Husqvarna MZ 5225 Support Question
Husqvarna MZ 5225 Support Question
Find answers below for this question about Husqvarna MZ 5225.Need a Husqvarna MZ 5225 manual? We have 2 online manuals for this item!
Question posted by Brandonswhite on November 3rd, 2022
Fuse Keeps Blowing When I Try To Start Mower
I replaced my PTO switch and began to mow. A few minutes in the blades kicked off. I found that if I pushed the PTO switch to the side the blades would kick back on. Now, when I put the new PTO switch in I kinda messed up the housing some so there was a little play that allowed me to move the switch from side to side. So after the blades did this a few times the mower just shut off. I found that the 7.5 amp fuse had melted to the fuse housing. I replaced the housing and fuse but as soon as I try to start the mower the engine makes a winding noise and the fuse blows. I replaced the PTO receiver socket but not the whole harness. I looked for grounding issues but could not find any. Can you help??
Current Answers
Answer #1: Posted by SonuKumar on November 3rd, 2022 9:02 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,653,150
Member since:
May 9th, 2021 Points: 16,653,150
https://www.youtube.com/watch?v=aQ1QStrVVOU
Sounds like you have a hot wire grounding out. Does it blow right after start up without blades engaged? If it blows when blades are engaged it could also be the PTO or electric clutch.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Husqvarna MZ 5225 Manual Pages
Owners Manual - Page 3
...Switch 21 Choke Control 21 Fuses 21 Fuel Tank 22 Fuel Shut Off Valve 23 Hour Meter 24 Tracking Knob 24 Operation 25 Training 25 Steering 25 Before Starting 26 Starting the Engine 26
Jumper cables 30 Running 31 Operating on hills 32 Mowing...belts 43 Deck belt 44 Pump Belt 45 Cutting Blades 45
Blade replacement 46 Adjusting the Mower Deck 47
Leveling deck 47 Anti-scalp rollers ...
Owners Manual - Page 5
...the manufacturer. Use only approved repair parts to the new owner. Read the contents carefully before transporting on public...drive system. Operating instructions for any trailers, etc. Lawn mowers and all who are also knowledgeable about the safety...be carefully followed.
INTRODUCTION
Congratulations
Thank you for mowing grass on lawns and even ground without obstacles such as stones,...
Owners Manual - Page 10
... or storing the machine. These operators should evaluate their ability to operate the riding mower safely enough to cause cancer, birth defects, or other reproductive system damage. Engine exhaust... laws may regulate the age of the user.
• Keep machine free of riding mower-related injuries.
Do not allow the mower deck to plow leaves or other debris buildup which is a odorless,...
Owners Manual - Page 11
... used. Do not drive up and down the slope.
• Keep all slopes requires extra caution. If you cannot back up the slope...degree of the machine. Tires may lose traction.
• Avoid starting, stopping, or turning on the slopes slow and gradual. English-11... when handling the blades.
• Never wear loose clothing that you feel uneasy on wet grass. And do not mow it will not ...
Owners Manual - Page 13
...not be started when the driver's floor plate or any protective plate for the fuel to cool at least two (2) minutes before each use and leave space for the mower deck's...• Keep the nozzle in contact with plastic liner. Always place containers on clothing, change clothing immediately.
• Never overfill fuel tank. Replace gas cap and tighten securely.
• Do not start the engine ...
Owners Manual - Page 14
...'s recommended parts, when necessary.
• Mower blades are considered to be driven with defective or unmounted protective plates, protective cowlings, safety switches, or other protective devices.
• Do... regularly.
• Keep machine free of governors and avoid running .
• Check grass catcher components and the discharge guard frequently and replace with safety devices. Clean...
Owners Manual - Page 17
... total structure MUST be used , it should not be replaced.
This mower is equipped with an internal combustion engine and should be replaced. • Check all bolts including seat belt for correct...unit by damage if the mower is overturned or if alteration to ride. • Operate the mower smoothly -
WARNING! no jerky turns, starts or stops. • When mower is stopped, set brakes...
Owners Manual - Page 21
... functions:
• 20 A, Primary fuse. • 7.5 A, Mower deck coupling.
They are two fuses with a richer fuel mixture. Fuses
8061-003
8061-004
8011-420
English-21 Fuses
Fuses are accessed by tilting the seat forward. They are located on the control panel and is used for cold starts in automobiles.
CONTROLS
5. Ignition Switch
The ignition key is placed...
Owners Manual - Page 25
..., disengage parking brake, do not engage blades at this will not move unit under its entirety prior to attempting to move both control levers back until operator becomes comfortable with the machine. Pull back slightly on control levers to the neutral position and mower should push mower (see "Before Starting" in a straight line.
Until operator...
Owners Manual - Page 26
... lever backward to the desired position. Activate the parking brake.
Starting the Engine
1. Mower deck lifting lever
8061-007
Activate parking brake before starting
8061-010
English-26 The following conditions must be fulfilled before the engine can be started:
• The blade switch for engaging the mower blades must be depressed.
• The parking brake must be...
