EdgeStar IB450SS Support Question
EdgeStar IB450SS Support Question
Find answers below for this question about EdgeStar IB450SS.Need a EdgeStar IB450SS manual? We have 1 online manual for this item!
Question posted by sconnett on November 18th, 2015
My Ib450ss Turns On And Water Flows But No Ice Is Produced.
The water flowing over the grate never gets very cold. Any idea why no ice is being produced? The icemaker is an Edgestar IB450ss.
Current Answers
Answer #1: Posted by TommyKervz on November 21st, 2015 6:48 AM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,813
Member since:
January 10th, 2013 Points: 17,776,813
Possible reasons:
- The ambient temperature or the water temperature is too high.
- Refrigerant liquid leakage.
- A pipe in the cooling system is blocked
Solution:
- Please run the ice maker in temperatures below 90°F and/or pour colder water into tank.
- Consult a qualified technician if Refrigerant liquid leakage.
Related EdgeStar IB450SS Manual Pages
Owner's Manual - Page 1
IB450SS Clear Ice Maker Owner's Manual
This owner's manual provides instructions on safe installation, use, and maintenance.
Owner's Manual - Page 4
...-14 Installation Types 12-13 OPERATION 14-15 Final Checklist before Operation 15-16 Operating Method 16 How the Machine Makes Ice 17 How the machine uses the water 17 Normal Sounds 17-18 Preparing the Ice Maker for Long Storage 18 CLEANING AND MAINTENANCE 18-20 Exterior Cleaning 19 Interior Cleaning 19-20 Condenser...
Owner's Manual - Page 6
... is recommended that a separate circuit, serving only your hands are not pinched or kinked or damaged during installation.
z Unplug the ice maker or disconnect power before operating after water line connection. z Make certain that cannot be turned off z Replace all electrical, water and drain connections in an area protected from the elements, e.g., wind, rain...
Owner's Manual - Page 7
... fins are sharp and can be discarded. TECHNICAL INFORMATION Model: IB450SS
Electrical input: 115VAC ~ 60Hz Power consumption: 13.2 kWh/100...ice produced per day will not be used for their safty. z Connect to protect hands. z Never turn the water supply tap off when the ice maker is operating. z The ice machine cleaner contains acids. Use rubber gloves to a potable water...
Owner's Manual - Page 8
Once enough of icemaker produces crystal-clear, gourmet cube ice. Note on ice storage This type of the ice has melted, the ice maker will slowly melt and go out the drain. Then the ice in the bin will automatically start making more ice. COMPONENT LOCATIONS
8
The ice bin will fill with ice and the ice maker will automatically shut off. An...
Owner's Manual - Page 9
Remove tape and glue from your icemaker. Failure to move and install icemaker. Remove packaging materials IMPORTANT: Do not remove any permanent instruction labels or the data label on your icemaker before using.
9
Ice scoop
Figure 1
Control panel Water inlet Power supply
Ice scoop
Drain hose
Unpacking
ICE MAKER INSTALLATION
Excessive Weight Hazard Use two or more people...
Owner's Manual - Page 10
... and drain fixtures in the Cleaning and Maintenance section. z The ice maker requires a continuous water supply with warm water and dry. Cleaning before using it. These products can also be between 41°F and 90°F for servicing if necessary. Location Requirements
z This icemaker should be easily removed by a licensed plumber only. See the...
Owner's Manual - Page 11
... ice maker and
wall or cabinet. Electrical Requirements
Electrical Shock Hazard Plug into a grounded 3-prong outlet. Never remove the grounding prong from the plug. Never use an extension cord. The
operating water temperature should be between 50ഘ and 100ഘ. Failure to work properly.
It is always a good idea to filter the water...
Owner's Manual - Page 12
... to lower that side of the ice maker Turn the leveling feet to the left to raise that a separate circuit, serving only your personal safety, this appliance must be raised or lowered by a switch or pull chain.
Recommended grounding method
For your icemaker, be grounded. Leveling the Ice Maker
It is equipped with the...
Owner's Manual - Page 13
... hinge, place on the right. Align the door on hinges: 1. The water supply pressure should be a minimum of installation. Set door aside. Push the...a Phillips screwdriver, remove the screws and take off bottom hinge and turn it upside down so that the handle is on the opposite side ...(A wall outlet directly behind the ice maker will make installation easier.)
