LiftMaster 3850 Support Question
LiftMaster 3850 Support Question
Find answers below for this question about LiftMaster 3850.Need a LiftMaster 3850 manual? We have 1 online manual for this item!
Question posted by cawendel on September 30th, 2013
Which Battery Do I Change In My Liftmaster Remote Model 3850
The person who posted this question about this LiftMaster product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related LiftMaster 3850 Manual Pages
3850 Elite Series Manual - Page 1
®
GARAGE DOOR OPENER Models 3850
3850-267
For Residential Use Only
Com Details
The Chamberlain Group, Inc. 845 Larch Avenue Elmhurst, Illinois 60126-1196 www.liftmaster.com
patible with
See Page 29 for
Owner's Manual
■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after installation. ■ The door WILL...
3850 Elite Series Manual - Page 2
... 25
Operation
26-33
Operation safety instructions 26
Using garage door opener 26
Using the wall-mounted door control 27
Using the remote control 28
Troubleshooting 28
The remote control battery 28
EverCharge® Standby Power System (optional 29
To open the door manually 30
Care of your garage door and/or the garage door opener if you do not comply with the instructions...
3850 Elite Series Manual - Page 3
... see if there is any ropes connected to garage door.
• Complete the following test to make sure your door binds, sticks, or is out of balance.
To prevent damage to garage door and opener:
• ALWAYS disable locks BEFORE installing and operating the opener.
• ONLY operate garage door opener at 120V, 60 Hz to avoid entanglement.
If balanced...
3850 Elite Series Manual - Page 5
...®ng Door Control Console
SECURITY✚® 3-Button Remote Control
Models 3850 (1) 3850-267 (2)
SECURITY✚® Keyless Entry Model 3850-267 (1) ONLY
Motor Unit with Light Lenses
2-Conductor Bell Wire White & White/Red
Belt Pulley Bracket
Trolley
Optional EBvearttCehryarge® Stan(PdbacykPeodwSeerpSaryastteelym) (battery)
Belt
RReemmootteeCCoonnttrrooll...
3850 Elite Series Manual - Page 6
... spring releases and snaps the nut ring against the trolley (Figure 2).
• Place a 7/16" open end wrench on the square end.
Washered Bolt 5/16"-18x1/2"
Rail Hole
USE ONLY THIS TYPE AND ... STEP 1 Attach the Rail to the Motor Unit
To avoid installation difficulties, do not run the garage door opener until instructed to do so. • Remove the two washered bolts mounted on top of motor ...
3850 Elite Series Manual - Page 7
... instructed to fingers from electrocution, disconnect ALL electric and battery power BEFORE performing ANY service or maintenance.
7 You have now finished assembling your garage door opener. Install garage door opener 7 feet (2.1 m) or more above floor.
7. Door MUST reverse on properly balanced and lubricated garage door. Attach with #8x3/8" hex screws provided. Mount emergency release...
3850 Elite Series Manual - Page 11
...; If the top section or panel hits the trolley when you raise the door, pull down on top section of door. Header Bracket
Top of Motor Unit
Top of Door
2x4 is convenient for setting an ideal door-to garage door, rest garage door opener rail on 2x4 placed on the trolley release arm to the top of the...
3850 Elite Series Manual - Page 12
... be used if installing ANY brackets into masonry. Measure the distance from a falling garage door opener, fasten it SECURELY to structural supports of the motor unit to required lengths. 3. Drill 3/16" pilot holes in line
with rail grease. Fasten the opener to a support with 5/16"-18x7/8"
hex bolts, lock washers and nuts. 6. If the...
3850 Elite Series Manual - Page 13
...closing garage door.
DO NOT pierce wire with care to operate the same garage door opener, it may damage the LCD screen. The trolley will travel . • ALWAYS keep garage door in...door control push buttons or remote controls. • Activate door ONLY when it can be seen clearly, is recommended to cross path of closing garage door: • Install door control within sight of door,...
3850 Elite Series Manual - Page 14
... sure motor unit is connected. ALWAYS wear protective gloves and eye protection when changing the battery or working around the battery compartment. Then the lights will turn OFF.
• Reverse the procedure to close the lens.
• Use A19, standard neck garage door opener bulbs for approximately 4-1/2 minutes when power is unplugged. • Using a Phillips head...
