2010 Hyundai Sonata Support Question
2010 Hyundai Sonata Support Question
Find answers below for this question about 2010 Hyundai Sonata.Need a 2010 Hyundai Sonata manual? We have 1 online manual for this item!
Question posted by dobe248 on September 22nd, 2011
Drive 2 Button
what is the drive 2 button for? what happens if you push it when driving?
Current Answers
Related Manual Pages
Owner's Manual - Page 21
... the system is weak. - B070B02NF-AAT
Armed Stage
NOTE:
If you have a problem with blinking of the transmitter. The weather is the "Disarmed" stage.
Push the "UNLOCK (2)" button on the transmitter for longer than 1 second.
The ignition key is in the transmitter is armed. At the same time, the driver's door unlocks...
Owner's Manual - Page 22
... ignition key. After depressing unlock button, you must open , the system will be armed. o The doors are met, the system will be armed. 2) If this happens, rearm the system as previously described... light will repeat 2 times). NOTE:
When the system is disarmed while the "DOOR" button of the following conditions are unlocked with the transmitter. The system can also be activated if...
Owner's Manual - Page 23
...transmitter.
!
1. To turn signal lights will sound and the turn off the system, push the "PANIC" button again on the backside of the transmitter. Carefully separate the case with a coin as ...health. At the same time, the alarm horn will blink continuously for 30 seconds. 3. Push the "PANIC" button on the backside of the transmitter. 2. ONF048120
2. Remove the old battery from the ...
Owner's Manual - Page 30
... be adjusted by using the control knobs on the instrument panel.
! Minimum support 2. To decrease it, push the lever toward the rear. 1.
To increase the amount of lumbar support, pull the lever forward. Before driving, adjust the seat to the proper position so as to prevent the driver's and front passenger's head...
Owner's Manual - Page 32
...belts and airbags) is turned on. With the ignition key in the "ON" position, push either of the switches to the OFF position whenever the ignition switch is greatly reduced by ... switches in the event of serious or fatal injuries in the "OFF" position. o Each time you push the button, the temperature setting of the seat warmer is occupied by reclining your hips and chest to warm the ...
Owner's Manual - Page 33
... push and hold the release button (2) on the headrest support and lower the headrest to the desired position (1). To remove the headrest, raise it as far as it can go then press the release button ...To reinstall the headrest, put the headrest poles (3) into the holes while pessing the release button (1). Then adjust it to the appropriate height.
!
WARNING:
Make sure the headrest locks in...
Owner's Manual - Page 37
... near your neck, you return the rear seatback to its upright position after the rear seatback was folded down while pressing the height adjuster button. To lower it, push it up. Additional questions concerning seat belt operation should be disassembled or modified. 1FEATURES OF YOUR HYUNDAI
24
B160A02A-AAT B160C01A-AAT B170A02NF...
Owner's Manual - Page 40
... if their restraints are not properly secured.
You should be used. If this does not happen, check the belt to minimize the risk of a collision. For small children and babies,...Safety Administration (NHTSA), children are designed to accident statistics provided by pressing the release button in your waist. Child restraint systems are safer when properly restrained in the rear ...
Owner's Manual - Page 69
...
The cruise indicator light in the instrument cluster is illuminated when the cruise control ON/OFF button on when the washer fluid reservoir is approaching empty. They will result if the worn pads...Cruise SET indicator light does not illuminate when the cruise control "CANCEL" switch is pushed or the system is pushed again. BRAKE PAD WEAR SOUND
WARNING
The front and rear disc brake pads have...
Owner's Manual - Page 70
...pressure as indicated on the vehicle's tire information placard. If the warning light illuminates while driving, reduce vehicle speed immediately and stop and check your foot off the road. If this... with the Tire Pressure Monitoring System. Inflate the tires to the "ON" position. If this happens, the system may not monitor the tire pressure.
The warning light also comes on and stays on...
Owner's Manual - Page 74
TRIPMETER A TRIPMETER B DISTANCE TO EMPTY AVERAGE FUEL CONSUMPTION DRIVE TIME
Push in the TRIP switch when the ignition switch is a microcomputercontrolled driver information gauge that displays information related to driving, such as estimated tripmeter, drive time, average fuel consumption and distance to initialize the displayed information such as tripmeter, average fuel consumption and ...