13 To remove door from the...
Owner's Manual - Page 14
... pipe with wrench. 5. Tools required: ½ in . Turn on the machine. Locate the floor drain near the installation location. Consult your drain through the drain line provided with the ice maker is about 4.5 feet. 2. Free-standing installation: A free-standing installation will likely be acceptable for water supply connection leaks. to the tubing and remove...
Owner's Manual - Page 15
... installation: A recessed installation will still be necessary to allow you turned on the main water supply and the tap?
15 Have all year round? 6. Leveling the icemaker. Built-in the ice maker. 5. Install the
drain line into position. 6. If electrical outlet for
a- Has the machine been leveled? 5. Tighten
any connections (including connections at the tie...
Owner's Manual - Page 16
... the evaporator when the machine is full, the sheet of flowing water will hold the ice-full probe open.
How the machine Makes Ice Turn the ICE/OFF/WASH switch to the ICE position. Have you checked for leaks at the drain? The ice maker will start the ice making ice and automatically progresses to reduce ice melting. 5. When the ice storage bin is...
Owner's Manual - Page 17
... or high-pitched sound.
17 During the freeze cycle, water flows to you .
The water containing impurities falls back into the evaporator. Normal Sounds Your new icemaker may be new to the evaporator surface. How the machine uses the water The ice maker begins with a fixed charge of water that are two distinct cycles: freeze and harvest. During...
Owner's Manual - Page 18
...due to the refrigerant flowing in the ice storage bin that is to be necessary to drain off all water. 7. Shut off the drainage tube of ice cubes falling into the ice storing bin. Periodic... fan. Preparing the Icemaker for circulation and to shorten the intervals if you may slip off the electric supply at the main water source. 2. Disconnect the water supply line from the...
Owner's Manual - Page 19
... cleaning agents or abrasives on the interior. With a clean cloth, wipe down the interior of the unit with 2 gallons of warm water. Water distribution tube 5. The ice-making system has been cleaned and the ice storage bin is empty. 1. Do not use solvent based or abrasive cleaners. Use a soft sponge and rinse with clean...
Owner's Manual - Page 20
..., then rotate the water distribution tube back to OFF, rotate the water distribution tube, and locate the holes in the icemaker or reconnect power. Unplug the ice maker or disconnect power...water hose from the surface, rinse the tube with a brush or flowing water.
4. This can be damaged easily.
Condenser Cleaning A dirty or clogged condenser prevents proper airflow, reduces ice...
Owner's Manual - Page 21
.... Carefully read the material safety instructions on the container of ice produced after cleaning..
6. Discard the first batch of the ice machine cleaner. After cleaning, turn the machine "OFF" at least 3 minutes, then dry. 9. The ice machine cleaner contains acids. Place the ICE/OFF/WASH selector switch to the water supply , Pour 200g.
Allow 30 minutes for cycle
completion, then...
Owner's Manual - Page 23
... is not recommended that can be solved without a service call.
23 The problem could
damage the machine's controls.
• Do not let water contact the control box. and the ice size will stop working condition. 5. Ice cube size is cold, the motor will be smaller in the next cycle. If the problem persists, check the...
Owner's Manual - Page 24
... restricted. The calcium level in the water Use a water-softening apparatus installed in . The air flow to ICE (ON) Take away some heat source. Probable Correction Plug the ice maker in
is full of ice. Problem
The machine won't operate.
Tighten fitting.
The electricity is turn off. The fuse is leaking. Check water supply--filter may be more careful...
Similar Questions
Good Afternoon, My Machine Is Covered, The Water Does Not Run To Make The Ice Cu
(Posted by yaninmahernandez 2 years ago)
Ice Maker Water Keeps Running
Ice maker water keeps running and it sounds like the compressor is constitly going.
Ice maker water keeps running and it sounds like the compressor is constitly going.
(Posted by RYANOSTROWSKI 2 years ago)
What Did You Do About This? I Just Got The Same Unit, And The Same Thing Is
happening to me. It makes ice, but doesn't try to harvest. It goes directly to ice-full red LED.Than...
happening to me. It makes ice, but doesn't try to harvest. It goes directly to ice-full red LED.Than...
(Posted by mhull 5 years ago)
Control Box
The Red LED - ice full indicator- on the rear Control Box is lit and the machine has no ice in it.
The Red LED - ice full indicator- on the rear Control Box is lit and the machine has no ice in it.
(Posted by mvgraf5 7 years ago)
Ice Will Not Release From The Evaporator In Harvest Mode
(Posted by wassonj 8 years ago)