2010 Mazda CX-9 Support Question
2010 Mazda CX-9 Support Question
Find answers below for this question about 2010 Mazda CX-9.Need a 2010 Mazda CX-9 manual? We have 1 online manual for this item!
Question posted by s88poys on September 16th, 2013
What Do I Do After I Put The Manual Key In The Ignition Of Mazda 2010
The person who posted this question about this Mazda automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 20
...ignition...key is inserted in the ON position). The selector lever is shifted to a position other than P (With the ignition switch in the key... cylinder. Press the set button is pressed. Vehicle locking/unlocking is done using a programmed advanced key/retractable type key...programmed advanced key/ retractable type key, and... advanced key/retractable type key within...
Owner's Manual - Page 90
... it is turned off and the ignition switch is turned to a door and window, however, always start if the advanced key is placed in the vehicle, the... vehicle will flash once.
3-8
Form No.8AU2-EA-09G The engine may not start the engine from the driver's seat. CX-9_8AU2-EA-09G_Edition1 Page90 Wednesday, July 8 2009 12:5 AM
Black plate (90,1)
Knowing Your Mazda...
Owner's Manual - Page 92
...flash for confirmation. The auxiliary key is pushed. This could occur. CX-9_8AU2-EA-09G_Edition1 Page92 Wednesday, July 8 2009 12:5 AM
Black plate (92,1)
Knowing Your Mazda
Advanced Keyless Entry and Start...against theft. WARNING
Before leaving the driver's seat, always put the key or start knob is inserted into the ignition switch.
NOTE
l
Start knob
LOCK (Released) The steering wheel ...
Owner's Manual - Page 93
...warning lights (except brakes) should fasten their seat belts. 3. The advanced key must be inspected before trying to the ignition switch. If the knob becomes detached from the vehicle. then it ....EA-09G_Edition1 Page93 Wednesday, July 8 2009 12:5 AM
Black plate (93,1)
Knowing Your Mazda
Advanced Keyless Entry and Start System
ACC (Accessory) The steering wheel unlocks and some electrical ...
Owner's Manual - Page 94
...-9_8AU2-EA-09G_Edition1 Page94 Wednesday, July 8 2009 12:5 AM
Black plate (94,1)
Knowing Your Mazda
Advanced Keyless Entry and Start System
NOTE
The starter will not start. l The advanced key is out of operational range.
Turn the ignition switch from another manufacturer similar to detect the signal (page 3-7). NOTE
In the following cases...
Owner's Manual - Page 95
... the advanced key is low. Turn the ignition switch from the ACC position to the LOCK position.
3-13
Form No.8AU2-EA-09G Without being pushed in, the ignition switch stops at...discharged if the ignition switch is left with a new one. Push in the ACC position. CX-9_8AU2-EA-09G_Edition1 Page95 Wednesday, July 8 2009 12:5 AM
Black plate (95,1)
Knowing Your Mazda
Advanced Keyless ...
Owner's Manual - Page 96
Press the buttons slowly and carefully. If the ignition switch is not in the LOCK position or the start knob installed in ...-EA-09G_Edition1 Page96 Wednesday, July 8 2009 12:5 AM
Black plate (96,1)
Knowing Your Mazda
Advanced Keyless Entry and Start System Operation Using Advanced Key Functions
qKeyless Entry System
This system uses the more traditional keyless entry buttons to open the power...
Owner's Manual - Page 97
...warning lights will activate the vehicle's alarm.
l The auxiliary key is inserted into or damage your vehicle, pressing the panic ...liftgate will work whether any of the double click. If your Mazda has a power liftgate (page 3-35), the transmitter can open...system, the hazard warning lights will flash once to break into the ignition switch. l The start knob is armed. NOTE
l
l
All ...
Owner's Manual - Page 100
... 3-30). l Insert the auxiliary key and turn the ignition switch to Ignition Switch (page 5-2). Starting the engine The engine can be locked/unlocked using the start knob until the KEY indicator light (green) illuminates. CX-9_8AU2-EA-09G_Edition1 Page100 Wednesday, July 8 2009 12:5 AM
Black plate (100,1)
Knowing Your Mazda
Advanced Keyless Entry and Start...
Owner's Manual - Page 101
...of the warning beep sound indicating that the advanced key has been removed. Refer to Ignition Switch (page 5-2). l The start knob is open , and the advanced key is removed from the vehicle. (A beep sound...is carried together with the advanced keyless function.
Have the vehicle inspected at an Authorized Mazda Dealer as soon as possible.
qStart Knob Not in LOCK Warning Beep
If the start...