Owners Manual - Page 30
...cables" are used for emergency starting, follow this procedure:
To attach jumper cables • Connect each end of the RED cable to the POSITIVE (+) terminal on the mower with a 12-volt negative...from the fuel tank and battery.
Keep sparks, flame and smoking materials away from both batteries.
Always wear eye protection when around batteries. If your mower to a good CHASSIS GROUND on...
Owners Manual - Page 32
... wheel is absolutely necessary, pull drive
levers into the neutral position and push to the outside of the mower and press forward to regain forward motion.
• Make all turns ...". Operating on hills
Read the Safety Instructions "Driving on the spot (zero turn) can be used before starting up or down hills.
• Avoid stopping or changing speed on hills. • If stopping is reduced...
Owners Manual - Page 33
.... Mowing pattern
8011-603
WARNING!
operation
Mowing Tips
• Observe and flag rocks and other fixed objects to clean top surface of stones and other objects that can be increased without poor mowing results.
• Avoid mowing wet lawns. The mowing result is used without negatively affecting the mowing result.
• The finest lawns are obtained by the blades.
Owners Manual - Page 36
... loose hardware (screws, nuts)
Clean under the mower deck
Start the engine and blades, listen for unusual sounds
Check for damage
Thoroughly clean around the engine
Clean around belts, belt pulleys
Check the tire pressures
Check battery
Sharpen/Replace mower blades
Clean the engine's cooling air intake 2)
Clean the air...
Owners Manual - Page 38
...battery charger will extend its life.
• Keep battery and terminals clean. • Keep battery bolts tight. • Recharge at the...with terminals in the same
position as the old battery. 7. Replacing battery 1. Using a 7/16 wrench, remove the bolts on... then the
RED battery cable and remove the battery from the mower. 6. Install new battery with plain water and dry. 4. Using two ½"...
Owners Manual - Page 39
...English-39 Check the spark plug. Replace the spark plug if fouled, the... and try again. If the machine starts when one of a turn from the seated position. Conditions for starting or driving...turning by bending the side electrode.
5. A new spark plug should be able to avoid damaging the...
4. Check that the engine stops if the mower blades are burned and if the insulation is compressed. ...
Owners Manual - Page 41
...minutes. Reinstall the precleaner over the paper air cleaner element and install on the blower housing to clean the air filter. Close and latch the door. Replace...).
Clean or replace the element as required and check condition.
6. Handle the new element carefully; ...Keep this will damage the element. IMPORTANT INFORMATION
Do not use pressurized air, as described in warm water with new...
Owners Manual - Page 48
... keep the deck in most terrain conditions.
Anti-scalp rollers Anti-scalp rollers are properly adjusted when they are just slightly off of grass or conditions being mowed.... MAINTENANCE
4.
Do not adjust the rollers to help prevent scalping in the proper position to support the deck. Blade tips should be ...with the mower on a flat level surface. English-48
Owners Manual - Page 56
...
• Drive belt for the mower deck has come loose. • Contact for the transmission slack or
has come loose from the
cable contact. • Blown fuse.
• Damaged seals, housing,... mowing results.
• Unequal tire pressure on pump open. • Drive belt for the electromagnetic coupling has
loosened. • Blade switch is too long. • Grass collected under the mower ...
Owners Manual - Page 66
... fuel shut off valve. 8. Check the idle speed 13. Check the mower deck adjustment. 11. Charge battery. 2. Check:
The safety switch for Mulching. 15. Driving backward. Certified:
English-66 Connect the contact box to both wheels. 10. Start the engine. 9. Engaging the blades. 12. Inform the customer about: The need and advantages of the...
Similar Questions
Mower Just Died.
While mowing my MZ5225ZT just died. It won't turn over now. Checked voltage at battery and have12.5v...
While mowing my MZ5225ZT just died. It won't turn over now. Checked voltage at battery and have12.5v...
(Posted by richardtallboy70 1 year ago)
Clutch Stop!!!
Had good intentions to change the Hyd Motor belt in MZ5225. Followed instructions and removed the "c...
Had good intentions to change the Hyd Motor belt in MZ5225. Followed instructions and removed the "c...
(Posted by jainsworth 3 years ago)
20 Amp Use Blows When Starting
The last time I mowed was a very hot day and I now quite a big yard. I'm mowed for about 3hrs before...
The last time I mowed was a very hot day and I now quite a big yard. I'm mowed for about 3hrs before...
(Posted by carricod01 3 years ago)
Blowig 20 Ampfuse
When Starting Mower Blows 20 Amp Fuse And Motor Makes A Whineing Nose
When Starting Mower Blows 20 Amp Fuse And Motor Makes A Whineing Nose
(Posted by kiki2kristi 6 years ago)
Husqvarna Mz 6128 20 Amp Fuse Keeps Blowing
Every time you would turn the Key the 20 Amp fuse blows. have replaced the switch and have check all...
Every time you would turn the Key the 20 Amp fuse blows. have replaced the switch and have check all...
(Posted by JonathanWilliams2961 9 years ago)