2013 Kawasaki KX250F Support Question
2013 Kawasaki KX250F Support Question
Find answers below for this question about 2013 Kawasaki KX250F.Need a 2013 Kawasaki KX250F manual? We have 1 online manual for this item!
Question posted by sherrydiamond on July 13th, 2016
Won't Idle/stay Running
We have replaced a lot of parts already and cleaned everything. Wiring has been checked and engine runs great but it won't idle or stay running.
Current Answers
Related Manual Pages
Owners Manual - Page 8
...Parts ...Side Stand...Fuel ...Fuel Requirement:...Kick Pedal ...Starting the Engine ...DFI Setting Data Selection ...Shifting Gears...Stopping the Motorcycle...Stopping the Engine ...Break-In...Daily Pre-Ride Checks ...After-Race Checks ...MAINTENANCE AND ADJUSTMENT...Periodic Maintenance Chart ...Engine...and Bolts...Cleaning Your Motorcycle...Lubrication...DFI Self-Diagnosis ...TROUBLESHOOTING GUIDE...TUNING ...
Owners Manual - Page 21
... changing the wiring connector on the right front of the • Change frame to suit various track conditions. They are available to suit the track condition with the engine stopped. Track Condition Soft Standard Hard Connector Color White Green Black
NOTE
j
żIf the connector is changed while the engine is running, the DFI...
Owners Manual - Page 24
... 3/4 throttle opening . 3. Break in procedure as follows. 1. Stop and let the engine cool completely. NOTICE
When any following parts have been replaced, the same break-in the engine as the new motorcycle must be carried out for one .
Start the engine and let it idle until it is ready for about 40 minutes within 1/2 throttle opening...
Owners Manual - Page 28
Periodic Inspection (Engine Related Item) FREQUENCY After each Every 3 races (or race (or 2.5 hours) 7.5 hours) OPERATION...carried out and must be serviced by referring to keep the motorcycle in good running condition. †: Replace, add, adjust, clean or torque if necessary. inspect † Spark plug - clean and inspect † Clutch - inspect K Crankshaft - inspect Air cleaner ...
Owners Manual - Page 33
... oil filler opening.
To ensure a proper reading of the engine.
Do not run it for several minutes for the engine, transmission and clutch to settle. Check the oil level before the oil reaches every part can cause engine seizure. Check the engine oil level with insufficient, deteriorated, or contaminated engine oil will fluctuate depending on the lower right side...
Owners Manual - Page 41
... made specifically for leaks. • Check the engine and warm up to the bottom of... system. MAINTENANCE AND ADJUSTMENT 39 the coolant is brown, iron or steel parts are rust• If ing and the system must be flushed.
Tightening ...the
air from the engine and radiator.
the cooling system for leaks. The coolant should come up to the
j
NOTE
żAlways replace a gasket with a...
Owners Manual - Page 48
... shroud bolts fol• Temporarily lowing the tightening sequence. j
the radiator shroud bolts securely. • Tighten • Install the removed parts. Bottom of the fuel tank. Check that both throttle cables run under the frame (right side). Fuel Tank C. NOTE
żInsert the fuel tank breather hose outlet end into
A.
Throttle Cables B. 46...
Owners Manual - Page 56
... the throttle a few times to correct any of the engine with damaged cables could result in an unsafe riding condition. Idle Adjusting Screw/Choke Knob B. Replace damaged control cables before operation. With the engine idling, turn the handlebars both ways and check if handlebars movement changes
Cleaning the Throttle Body Assy
the seat (see Air Cleaner section...
Owners Manual - Page 65
...Exhaust System section). • Install the fuel tank (see Spark Plug section). • Install the removed parts. • Install and close the throttle a few times to make sure they are locked and do ...not apply strong force to the delivery pipe. the throttle cable play and idle speed ad• Check justment.
and pull the fuel hose joints back and forth • Push more than ...
Owners Manual - Page 78
... reduce exhaust noise and conduct the exhaust gases away from the rider while minimizing power loss. Replace the silencer wool if the exhaust noise becomes too loud or engine performance drops.
A.
Bolts B. j
• Install the removed parts. Right Side Cover 76 MAINTENANCE AND ADJUSTMENT
• Install the two caps to drop. Silencer Wool...
Owners Manual - Page 80
... the muffler cover bolts and apply the sili• Tighten cone sealant to the joint part of the silencer wool and install • Arrange the muffler cover to the muf•...the muffler cover and muffler body. that the exhaust port of the muffler cover • Check align with a new one. • Replace the silicone sealant attaching on the muf• Remove fler cover and muffler body. Muffler...