Owner's Manual - Page 76
... '99:59'. When the RESET switch is calculated from the total fuel used is pushed, it will be initialized to '0:00' after resetting, the average fuel consumption will be...fuel consumption input. If the ignition switch is disconnected. Average Fuel Consumption (MPG) 4. Drive Time
B340A01A-AAT
LIGHT
COMBINATION TURN SIGNAL, HEADLIGHT AND HIGH-BEAM SWITCH Turn Signal Operation
...
Owner's Manual - Page 85
...To stop at any point, press any sunroof control button. Manual slide open
Press the SLIDE OPEN button on the overhead console.
This could result in the... "ON" position. Your HYUNDAI is in loss of control and an accident that may cause death, serious injury, or property damage. WARNING:
Never adjust the sunshade while driving...
Owner's Manual - Page 92
... HomeLink® Wireless Control System. During nighttime driving, this feature will automatically detect and reduce rearview mirror glare while the compass indicates the direction the vehicle is pointed.
The HomeLink® Universal Transceiver allows you to activate your garage door(s), electric gate, home lighting, etc.
Channel 1 Button Channel 2 Button Status Indicator LED Channel...
Owner's Manual - Page 93
...way to the "ON" position each time the vehicle is cycled. Press and release the button to the Gentex website: www.gentex.com. Any object that shows the vehicle Compass heading in...Zone Numbers for this difference when it knows the Magnetic Zone in the rearview mirror during driving conditions based upon detecting glare from the rear of the mirror case.
For more information regarding...
Owner's Manual - Page 94
..., the compass will appear in 2 complete circles at less than 6 seconds. Pressing and holding the button again will cause the numbers to the vehicle magnets.
Releasing the button when the desired Zone Number appears on the Zone Map. 2. To re-calibrate the compass: 1. To calibrate the compass, drive the vehicle in the display. 2.
Owner's Manual - Page 98
..., depress the release button and lower the parking brake lever while holding the button.
!
ONF058010
CAUTION:
Driving with the parking brake set the parking brake as far as possible. Before driving away, be sure... the parking brake, first apply the foot brake and then without pressing the release button in, pull the parking brake lever up the parking brake lever slightly. In addition...
Owner's Manual - Page 107
..., the cruise "SET" indicator light in the instrument cluster will illuminate. 2. If this happens, depress the clutch pedal or release the cruise control ON/OFF switch. Accelerate to avoid inadvertently... Pay particular attention to keep the car at a constant speed, for instance, driving in good weather. Push the control switch "RESUME (+)" and hold it may not be overrevved. While the...
Owner's Manual - Page 132
... selected is turned off , power is automatically turned on the DISC.)
4. After selecting each mode, rotate the Audio control knob clockwise or counterclockwise. CD eject Button
Push button to decrease the BASS, rotate the knob counterclockwise. But if VCD, Data CD are loaded, "Reading error" message will appear and CD will be ejected...
Owner's Manual - Page 145
...Data CD are loaded, "Reading error" message will appear and CD will disable loading process. o Push [SEEK ] button for 0.8 or longer to decrease the BASS, rotate the knob counterclockwise.
2. CD Indicator
When ... switch is ACC or ON and if the CD is not available on the DISC.)
6. Push [LOAD] button for less than 0.8 seconds and press again within 1 second to available CDC deck (from the...
Similar Questions
What Constitutes Severe Driving Conditions For A Hyundai Sonata
(Posted by Swatmhw 10 years ago)
Does The Car Drive Slower With The Esc Button On For A 2010 Hyundai Sonata
(Posted by sojo 10 years ago)
Does The Random Button Work On Ipod Via Usb On Sonata
(Posted by morrsaji 10 years ago)
2007 Hyundai Sonata Gear Shift Will Not Move Without Pushing Reset Button
(Posted by ehacomand 10 years ago)
A Button In The Trunk Of My 2001 Hyundai Sonata Was Accidentally Pushed Locking
trunk so it cannot be opened either with the key or the remote. Is there an unlock button somewher...
trunk so it cannot be opened either with the key or the remote. Is there an unlock button somewher...
(Posted by mkarpisek 12 years ago)