Harbor Freight Tools 62419 Support Question
Harbor Freight Tools 62419 Support Question
Find answers below for this question about Harbor Freight Tools 62419 - 18 Volt 1/2 in. Cordless Variable Speed Hammer Drill.Need a Harbor Freight Tools 62419 manual? We have 1 online manual for this item!
Question posted by FireEagle170 on June 21st, 2023
Replacement Battery
Is there a replacement battery for this drill 62419. I was told when I bought this drill I could trade it in for the full credit of my purchase cost for a Li. Powered drill. Is this deal still good.
Current Answers
Answer #1: Posted by SonuKumar on June 21st, 2023 9:58 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,653,150
Member since:
May 9th, 2021 Points: 16,653,150
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Harbor Freight Tools 62419 Manual Pages
User Manual - Page 1
... by Harbor Freight Tools®. All rights reserved. Tools required for the safety...18 VOLT CORDLESS
REV 14g
Visit our website at: http://www.harborfreight.com Email our technical support at: [email protected]
When unpacking, make sure that the product is intact and undamaged.
Keep this product.
If any shape or form without the express written consent of purchase...
User Manual - Page 2
... death or serious injury. Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
It is the safety alert symbol.
Item 62419 Addresses practices not related to personal injury. Setup
Operation
Maintenance
Page 2
For technical questions, please call 1-888-866-5797.
User Manual - Page 3
Failure to your battery-operated (cordless) power tool. Power tools create sparks which may not provide adequate protection.
Ensure the Trigger is in electric shock, fire and/or serious injury. Dress properly. Only use a power tool while you are tired or under the influence of inattention while operating power tools may result in the work area clean and well lit.
...
User Manual - Page 4
...rate for one terminal to operate the power tool. Service
Have your application. Properly maintained cutting tools with another . Use of injury and fire.
3.
Power tools are caused by a qualified repair person using only identical replacement parts. A charger that cannot be performed. Shorting the battery terminals together may affect the power tool's operation. This will do not...
User Manual - Page 5
... shock.
3. drill torque can cause personal injury.
2. Do not lay the tool down until it...Tools for a replacement.
6. Moving parts can grab the surface and pull the tool out of the power tool ″live″ and could cause pacemaker interference or pacemaker failure.
13.
Frequently monitor the Charger and Battery...62419
For technical questions, please call 1-888-866-5797. Page 5
User Manual - Page 6
...on the user.
4. Use tools with the lowest vibration when there is a choice.
5. Let the tool do the work .
6....worsened from use. Grip tool as lightly as explained in this tool. To reduce vibration, maintain the tool as possible (while ... as possible.
2. Safety
Vibration Safety
This tool vibrates during use. Anyone using vibrating tools regularly or for an extended period should not...
User Manual - Page 7
...Specifications
Charger Input Rating Battery Rating Battery Type No Load Speed Chuck Size
120V~ / 60Hz 18V / 1500mAh NiCd 0-400 / 0-1200 RPM 1/2"
3160002
Operation
Maintenance
Item 62419
For technical questions,...fit the outlet, have it repaired by a qualified electrician. Properly connect Charger's power cord to whether the outlet is damaged. Safety
Setup
Grounding
TO PREVENT ELECTRIC ...
User Manual - Page 8
...Speed Selector
Setup
Operation
Chuck
Torque Setting Ring
Trigger
Work Light
Direction Switch
Bit Groove
Battery Switch Battery Pack
Charger Indicator LED's
1. Continuously lit (not flashing) indicates that the battery is powered.
2. Battery...
Item 62419
Maintenance
Green LED: Continuously lit indicates charger is charging.
Red LED: Flashing indicates that the battery has ...
User Manual - Page 9
... Tool forward and back to adjust from the lower speed (0-400 RPM) to fit the drill bit.
4. Setup
Operation
Maintenance
Item 62419
For technical questions, please call 1-888-866-5797. Drill Bit Installation
CAUTION! Do not remove drill bits until the bit is in the off‑position and remove its Battery Pack before set up to 1/2" drill...