Owners Manual - Page 85
...cause it to wear faster, inspect both the engine and rear sprockets whenever the chain is replaced, and replace them if necessary.
• •
A. ...) to the proper torque and install a new cotter pin.
• Check the rear brake effectiveness. Tighten the axle nut to 62 a 68 mm...by hanging a 10 kg (22 lb) weight on a straight part of the chain from the center of the 1st pin to ...
Owners Manual - Page 86
Master Link Clip B.
j
A. For maximum stretch resistance and safety, a genuine part must be used for use with the closed end of the "U" pointing in .)
A. Weight B. 84 MAINTENANCE AND ADJUSTMENT
żTo ...53 Standard in.) Service Limit 323 mm (12.7 in the direction of Chain Rotation
NOTE
żThe
drive system was designed for replacement. Direction of chain rotation.
Owners Manual - Page 97
If necessary, repair or replace by an authorized Kawasaki dealer. Inner Tubes inspect the front fork ...Check the front brake for oil leakage, scor• Visually ing or scratches on the outer surface of the inner
j
• •
essary. MAINTENANCE AND ADJUSTMENT 95
NOTE
żTighten the two clamp bolts alternately two times
to check for smooth operation. Install the removed parts...
Owners Manual - Page 159
L: Apply a non-permanent locking agent. R: Replacement Parts S: Tighten the upper clamp bolt first, and then the lower clamp bolt. G: Apply grease. MAINTENANCE AND ADJUSTMENT 157 Fastener Handlebar Holder Nuts Steering Stem Head ...
Owners Manual - Page 161
..., immediately wash your motorcycle with chemical substances or household cleaning products such as gasoline, brake fluid, window cleaners, ... air dry as it idle for chips and scratches. Chrome and Aluminum
Chrome and uncoated aluminum parts can be applied once every...Lubricate the drive chain to gently dry plastic parts. Start the engine and let it accelerates the chemical reaction of...
Owners Manual - Page 162
... of tires and other rubber components should be treated with a vinyl treatment. Before lubricating a part, clean off any rust with rust remover and wipe off any tread area.
• •
.../treatment to any grease, oil, dirt, or grime. Do not apply rubber protectant to clean and care for leather accessories. 160 MAINTENANCE AND ADJUSTMENT Leather, Vinyl, and Rubber
If your...
Owners Manual - Page 164
... riding through rain or on the chain longer and provide better lubrication. A heavy oil such as SAE90 is preferred to a lighter oil because it will stay on wet track, or any excess oil.
• •
Owners Manual - Page 170
... Fuel pump malfunction, wiring open or short Ignition coil malfunction, wiring open or short
j
NOTE
żThe ECU may be involved in these problems. If all the parts and circuits checked out good, be sure to check
the ECU for ground and power supply. If the ground and power supply are checked good, replace the ECU (see...
Owners Manual - Page 189
...or sparks; Avoid getting oil on rubber parts and on all the cables. Run the engine for about five minutes to warm the oil, then stop the engine and never smoke while handling fuel. WARNING
...properly.
Always stop it . the fuel system by running the engine at • Empty idle speed until the engine stalls (If left in fresh engine oil. • Install the fuel from any source of ...
Similar Questions
Bike Will Not Start.
would like help in finding and cleaning injectors. would also like to adjust valves myself.
would like help in finding and cleaning injectors. would also like to adjust valves myself.
(Posted by rjmarche277 1 year ago)
2009 Kawasaki Kfx90
Will start when cold but dies when throttle is let go, also does this when warm.The cold start featu...
Will start when cold but dies when throttle is let go, also does this when warm.The cold start featu...
(Posted by cokerblaine5 7 years ago)
Engine Warning Light Stays On.
My Vulcan S has ODO 1300 km. Engine warning light goes ON, non stop. Pls help, local dealer are not ...
My Vulcan S has ODO 1300 km. Engine warning light goes ON, non stop. Pls help, local dealer are not ...
(Posted by lethacvs 7 years ago)
Cvt & Powerstering Lights Comes On, Motor Misses Spedo Shows 0 While Moving
this happens after a run or a mile or so - never on shorter trips. Sometimes Power Steering goes out...
this happens after a run or a mile or so - never on shorter trips. Sometimes Power Steering goes out...
(Posted by prharrill 7 years ago)
I Have A 2005 Mean Streak And It Wont Run Smoothly With Vance And Hines.help
my 2005 mean streak came with vance& hines and runs poorly. Even with the addition of power comm...
my 2005 mean streak came with vance& hines and runs poorly. Even with the addition of power comm...
(Posted by terrilldavis28 7 years ago)