Owner's Manual - Page 102
... the liftgate cannot be set so that the KEY indicator light (green) does not flash even if the battery power is inserted into the ignition switch. l The start knob is returned to... Advanced Key Maintenance (page 3-5). l A door or the liftgate is open (door ajar included). CX-9_8AU2-EA-09G_Edition1 Page102 Wednesday, July 8 2009 12:5 AM
Black plate (102,1)
Knowing Your Mazda
Advanced Keyless...
Owner's Manual - Page 107
...locked by pressing the lock button while any other door or the liftgate is in the ignition switch. Operation indicator light Panic button
NOTE
The unlock button can be used to close the...center of the vehicle, but the lock button cannot be obtained at an Authorized Mazda Dealer. The system does not operate when the key is open the power windows and the moonroof, but this may be dead....
Owner's Manual - Page 108
... button on page 3-61. All doors and the liftgate cannot be locked when the key is properly armed. Turning off the alarm Press any door or the liftgate is open...9_8AU2-EA-09G_Edition1 Page108 Wednesday, July 8 2009 12:5 AM
Black plate (108,1)
Knowing Your Mazda
Doors and Locks
NOTE
l
NOTE
(Without theft-deterrent system) The hazard warning lights will flash ... is in the ignition switch.
Owner's Manual - Page 113
... AM
Black plate (113,1)
Knowing Your Mazda
Doors and Locks
qLocking, Unlocking with DoorLock Knob
To lock any door from the outside if the key is in the ignition switch, all doors and the liftgate will...or the liftgate open .
This does not operate the other door locks. With the key in the ignition switch. This does not operate the other door locks. Unlock
To lock any door ...
Owner's Manual - Page 116
....
3-34
Form No.8AU2-EA-09G Cap
qOpening and Closing the Liftgate
Manually opening the liftgate
WARNING
Always fully open the liftgate when opening it : 1. CX-9_8AU2-EA-09G_Edition1 Page116 Wednesday, July 8 2009 12:5 AM
Black plate (116,1)
Knowing Your Mazda
Doors and Locks
qLocking, Unlocking with Transmitter (with a flathead screwdriver. NOTE...
Owner's Manual - Page 122
... Page122 Wednesday, July 8 2009 12:5 AM
Black plate (122,1)
Knowing Your Mazda
Doors and Locks Power Windows
The ignition switch must be in the ON position for the front power windows using the power... window master control switches on the driver's door or front passenger's door switch.
Manual opening/...
Owner's Manual - Page 123
..., or for other reasons such as a switch continues to the ON position. 2. Turn the ignition switch to be operated after the window fully closes. 5. Repeat Steps 3-4 for each front power...EA-09G_Edition1 Page123 Wednesday, July 8 2009 12:5 AM
Black plate (123,1)
Knowing Your Mazda
Doors and Locks
Manual opening/closing To fully open and stop the power window partway, pull or press the ...
Owner's Manual - Page 124
... procedure within 40 seconds, turn the ignition switch to restore the function despite carrying out the cancellation procedure, consult an Authorized Mazda Dealer. CX-9_8AU2-EA-09G_Edition1 Page124 ...Mazda
Doors and Locks
NOTE
Pressing the power window switch once when the window is fully closed will only open halfway. If a person's hands, head or an object blocks the window during the manual...
Owner's Manual - Page 182
... change to manual shift mode, shift the lever from P: 1. To shift from D to the LOCK position when the shift lever is not in P. (With Advanced Key) The ignition switch cannot ...-9_8AU2-EA-09G_Edition1 Page182 Wednesday, July 8 2009 12:6 AM
Black plate (182,1)
Driving Your Mazda
Starting and Driving
qActive Adaptive Shift (AAS)
Active Adaptive Shift (AAS) automatically controls the transaxle...
Owner's Manual - Page 382
...Pairing options" 6. Select "Mazda" from the LOCK to ...] "Pair" 8. Prompt: "Please say the name of the device after turning the ignition switch from the device list searched by activating Bluetooth Hands-Free first after the beep." ..." or "1234"). Record the code as it will be completed, refer to the owner's manual of your device in Step 9 to the ACC position, the system reads out a voice ...
Similar Questions
How To Change The Battery Of A Mazda Car Key Cx9 2010
(Posted by 77edljohn 10 years ago)
2010 Mazda Cx 9 No Instrument Cluster Or Start Signal When Ignition Key Is
turned battery new
turned battery new
(Posted by kizgorcs 10 years ago)
How To Change The Battery In A Mazda Cx-7 Key Fob 2010
(Posted by zcaldejam 10 years ago)
How To Change Battery In Mazda 2010 Cx9 Remote Key Fob
(Posted by richdickb 10 years ago)