User Manual - Page 10
... the material, a lower torque setting will take about one hour to insert it .
10. The Hammer setting works well when drilling/chipping into the Charger.
4. While charging, the Battery Pack, Charger, and Power Supply may become warm to release Battery Pack from 1 to prevent distraction and injury.
2. Designate a work area must be required. Place the...
User Manual - Page 11
... once the Switch is pressed and turn off the tool and remove its Battery Pack after use high speed drill bits for metal or steel drilling and turn the torque setting to keep the bit from slipping as drill bit bites into or unthread from slipping. Increase speed as the hole is released.
7.
Be sure to remove...
User Manual - Page 12
... its safe operation.
2. Cleaning, Maintenance, and Lubrication
1. NiCd BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY. Item 62419
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Make sure that may affect its Battery Pack before further use damaged equipment. AFTER USE, wipe external surfaces of the tool. Setup
Operation
Maintenance
Page 12
For technical questions...
User Manual - Page 13
... rate.
2. Replace Battery Pack. If symptoms are no obstructions, reinsert the Battery Pack according to work at its shape (it .
Forcing tool to its own rate. 2. Blocked motor housing vents.
3. Disconnect Battery Pack and Charger power supply before service.
Dispose of motor using compressed air. Have technician service tool. Battery Pack power low.
1. Battery Pack...
User Manual - Page 14
...
Qty
1 Screw M5x23
1
12 Double Head Bit
1
2 Chuck
1
13 Belt
1
3 Torque Ring
1
14 Battery Clamp
1
4 Rotary Knob
1
15 Wire
1
5 Handle
1
16 Battery Pack
1
6 Handle Cover
1
17 Right Housing
1
7 Screw St2.9x18
4
18 Screw St2.9x16
8
8 Sleeve Housing
1
19 L/R Button
1
9 Speed Button
1
20 Switch
1
10 Gear Box with Motor
1
21 Led
1
11 Left Housing
1
22...
User Manual - Page 15
Page 15 Assembly Diagram
Safety
Setup
Operation
Maintenance
Item 62419
For technical questions, please call 1-888-866-5797.
User Manual - Page 16
...replace the product at our expense, but if we determine there is free from defects in no defect, or that this warranty, the product or part must accompany the merchandise. This warranty gives you specific legal rights and you must bear the cost...Limited 90 Day Warranty
Harbor Freight Tools Co. If our inspection verifies the...and tear, or to refund the purchase price if we may also have ...
Similar Questions
Carbon Brush Size For Central Machinery 16 Inch Scroll Saw Variable Speed
what are the Carbon brush size for Central machinery 16 inch scroll saw variable speed
what are the Carbon brush size for Central machinery 16 inch scroll saw variable speed
(Posted by rickyray1983 1 year ago)
Replacement Battery Pack? (or Specs?)
This tool is not listed at H.F. anymore- Does anyone know if a name brand battery pack will fit? Als...
This tool is not listed at H.F. anymore- Does anyone know if a name brand battery pack will fit? Als...
(Posted by JD4x4 2 years ago)
Do You Sell Replacement Battery 62427?
do you have a replacement battery for 62427
do you have a replacement battery for 62427
(Posted by broncobaru66 3 years ago)
18 Volt Cordless Drill Driver Item 62427 1/2' Chuck
This is the 2nd drill like this that the gears have stripped out. Do you still sell this drill? How ...
This is the 2nd drill like this that the gears have stripped out. Do you still sell this drill? How ...
(Posted by ra82nd 4 years ago)
Need Replacement Parts For 16 Speed Floor Drill Press Model 43389
need Item 15 Locking Switch 02A0549Item 18 Switch KeyItem 19 Switch Plate CoverSonney 760-300-5377
need Item 15 Locking Switch 02A0549Item 18 Switch KeyItem 19 Switch Plate CoverSonney 760-300-5377
(Posted by hp25years 5 years ago)