Makita MAC2400 Support Question
Makita MAC2400 Support Question
Find answers below for this question about Makita MAC2400.Need a Makita MAC2400 manual? We have 2 online manuals for this item!
Question posted by jimransom on January 29th, 2022
Tank To Regulator Hose With Flare Fittings?
The hose on my Mac2400 leaks. It goes from the tank to the regulator. What is this part called?
Current Answers
Answer #1: Posted by SonuKumar on January 30th, 2022 7:08 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,648,150
Member since:
May 9th, 2021 Points: 16,648,150
http://www.ereplacementparts.com/images/makita/MAC2400.pdf
https://www.repairtoolparts.com/makita-parts/makita-mac2400-parts-list
https://www.jackssmallengines.com/jacks-parts-lookup/manufacturer/makita/air-compressors/mac2400
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Makita MAC2400 Manual Pages
Owners Manual - Page 1
...protected by fuses, use time delay fuses. OWNERS MANUAL FOR
Oil Lubricated Air Compressor
MODEL No MAC2400
SPECIFICATION CHART
Model # Horsepower SCFM @ 40 PSIG SCFM @ 90 PSIG Cut-In Pressure Cut...-Out Pressure Bore Stroke Voltage -Single Phase Motor RPM Amperage @ max pressure Tank Size CSA/US Listed
MAC2400 2.5 4.8 4.2
100 PSI 130 PSI 51 mm 44 mm
120 1720 12.3 4.2 Gallon Yes...
Owners Manual - Page 4
...; Unauthorized modifications to the pressure switch, safety valve, or any other components, which control tank pressure.
• Follow the equipment manufacturers recommendation and never exceed the maximum allowable pressure rating of air tools, spray guns, air operated accessories, tires AND other inflatables can cause them to explode or fly apart, and could...
Owners Manual - Page 5
..., correct voltage, and adequate fuse protection.
• Never operate the compressor outdoors when it may contain carbon monoxide or other vapors, or particles from the tank or other electrically powered device, if it is not used properly, it is raining, or in a wet environment. Page 5 Doing so can result in serious...
Owners Manual - Page 6
... and
pressure switch is operating or maintenance or repair.
Page 6 These moving compressor with your specific application. Risk from the tank and any
attempt repair or
attachments before attempting maintenance, attaching tools or accessories.
plugged in a serious skin burn.
• Never touch hot components during or immediately after operation of Burn
Contact...
Owners Manual - Page 7
...tool. This means an air compressor that pumps air more than a 50% duty cycle. Your air compressor can enjoy all the benefits of having an oil lubricated professional air compressor.
With improper handling, damage may result in the air tank... PRESSURE: While the motor is called "cut -in pressure".
Immediately upon...your air tank from pressure higher than 50% of air regulation and/or...
Owners Manual - Page 8
... valve remains closed.
Store the air compressor in the cylinder. Protect the electrical cord and air hose from obstructions. Review the "Maintenance" and
"Operating Procedures" sections and perform maintenance as being stepped...the motor. Useable air is not available until the compressor has raised the air tank pressure above that required at the end of the piston, air is drawn in through the...
Owners Manual - Page 9
... (slightly higher than desired pressure.
A small
Page 9 See "Operating Procedures". Follow the instructions packaged with the flow of each particular
accessory, the outlet regulated air pressure may have to the tank pressure. Compressor oil is high, an air filter can be kept clear of obstructions, which could reduce air delivery of the...
Owners Manual - Page 10
... The air compressor is over 100 feet long, use extra air hose instead of an extension cord. Page 10
Please see the chart below...that is in good condition. Grounding Instruction WARNING: Risk of leaks. They leave carbon deposits on the air compressor. · Make sure ...extension cord is the same size, or larger than, the air tank outlet. Extension Cords To avoid voltage drop, power loss, and ...
Owners Manual - Page 11
... set to "OFF" and the air regulator or shut-off valve is plugged, release all local codes and ordinances. Attach hose and accessories. Check the manufacturer's maximum pressure rating for use.
5. Turn the pressure switch lever to "ON/AUTO" and allow tank pressure to zero. 8. Remove the air tool or accessory. 9. Note: If drain...
Owners Manual - Page 12
...water from the air tank, any unusual noise and/or vibration.
3. Manually check all maintenance checks. Inspect air filter, replace if necessary.
5. Inspect air lines and fittings for any moisture separators... intake and exhaust valves. • Check condition of the sight glass. Check for leaks; correct as necessary. MAINTENANCE
WARNING: UNIT CYCLES AUTOMATICALLY WHEN POWER IS ON. WHEN DOING...
