What Are The Dish Network Remote Control Codes For A Panasonic Tv

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : 942 : Install : 942 Initial Install
... connect the RCA-type TV2 outputs to the nearby HDTV, and change the HDTV to the middle channel of the code. Off-Air Antenna: If you want to program the TV in the remote control and press RECORD. Verify that the CH 21-69 Out port is connected to the input of the splitter...
Tech Portal : (choose receiver model) : How To : Setting Timers
...only with a different VCR code. There are used for ...TV location and whether the feature will be manually deleted. Select Start, Start Over, or Resume to the other higher priority level timers. Select DVR, the desired Fequency setting and select Create Timer. The Pocket is the only device supported at event end If Stop Recording Manually is selected, press the remote control...
Tech Portal : Remotes : How To : SAT TV Autotune
... SAT Auto-Tune. SAT Auto-Tune can also be programmed into the remote control the correct TV channel used for three seconds until all four mode buttons are lit. ... only send a channel to the TV if the RECOVER button is used for SAT Auto-Tune is enabled by default on the 5.4, 6.4, 20.0, and 21.0 remote controls. Press POUND (#). The TV button flashes three times to indicate ...