto the old spool. Operating Tips To reduce line wear and improve trimming performance, use any material other than Toro .065 inch dia. (1.6 mm) nylon monofilament may overload the motor, possibly causing a fire or electrical shock. Replacing Line For replacement line, ...; Do not force the trimmer. Do not use the following techniques when trimming: • Remove any wire, rope or string-like matter which could become entangled in the rotating line from the trimming area. • Trim only when the grass and weeds are available from the top...
...handling the trimmer so that you can wind onto the old spool. Operating Tips To reduce line wear and improve trimming performance, use any material other than Toro .065 inch dia. (1.6 mm) nylon monofilament may overload the motor, possibly causing a fire or electrical shock. Replacing Line For replacement line, ...; Do not force the trimmer. Do not use the following techniques when trimming: • Remove any wire, rope or string-like matter which could become entangled in the rotating line from the trimming area. • Trim only when the grass and weeds are available from the top...
Operation Manual
Page 6
...1/8 inch (3 mm), or you do not fully install the spool and cap, the trimmer could throw them for any cutting line left on the spool. m-7854 m-6303 3352-878 Remove any damaged or worn parts. 6 Removing the Spool 1. Thoroughly clean the cutting head and cap and inspect them.... 2. Twist the cap off , install it before installing the spool. 3. Hook one end of the arrow on the spool, allowing no more than 1/8 inch (3 mm) to you are replacing the spool with a new, pre-wound spool, discard the empty spool and skip this section. 1. Twist the cap on securely clockwise....
...1/8 inch (3 mm), or you do not fully install the spool and cap, the trimmer could throw them for any cutting line left on the spool. m-7854 m-6303 3352-878 Remove any damaged or worn parts. 6 Removing the Spool 1. Thoroughly clean the cutting head and cap and inspect them.... 2. Twist the cap off , install it before installing the spool. 3. Hook one end of the arrow on the spool, allowing no more than 1/8 inch (3 mm) to you are replacing the spool with a new, pre-wound spool, discard the empty spool and skip this section. 1. Twist the cap on securely clockwise....