Bosch WFMC2201UC Support Question
Bosch WFMC2201UC Support Question
Find answers below for this question about Bosch WFMC2201UC - Nexxt 300 Series Washer.Need a Bosch WFMC2201UC manual? We have 4 online manuals for this item!
Question posted by garrisonml on August 19th, 2014
Bosch Nexxt 300 Series Washer Will Not Spin Or Agitate.
Found on the internet to how to put into dervice mode, which I tried and received a P:01 and E:20 error. What would I need to look at or replace?
Current Answers
Related Bosch WFMC2201UC Manual Pages
Pedestal Installation Instructions - Page 2
... nonĆobservance of this warning. Figure 1 1. 17 mm open end wrench 2. 6 mm Allen (Hex) wrench 3. (4) Socket Head Cap Screws and
(4) Flat Washers 4. (4) Height Adjustable Feet 5. (4) Spacers 6. If you need to uninstall your appliance, refer to do so can result in the pedestal drawer:
Definitions d WARNING
WARNING - Failure to the Operating, Care...
Pedestal Installation Instructions - Page 3
... be reinstalled prior to the left side.
Preparing Your Appliance
Existing Appliance - i Your washer was originally
shipped with the assembly to allow it against the floor as support.
Support ...in injury or damage.
4. Figure 3 q Insert the bolt assemblies. NOTICE
Make sure the washer transportation bolts are in the slot on its side.
5. q When installing the first bolt assembly...
Pedestal Installation Instructions - Page 4
...large piece of the unit. Figure 5
4.
Doing so can result in case the appliance needs to be noticed due to Installing the Pedestal"
section of the pedestal while moving the ... Foam packaging may be reinstalled later without the pedestal. NOTICE
If installing the pedestal to a new washer, do so can be used . Support the appliance approximately 1 1/2" to installing the pedestal. 2....
Pedestal Installation Instructions - Page 5
...10).
d CAUTION
Avoid holding the appliance by the pedestal when lifting it passes through the flat washer, pedestal housing, then the spacer, and into the protruding threaded bushing in place, insert the bolt... N-m).
To avoid damaging the pedestal do not use the feet that are
included with the washers and spacers in the base of the pedestal. NOTICE
Use only the feet supplied with the...
Pedestal Installation Instructions - Page 7
...does not wobble. For Washers: Fine tune the leveling by aligning it in spin cycle and then leveling the appliance again. Replace the drawer by placing a small load of laundry in the machine, ...touches the floor firmly. 3. For problems with a pair of the appliance. i If the test spin cycle is available in place by freely opening and closing the drawer. Ensure slides of the appliance ...
Installation and Use & Care (all languages) - Page 2
...Bosch NexxtR washers deliver the most stubborn stains with the spin speed of the washer, based upon the fabric
setting and water temperature of your laundry...washer and dryer times with our unique suds sensor, you wait for the toughest stains. Quiet Performance Bosch laundry...with Technology Operation Logic. Stainless Steel Drum The Nexxt washer drum has hundreds of smooth double punched holes...
Installation and Use & Care (all languages) - Page 3
...
Changing a program 20
Add a garment / Interrupting the program 20
Canceling active program 20
After Washing 20
Cleaning and Care 21
Cleaning the washer 21
Descaling the washing machine 22
Troubleshooting of Minor Faults 23
Customer Service 25
STATEMENT OF LIMITED PRODUCT WARRANTY 26
STATEMENT OF WARRANTIES FOR BOSCH CLOTHES WASHERS 28
Exclusions 28
Program Selection Table...
Installation and Use & Care (all languages) - Page 4
... As the gas is used for washing
and spinning.
- Do not tamper with any source of...lock).
- This modern washing machine cleans your laundry using your household. d CAUTION
CAUTION- It...Definitions d WARNING d
WARNING - ATTENTION
ATTENTION - BOSCH washers are indicated in a hot water system that ...this warning. Do not repair or replace any part of this appliance where...
Installation and Use & Care (all languages) - Page 7
...surface where it is to be installed on a second floor, the floor may need to be retained for any of the bolts all 4 transport bolts must be ... floor and well leveled due to the higher spin speeds available.
Closet If installing the washer in a corner of the washing machine with foam backing, are not designed to be installed on the Bosch pedestal (accessory no . Dimensions
a = 27...
Installation and Use & Care (all languages) - Page 11
...washer. 2. i If the test spin cycle is locked against the washer housing. Turn off the water. - Make sure that direction.
5. Level the washer as low as necessary to make it .
q A center-located bubble indicates the unit is closer to check the leveling status of laundry...transport bolts:
Loosen the screw in spin cycle and then leveling the washer again.
d CAUTION
TO AVOID ...
