Home » Hayward » Pool & Spa » Hayward Aqua Solar TC

Hayward Aqua Solar TC Support Question

Find answers below for this question about Hayward Aqua Solar TC.
Need a Hayward Aqua Solar TC manual? We have 1 online manual for this item!

Hayward Overview Questions Manuals Reviews Videos Research

Question posted by jeffnjessie on January 30th, 2015

Timer

the timer is not keeping the appropriate time. every few days it is a couple hours behind and i have to reset it.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TommyKervz on January 31st, 2015 1:22 AM

TommyKervz

Member since:
January 10th, 2013

Points: 17,776,793

100
points

on your time settings make sure you have selected the correct time zone

Hope that is helpful.
Kervz at www.satechhelp.co.za

Related Hayward Aqua Solar TC Manual Pages

Aqua Solar - Page 1

... at 25ºC/77ºF. When disconnected from the control, the sensor will read 10K ohms at other temperatures. Aqua Solar Electronic Solar Control Center Operation and Installation Manual AQ-SOL-LV AQ-SOL-LV-TC AQ-SOL-LV-SP www.haywardnet.com Temperature/Resistance /Voltage All Hayward controls use a 10K thermistor sensors. For...

Aqua Solar - Page 2

...pool, spa or hot tub shall be followed, including the following: • READ AND FOLLOW ALL INSTRUCTIONS • Disconnect all times. • A green colored terminal marked "EARTH" is only applicable to Solar... eligible for warranty repair replacement. 12 SAVE THESE INSTRUCTIONS 5-Year Limited Solar Warranty This Five Year Limited Warranty statement is located inside the wiring ...

Aqua Solar - Page 3

... sensor resistance. Use the chart on the back cover to disconnect the sensor). This error indication only occurs when the "AUX" sensor is shorted, the Aqua Solar will still operate properly. On continuously indicates a probable open circuit in the "POOL" sensor or wiring. In either case digital pool temperature display will still operate properly.

Aqua Solar - Page 4

...-250VAC, .3A 50/60Hz Valve Output: 24VAC, 20VA, .85A max. The Aqua Solar is a 2 hour minimum off time to resume normal operation. 5. The exception is when solar override is being open , the "AUX" temperature display will only be enabled/disabled via internal jumpers. "Pool Sensor" LED on or flashing "Err" on /off : Check main power circuit...

Aqua Solar - Page 5

... periods per day. The factory default is required: 1. See diagram on /off time using the series of small slide "trippers" located around the outside of a power failure. In this also turns on . TIMECLOCK (model AQ-SOL-LV-TC only) The time clock controls the hours of desired temperature setting. If enabled, the Aqua Solar will show time at...

Aqua Solar - Page 6

... wired in series with the model of this relay varies with the pool sweep and turns the pool sweep off whenever the filter pump is no other timer. The Aqua Solar will show Pool temperature. Cooling: Nocturnal Cooling is being purged from losing prime while air is active. TIME CLOCK -- This prevents the pool sweep pump from the...

Aqua Solar - Page 7

...-SOL-LV-TC with filter pump & pool sweep relays 120/240 VAC Pool Sweep Timer 240 VAC Aqua Solar (AQ-SOL-LV-TC) Booster Pump Pool Sweep Filter Pump 240 VAC Ground Sweep Pump Filter Pump NOTES: 1) Do not use a solar valve, which diverts water through the collector panels when solar heat is being powered from the pool or spa. Plug the...

Aqua Solar - Page 8

... 6 Ground the shields to the collectors. The AQ-SOL-LV-TC model comes with Solar Override & Pool Sweep Interlock Pump 120/240 VAC Contactor (240 VAC Coil) Aqua Solar (AQ-SOL-LV) Pool Sweep Timer Booster Pump Pool Sweep Filter Pump 240 VAC Ground 240 VAC Filter Pump Timer Pool Filter Pump Be careful not to cross phases on the...