Owners Manual - Page 13
... Apply sealant to operate at all air pressure from
air tank and unplug outfit. 2. Replace the pressure release tube and fitting. 9. Replace the shroud. If the overload protector shuts ...will not allow the compressor to the check valve threads. Remove the pressure release
tube and fitting. 5. Motor The motor has a manual reset thermal overload protector switch.
Before you use ...
Owners Manual - Page 14
... the unit doesn't shut off . A defective check valve results in air tank or at pressure switch unloader valve.
Contact a trained service technician. Do not repair the leak. Defective pressure switch. Air leaks at Fittings are good, check to the "OFF" position. Air leaks at the pressure release valve where there is a pressure in the pressure...
Owners Manual - Page 15
...
air
requirement.
• Restricted air intake filter.
• Unit is used , adjust the regulator following the instructions. Air leak
Possible
from safety defective
valve. safety valve.
Motor will not run.
• Motor overload protection switch has tripped.
• Tank pressure exceeds pressure switch "cutin" pressure.
• Let motor cool off and reset overload...
Owners Manual - Page 16
...; Have checked at an Authorized Warranty Service Center.
1.Check fuse box for inspection or replacement if necessary.
• Have checked at air outlet. Regulator knob has continuous air leak.
if the valve does not open .
• Loose electrical connections.
• Possible defective capacitor.
• Paint spray on internal motor parts.
• Possible...
Owners Manual - Page 17
... West Allis, WI 53227 (414) 541-4776
Customer Record
When you need service: Send complete tool (prepaid) to an Authorized Makita Service Center.
Be sure to attach a letter to the outside...of the Makita Factory Service Centers listed, or to one of the carton detailing the problem with your tool. Louis, MO 63126 (314) 909-9889
NEBRASKA
4129 S. 84th Street Omaha, NE 68127 (402)...
Owners Manual - Page 18
...option, replace), without charge.
Some states do this one year period, return the COMPLETE tool, freight prepaid, to one of work with approved safety equipment, such as those dust .... MAKITA DISCLAIMS LIABILITY FOR ANY IMPLIED WARRANTIES, INCLUDING IMPLIED WARRANTIES OF "MERCHANTABILITY" AND "FITNESS FOR A SPECIFIC PURPOSE," AFTER THE ONE YEAR TERM OF THIS WARRANTY.
THIS DISCLAIMER APPLIES ...
Owners Manual - Page 19
...
Other (
)
4. Any comments:
3. How did you learn about this portion by facsimile or mail. This product was purchased from:
Home Center
Other (
Hardware/Lumber Store
Tool Distributor
Industrial Supply
Construction Supply
2.Use of the product is intended for:
Construction Trade
Industrial Maintenance
Home Maintenance
Hobby
Other (
)
5. MAIL THIS PORTION
Your answers...
Parts Breakdown - Page 1
...302001-E 1
38 Exhaust valve seat 39 Oil gauge gasket 40 Air tank 41 Pressure gauge 42 Regulator 43 Rubber handle 44 Tank foot assembly 45 Quick coupler (1/4") 46 Safety valve (1/4") 47 Drain...;
37 Electric motor / Crankcase
251332-E 1
Makita Air Compressor - Makita Air Compressor Part Breakdown - Model MAC2400
Compressor oil (1 quart)
181122-A 1
PB-MKTA-072605
www.makita.com
Similar Questions
Air Receivers Drain Plug
Where is the "AIR RECEIVERS DRAIN PLUG?" Initial start up instructions state to open and run for twe...
Where is the "AIR RECEIVERS DRAIN PLUG?" Initial start up instructions state to open and run for twe...
(Posted by dclombard 8 years ago)
Makita Air Compressor Mac5200
I've got a Makita mac 5200 air compressor that is suddenly leaking air out the pressure regulator kn...
I've got a Makita mac 5200 air compressor that is suddenly leaking air out the pressure regulator kn...
(Posted by dklilja 8 years ago)
Hi, Do Bits (concrete Drill Etc Of The Hr 3851 Fit Into The Hr4041c?reinhold
(Posted by reinholdstromeyer 9 years ago)
Tool Not Working
I bought a new makita LXPH01 Hammer Drill. I put a fully charged lit-ion battery 3.0a but when I pr...
I bought a new makita LXPH01 Hammer Drill. I put a fully charged lit-ion battery 3.0a but when I pr...
(Posted by shiki98 11 years ago)