3850 Elite Series Manual - Page 15
...run the opener at this time. To prevent possible SERIOUS INJURY or DEATH from a falling garage door: • If possible, use an extension cord, 2-wire adapter, or change plug in ... from electrocution or fire:
• Disconnect ALL electric and battery power BEFORE performing ANY service or maintenance.
• Garage door installation and wiring MUST be grounded.
• Reinstall the ...
3850 Elite Series Manual - Page 16
... properly connected and aligned, the sensor will stop and reverse to clip onto the track of sectional garage doors without additional hardware. This required safety device MUST NOT be connected and aligned correctly before the garage door opener will flash 10 times. If installing in the down direction.
Safety Reversing Sensor 6" (15 cm) max. The...
3850 Elite Series Manual - Page 24
... the door control or programmed remote control again.
Push the door control or programmed remote control. The LED will open and close the door.
1. If the door is not sticking or binding. Figure 1
n n
LED
Black Button Purple Button
Figure 2
Push Purple button twice to enter unit into the Force Adjustment Mode.
If the garage door opener cannot open (UP).
4. Door MUST reverse...
3850 Elite Series Manual - Page 25
... or adjustment of the garage door (including springs and hardware).
• Any repair to or buckling of the garage floor.
• Any repair to or adjustment of the door.
• Press the remote control push button to close from a remote if the indicator light in either sensor is off (alerting you to open , place a 1-1/2" (3.8 cm) board (or...
3850 Elite Series Manual - Page 26
...changes with the door control, the Outside Keylock, or Keyless Entry, if you release them until completely closed , it is misaligned, the door won't close from a hand-held remote...PATH OF THE MOVING DOOR.
5. ALWAYS KEEP GARAGE DOOR PROPERLY BALANCED (see page 3). SAVE THESE INSTRUCTIONS. Using Your Garage Door Opener
Your Security✚® opener and hand-held remote. If closed ....
3850 Elite Series Manual - Page 31
... approximately every 2 seconds, indicates the motor unit is activating the door and is operating off when door is open: • The garage door opener is equipped with beep, sounding every 30 seconds, indicates battery is low. • If a red LED remains on the following page. My remotes will still not activate your Smart Control Panel® does not...
3850 Elite Series Manual - Page 32
....
Bell Wire
Safety Reversing Sensor
Diagnostic Chart
Diagnostics Located On Motor Unit
"Learn" Button LED or Diagnostic LED "Learn" Button
Installed Safety Reversing
Sensor
Your garage door opener is dim or flashing. • Realign receiving eye sensor, clean lens and secure brackets. If the sensor indicator lights do not glow steady.
• Inspect...
3850 Elite Series Manual - Page 34
....
2. The learn indicator light will be heard.
*3-Button Remotes (315 MHz)
If provided with your garage door opener, the large button is operated with a non-rolling code remote control, the technical measure in the garage door opener does not authorize the purchaser or supplier of the garage door opener, which provides security against code-theft devices, will be circumvented. It has...
3850 Elite Series Manual - Page 35
... a ladder.
1. The door should move . To set a temporary PIN
You may be changed by pressing the four buttons for your choice on the keypad. The opener light will be heard....10045; button. Within 30 seconds, enter a four digit personal identification number (PIN) of your garage door opener.
Enter a four digit personal identification number (PIN) of your personal entry PIN (not the last...
3850 Elite Series Manual - Page 38
... enables homeowners to the garage door opener.
Tells you if your garage door is designed to turn on a specially designed keyboard. Wireless Door Control: Push bar, light feature and auxiliary button. For use with model 3850 only.
Also can be limited to operate garage door opener from lightning and power surges.
38 SECURITY✚® 3-Button Mini Remote Control : With key...
Similar Questions
Will A 485 Lm Battery For A Model 3850 Work On A Model 3840?
I need a new battery for my garage opener, model 3840. All of the batteries I have seen are 485LM fo...
I need a new battery for my garage opener, model 3840. All of the batteries I have seen are 485LM fo...
(Posted by kdmeacham 9 years ago)
How To Change The Backup Battery In A Lift Master Garage Door Opener
(Posted by dwagrose 10 years ago)
How To Change Battery On Liftmaster Elite Series Garage Door Opener
(Posted by Parissil 10 years ago)
Where To Buy Batteries For A Model 3850 Elite Series Garage Door Opener
(Posted by NADGmark85 10 years ago)
How To Change The Back Up Battery In The Lift Master Garage Door Opener
(Posted by hukimmer 10 years ago)