I Need Dish Network Remote Codes To Operate My Panasonic Home Theater

I Need Dish Network Remote Codes To Operate My Panasonic home Theater

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by MaryBDish on November 14th, 2012 3:01 PM

This answer was accepted by the poster of the original question.

MaryBDish

Member since:
December 30th, 2010

Points: 627,730

1,150
points

Hi, I would be happy to assist you with programming your remote to the Panasonic Home Theater. The codes are 783,808, or 818. You will most likely want to program the remote to work in the AUX mode and here are the steps.

Press and hold down the AUX button on the top right side of the remote until all the other buttons on top light up and then let go.

If you are programming a code into AUX Mode, you must do the following before entering the device code:

Press 0 for a TV (if TV code is 500, enter 0500)

Press 1 for a VCR/DVD (if DVD code is 617, enter 1617)

Press 2 for any other device (if device code is 639, enter 2639)

Then enter the 3 digit code 783, 808, & 818.

Press the Pound (#) button under the number 9.

AUX Volume Override:

Then you will need to place the remote in Aux Volume override which will have the remote change the volume on the surround sound and not the TV.

1. Press and hold the AUX mode button. To disable AUX Volume, press and hold the TV mode button. All the buttons on top will light up.

2. Press the pound (#) under the number 9.

3. Press the Volume UP button.

4. Press 0 (Zero)

5. Press Pound #.

If you have any additional questions or concerns, please email me directly. Thank you!

Mary Catherine Brady
DISH Internet Response Team
[email protected]
Tuesday-Saturday 2:45pm-11:15pm(MST)

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote)
...remote controls need this so that function for the correct TV1/TV2 operation. Press the POUND (#) button twice. The remote will tend to install in SAT mode. A maximum of RCA TV codes...AUX codes for the DISH Network logo on the remote control in a home theater environment. Remove the UHF Pro remote battery cover and remote configuration Indicator Tab. The Green TV1 IR remote should...
Tech Portal : (choose receiver model) : Remotes : (choose remote)
...code that is programmed into TV Mode, (you can also be compatible with that function for AUX mode) corresponding to pick up , the equipment will power off after each digit is configured for Green 1 TV1 operation. Record The number in a home theater...universal remote. Press and release the Up button once a second while pointing the remote at the receiver . The light will need ...
Tech Portal : 3750 : Errors & Troubleshooting
...is unlocked. If using the remote, and wait for a period of the TV or home theater system is the receiver connected...software download the receiver may not be needed to basics and only leaves the receiver or operator error as the problem. The TV ...not viewed, channels are locked and removed from EPG, missing codes on the account, service interruption on the account, old software ...