Installation and Use & Care (all languages) - Page 16
... recommended to remove persistent, dried on stains. The heater may appear on the laundry. Too much detergent: Not environmentally friendly, excessive suds reduce wash agitation producing poor washing and rinsing results or may prevent proper spinning.
Keep detergents and additives out of the reach of the detergent manufacturer. The specifications of children. Measuring...
Installation and Use & Care (all languages) - Page 17
... be used to obstruction).
Sturdy, hard wearing items made of your front-loading washer. Permanent Press Warm Items consisting of the programs are dependent upon the cycle. ... and underwear. Permanent Press Cold Items consisting of laundry in wash performance. Bulky items, e.g.
These cycles have selected a reduced spin speed for preĆtreatment of cotton or linen...
Installation and Use & Care (all languages) - Page 18
... locked for use the Heavy duty
The indicator light conveys the following information: - Adding laundry is not possible
because the door is lit red.
The Start time must drain the ...last rinse. For delicate laundry, the water remains in time of the cycle.
The washing cycle time is emitted. Rinse Plus
option with 1 hour increments) by selecting Drain or Spin and starting a program...
Installation and Use & Care (all languages) - Page 20
...q Open the door. Laundry can be interrupted, however the door cannot be added in Pause" mode when the drum is ...should not cause concern. q Turn the program selector to dry.
20 q When this program ends.
q If required, change the ...program. q Close the door.
i For Spin, select the desired spin
speed (but not no final spin). q Unload the laundry. q Turn the program selector to Off....
Installation and Use & Care (all languages) - Page 21
...drum and rubber seal -TO AVOID Risk of the detergent dispenser.
21 q Rub dry with a pressure washer. coins, paper clips, nails): q Use a chlorineĆfree cleaning agent. q Clean the detergent ...the hose from the power outlet before cleaning.
ATTENTION
Occasionally check for any
program (except Spin or Drain). Cleaning the strainer(s) on the washing machine On both the hot and cold ...
Installation and Use & Care (all languages) - Page 23
...and display is flashing E:01" Spin speed cannot be resumed when...laundry is flashing E:04" with no water reĆ maining in progress; see Page 21.
Turn on . see Page 20...washer produce fewer suds and will be removed during a power failure, call Customer Service (refer to Off before spinning...Spin. Wait until the program ends; Eliminate the cause. Select a program.
Replace...
Installation and Use & Care (all languages) - Page 24
... amount of suds. Add detergent according to minimize this is not a fault.
Repeated spinning. The laundry was automatiĆ cally suppressed.
Unsatisfactory washing result. Too much soap or non-HE....
Use less detergent for you High Efficientcy washer produce fewer suds and will include the letters HE" on the laundry. Detergents specifically designed for future wash loads....
Installation and Use & Care (all languages) - Page 26
...and (6) any alterations including without limitation, one of its authorized service providers will replace your Product (upgrade models may be fully liable and responsible for a period of...by BSH Home Appliances ("BOSCH") in this Statement of limited product Warranty applies only to the Bosch 300 Series washer ("Bosch") sold to you, the first using a
Bosch-authorized service provider during ...
Installation and Use & Care (all languages) - Page 28
... two years from date of the applicable warranty period. The Warranties provided herein are not transferable.
1 Year Full Limited Warranty From Date of Installation*
Bosch will repair or replace, free of charge, any clothes washer after the delivery date.
TO OBTAIN WARRANTY SERVICE. HUNTINGTON BEACH, CA 92649 BE SURE TO PROVIDE YOUR CLOTHES...
Installation and Use & Care (all languages) - Page 92
92
Program selection table Nexxt 300 Series
Please read and observe Operating, Care and Installation Instructions carefully before using the washing machine !
Drain pump operates prior to and during spinning.
9
Drain
To drain water after a program with the "No final spin" option for gentle treatment of delicate laundry.
2
* Actual program duration may be different from the indicated...
Similar Questions
Stacking Kit For Bosch 27 Inch 300 Series Washer And Dryer Set
I am searching for the correct kit to stack my 27 inch Bosch WFVC4400uc/24 washer and my WTVC4300US/...
I am searching for the correct kit to stack my 27 inch Bosch WFVC4400uc/24 washer and my WTVC4300US/...
(Posted by stevendebbie22 3 years ago)
Bosch Nexxt 300 Series Washer Water In Drum When Sitting
(Posted by niksaidyle 9 years ago)
Where Is The Bosch Nexxt 300 Series Washer Water Drain Hose Located
(Posted by najtoum 10 years ago)
How To Remove Front Access Panel On Bosch Nexxt 300 Series Washer
(Posted by eaaug 10 years ago)
How To Take A Pump Off A Bosch Nexxt 300 Series Washing Machine
(Posted by lilpodi 10 years ago)