Home » Dodge » Technical Support » 2009 Dodge Journey

2009 Dodge Journey Support Question

Find answers below for this question about 2009 Dodge Journey.
Need a 2009 Dodge Journey manual? We have 2 online manuals for this item!

Dodge Overview Questions Manuals Reviews Videos Research

Question posted by trailhiker82 on August 14th, 2013

How To Remove And Install Shift Indicator

The person who posted this question about this Dodge automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Manual Pages

Owner's Manual - Page 16

... is turned to run, and it as soon as the starter engages. Ignition Key Removal Place the shift lever in the ignition. Don't leave the key in PARK. A child could be...of reasons. WARNING! Leaving unattended children in a vehicle. Refer to the LOCK position and then remove the key. Opening either front door will remain active for approximately 45 seconds after the ignition ...

Owner's Manual - Page 18

... cannot be used to the vehicle electronics. Once a transmitter is programmed to a vehicle, it indicates that there is a fault in the engine being used to any other RF electronics will not ...as possible. CAUTION! Should this system. Cell phones, pagers, or other vehicle. Always remove the keys from the vehicle and lock all doors when leaving the vehicle unattended. This ...

Owner's Manual - Page 21

... on the RKE transmitter or insert a valid ignition key into the ignition lock cylinder and turn the key to indicate the alarm is disabled as well. If the previously described arming sequence has occurred, the system will cancel the ...unlock the doors. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 19 To Arm the System 1. Remove the key from the ignition switch and exit the vehicle. 2.

Owner's Manual - Page 29

... • HAZARD switch off • BRAKE switch inactive (brake pedal not pressed) • Ignition key removed from outside the vehicle while still maintaining security. The parking lights will flash and the horn will remote start: • Shift lever in the Remote Start mode for a 15-minute cycle. How To Use Remote Start...

Owner's Manual - Page 51

...Use The Automatic Locking mode any time a child safety seat is installed in the shoulder belt. How to disengage the Automatic Locking mode and.... 2. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 49 4. However, the belt will continue to remove slack in a seating position that you will here a clicking sound. As the belt retracts,... position. This indicates the safety belt is extracted. 3.

Owner's Manual - Page 73

... are to be appropriate for your child restraint: • Before buying any restraint system, make sure that you can install the child restraint in the vehicle with the seat belt or remove it from the child restraint to the vehicle structure. Check the label on getting the most out of the child...

Owner's Manual - Page 76

.... This should not play with them. NOTE: • Ensure that the tether strap does not slip into the seat, removing slack in the strap. • When using the LATCH attaching system to install a child restraint, please ensure that they should stow the seat belt out of the reach of the seatcover material...

Owner's Manual - Page 79

... seat in pet harnesses or pet carriers that the tether strap does not slip into the opening between the seatbacks as you remove slack in the engine at the factory is not required for the engine in the front seat could lead to increased head ... will occur. Use only the anchor positions directly behind the child seat to a good break-in a collision. The engine oil installed in the strap.

Owner's Manual - Page 133

... endanger the occupants of an accident. • Do not leave a head restraint that is removed from a seat loose in the vehicle. Failure to follow this warning may result in personal ...injury to sit in a seat without having the head restraint installed and adjusted properly. Adjustable Head Restraint 3 To remove the head restraint, you or your passenger in the event of the...

Owner's Manual - Page 193

... the cover housing) into the left attachment point or the right attachment point (shown). 3 Installing Retractable Cargo Area Cover Then, insert the spring-loaded post on the opposite end of the ... housing faces upward. To install the cover, position it in the cargo area. You can also remove the cover from loose cargo. It will not prevent cargo from shifting or protect passengers from the...

Owner's Manual - Page 207

...shows the level of the vehicle where the fuel filler cap is restarted. Fuel Cap Indicator This symbol indicates the side of fuel in heavy traffic, or when towing a trailer. The gauge... ignition switch is turned off . Coolant Temperature Gauge The temperature gauge indicates engine coolant temperature. CAUTION! Also, shift the transaxle into NEUTRAL and idle the vehicle. Do not leave your...

Owner's Manual - Page 208

Also, shift the transaxle into the normal range. CAUTION! Idle the vehicle with a hot cooling system could...continuous chimes, turn it off immediately and call for more information.) NOTE: As the coolant temperature gauge approaches H, this case, the indicator light will flash continuously and a continuous chime will sound. If the A/C system is allowed to pass H. If the light turns ...

Owner's Manual - Page 212

... 12 seconds after performing the scheduled maintenance) perform the following procedure: 1. Unless reset, this procedure. Turn the ignition switch to indicate the next scheduled oil change indicator system is started. A loose, improperly installed, or damaged fuel filler cap may fluctuate dependent upon your personal driving style. If the problem persists, the message will...

Owner's Manual - Page 216

... to "Tire Pressure Monitor System (TPMS)" in Section 5 for a variety of reasons, including the installation of the same size, type, and/or style. TPMS malfunctions may result. (Refer to "Tire ... after replacing one or more information). 214 UNDERSTANDING YOUR INSTRUMENT PANEL When the malfunction indicator is not of replacement or alternate tires or wheels on the vehicle that prevent the...

Owner's Manual - Page 222

NOTE: The shift lever must be in PARK to calibrate it. To calibrate the compass, first, start the engine....However, prior to Zone 1. Then, press and hold the COMPASS/TEMPERATURE DISPLAY button until the direction displays with the "CAL" indicator on continuously (approximately 10 When setting the variance, the numbering will wrap around from Zone 15 to calibrating the compass, make ...

Owner's Manual - Page 309

... occupants to rest or sleep in your car. A child could be caused by inadvertently moving the shift lever. interior heat buildup may cause serious or fatal injuries. 5 Accidents can also be seriously or...may cause serious injury or death. • Be sure to turn OFF the engine and remove the key from the ignition switch if you want to buckle their seat belts. WARNING! •...

Owner's Manual - Page 314

... lose control of PARK. If your right foot is running. Furthermore, you to the ON position. 3. Insert the ignition key into PARK, remove the key from the ignition, the shift lever is in the PARK position, securing the vehicle against unwanted movement. Before exiting a vehicle, you should never exit a vehicle while the...

Owner's Manual - Page 315

... prevents the key from PARK to NEUTRAL. 6. This is a normal condition, and precision shifts will develop within a few shifts on a new vehicle may be somewhat abrupt. While holding the release lever forward, move the shift lever from being removed unless the shift lever is in the ON position and the brake pedal is in PARK...

Owner's Manual - Page 320

...in the instrument cluster on the transaxle range indicator. AutoStick General Information • You can be more noticeable when Autostick is engaged. Moving the shift lever to the Left (-) triggers a downshift .... The gear position will be moved from side to side. The system will only shift up when maximum engine speed is reached while Autostick is moved out of the AutoStick ...

Owner's Manual - Page 376

...! • Never have any smoking materials lit in or near the vehicle when the gas cap is removed or the tank filled. • Never add fuel to the vehicle when the engine is running. ... problem persists, the message will display in loose, improperly installed, or damaged, the word "gASCAP" will appear the next time the vehicle is an indication that the fuel filler cap in the odometer. This is...