Makita BHX2500 Support Question
Makita BHX2500 Support Question
Find answers below for this question about Makita BHX2500.Need a Makita BHX2500 manual? We have 3 online manuals for this item!
Question posted by Anonymous-165067 on October 20th, 2018
Starter Cord Problems
On my BHX2500 the starter cord is stuck at the start position and will not release. When I pull the cord it will not budge. I have used considerable force though not enough to break the rope.The blower is 2 years old and is once a fortnight during summer months. It is not overused and looks now. So general wear and tear is no the problem, I think.Any clues would be appreciated.
Current Answers
Answer #1: Posted by Odin on October 21st, 2018 5:56 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,630
Member since:
April 10th, 2010 Points: 41,236,630
The fuel filter may be clogged. See the solution at https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Leaf-Blower/457-415-2134637-/new/Makita-Leaf-blower-won-t-start-BHX2500. If the issue persists (or if you require further explanation), you'll have to consult Makita: use the contact information here--https://www.contacthelp.com/makita/customer-service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Makita BHX2500 Manual Pages
Accessory Catalog - Page 6
blower accessories
195282-8 Description: Vacuum Kit, BHX2500CA
Features: • Large capacity dust bag. • Efficient collection of leaves and debris. • Easy installation. Includes: Dust bag ...
Accessory Catalog - Page 7
...made from 25% post consumer materials. • 4.6 oz bottle makes 2.5 gal 50:1 fuel. For Use With All Makita 2 Cycle Models
T-00739 Description: Synthetic 2 Cycle Fuel Mix, 4.6 oz
• ...Excellent for low emission 2-stroke engines. • Packaging made from 25% post consumer materials.
For Use With All Makita 4-Stroke Models
T-00745 Description: Synthetic 2 Cycle Fuel Mix, 2.6 oz
• ...
Accessory Catalog - Page 8
chain saw & safety
181119-A Description: Bar Chain Oil 1 Qt.
• Packaging made from 25% post consumer materials.
For Use With All Makita Chain Saws 181116-A Description: Bar Chain Oil 1 Gallon • Packaging made from 25% post consumer materials. For Use With All Makita Chain Saws
841008-A Description: 38" Chain Saw Chaps LG
For...
Owners Manual - Page 1
English
BLOWER
BHX2500
INSTRUCTION MANUAL
Important: Read this instruction manual carefully before putting the Blower into operation and strictly observe the safety regulations! Preserve instruction manual carefully!
Owners Manual - Page 2
...booklet which is the result of a long development programme and many years of knowledge and experience. This will assist you to the various ...Start Emergency Stop
No Smoking
First Aid
No Open Flame
Recycling
Protective Gloves must be able to offer you the MAKITA blower which refers in detail to safety obtain the best possible results from your MAKITA Blower. The blower models BHX2500...
Owners Manual - Page 4
... products. Do not use any engine problems.
• When working with your clothing immediately if fuel has been spilled on it (fire hazard).
• Inspect the fuel cap at all the appropriate accessories are in order to prevent soil
contamination (environmental protection). Do not inhale fuel vapor. Start the Blower only in such a manner...
Owners Manual - Page 6
...Engine oil volume
(L)
Carburetor (Diaphragm-carburetor)
Ignition system
Spark plug
Electrode gap
(mm)
Notes: 1.
BHX2500 4.5 (9.9 lbs)
350 231 368 (13.8 9.1 14.5 in) 7,800 3,500 24.5 (1.49...SPECIFICATION
Model Mass (without blower pipe) Dimension (without prior notice. This specification is subject to change without blower pipe L x W x H) Max. Use the oil and spark plug specified by MAKITA...
Owners Manual - Page 7
... 16. Spark Plug 17. Starter Handle
DESIGNATION OF PARTS 8. Cruise Control Lever 13. Blower Nozzle A 20. Vacuum Pipe A 23. DESIGNATION OF PARTS
Optional
Vacuum set
DESIGNATION OF PARTS 1. Protector
DESIGNATION OF PARTS 15. Elbow
DESIGNATION OF PARTS 22. Primer Pump 5. Arrow Mark 26. Stop switch 2. Choke Lever 7. Blower Tube 19. Fuel Tank 9. Muffler...
Owners Manual - Page 11
... stable position.
(6) Pull out slowly the starter handle till a certain resistance is pulled, never release your hand
immediately. Return the starter handle ...supplied. Hold the start , stop the engine immediately and carry out inspection. - OPERATION
1. When starting the engine, keep...handle with force.
• Never pull the rope to 3 minutes.
(9) Rotation of the engine speed ...
Owners Manual - Page 12
.../min). • If it
out with force. (6) When the engine is difficult to start, open . (4) Hold the main handle with...position in the "CLOSE" position, the engine may be difficult
to start the engine again. • If the operator keeps pulling the starter...position. (5) Pull out slowly the starter handle till a certain resistance is felt. Stopping
1) When the cruise control lever is OFF Release...
Owners Manual - Page 16
...and described in the fuel tank, remove it completely. (2) Pull out the fuel filter from there, and drain fuel coming...
6. Replacement of operation for any , wipe clean such materials.
(2) Pull out the fuel filter with possibility of engine speed increase.
• ... materials. Just after the engine is drained from the refill port using a wire. (3) Push the primer pump until it at a ...
Owners Manual - Page 17
... ignition spark Fuel tank filled No compression when pulled over Starter not engaging Tank filled ignition spark existing Tank ...defective, ignition module faulty Incorrect choke position, carburetor defective, fuel supply line bent or blocked, fuel dirty. Fault location
Fault Engine not starting or with difficulty
Warm start problems Engine starts but dies Insufficient performance
System Ignition ...
Owners Manual - Page 18
...start as they originally are. If any part contrary to high speed, and pull starter handle until engine starts. Clean
Straighten fuel tube
Deteriorated fuel makes starting more difficult.
If engine will not start...the description of fuel
Remedy
Push 7 to operate primer pump Low pulling speed of starter rope Lack of fuel Clogged fuel filter Broken fuel tube Deteriorated fuel
Excessive...
Owners Manual - Page 20
... the State's stringent anti-smog standards Makita U.S.A., Inc. You are responsible for two (2) years. may be designed, built and equipped to abuse, neglect, improper maintenance or unapproved modifications.... retain all scheduled maintenance.
-
Your emission control system includes parts such as a problem exists. will be repaired or replaced by Makita U.S.A., Inc. Clovis Ave., Ste....
Owners Manual - Page 25
...adjustment (unless they were
made by the dealer or service center authorized by MAKITA when a problem exists.
You are responsible for your sales receipts indicating date of purchase for required maintenance ...services. * Consequential damages such as loss of time, inconvenience, loss of use of the engine of equipment, etc. * Diagnosis and inspection charges that do not ...
Parts Breakdown - Page 6
socket head bolt
Pag1eo6f 1o6f 15
PB_12-201016_/1r0e/v20910 PARTS BREAKDOWN PARTreSv 9B_1R2E/2A9/K20D11OWN
Prior to August 2008
BHX2500
BHX2500CA EM4251
Type 2
Implemented August 2008
96 157 156 97
101 99
43
To receive 156, the air intake
Change from Pan head screw to Hex.
Parts Breakdown - Page 12
...5X16, N1900B 10
18
660-15034-00 OUTER SNAP RING
1
19
660-15027-04 PROTECTOR, BHX2500
1
20
660-15035-00 RUBBER WASHER
1
21
004-36042-53 SCREW ASS'Y M4X25 (W,SW)...CAUTION LABEL
1
2
665-95043-00 MODEL LABEL , BHX2500CA
1
3
660-95132-00 CAUTION LABEL
1
4
665-55000-00 GRIP BHX2500
1
5
665-50010-00 SWITCH CPL.
1
6
665-15005-00 FRICTION RUBBER
1
7
665-10140-00 VOLUTE CASE
1
8...
Parts Breakdown - Page 13
...592-35006-00 CAM LIFTER SHAFT
1
84
592-35000-01 CAM LIFTER
2
85
592-50010-02 STARTER COVER ASS'Y
1
86
168483-1
PULLEY, EM2650LH
1
87
266585-8
TAPPING SCREW 5X12, EM2650LH
1...
1
Page1 o1f316of 15
PB_12-20110_6/r1e0v/20910
No. PARTS BREAKDOWN PARrTevS9B_1R2E/2A9/K20D1O1 WN
BHX2500 BHX2500CA
EM4251
Products with multiple versions are attached.
BOLT M5X14
8
49
592-15007-00 ...
Parts Breakdown - Page 14
...
Q'ty Unit
Notes
90
451937-8
REEL, EM2650LH
1
91
232258-5
SPIRAL SPRING, EM2650LH
1
92
424319-7
STARTER KNOB, EM2650LH
1
93
592-50010-50 STARTER ROPE
1
94
819328-3
MAKITA LOGO LABEL, BHX2500
1
95
911128-8
P.H. PARTS BREAKDOWN PARrTevS9B_1R2E/2A9/K20D1O1 WN
BHX2500 BHX2500CA
EM4251
Products with multiple versions are attached.
SCREW M4X16
2
Y05396 96
592-35047-00...
Parts Breakdown - Page 15
...592-75001-00 PLUG CAP
1
148
065-40099-31 PLUG CAP SPRING
1
149
592-70120-11 IGNITION COIL, BHX2500
1
150
011-90499-70 SOCKET HEAD BOLT, BBX7600
2
150
004-37042-00 SCREW ASS'Y M4X20
2
151
...013-00699-40 BOLT ASS'Y M6X16
1
152
592-75002-00 FLYWHEEL BHX2500
1
153
665-95040-00 EXTENSION PIPE, BHX2500
1
154
665-95010-00 ROUND END NOZZLE
1
155
690-90590-00 TOOL KIT...
Similar Questions
Blower Won't Rev To Full Throttle !
hello ". I bought this blower about a year ago ,Mir starts perfectly and worked really well , I left...
hello ". I bought this blower about a year ago ,Mir starts perfectly and worked really well , I left...
(Posted by mrsnappy 1 year ago)
Makita Bhx2500 Leaf Blower
I have recently dismantled carburetor and cleaned for a no start issue and reassembled unit to blowe...
I have recently dismantled carburetor and cleaned for a no start issue and reassembled unit to blowe...
(Posted by jczernicki1 3 years ago)
Screws Came Out Of Starter Pull Cord Panel Replaced But Wont Start
(Posted by mariann43 9 years ago)
Serial Number
Where on the product do I find the eight digit serial number for my BHX2500
Where on the product do I find the eight digit serial number for my BHX2500
(Posted by rocket48 10 years ago)
