1999 Nissan Altima Support Question
Find answers below for this question about 1999 Nissan Altima.Need a 1999 Nissan Altima manual? We have 1 online manual for this item!
Question posted by mpotts on March 12th, 2013
How Do I Change The Check Engine Light Bulb In My 1999 Altima?
Current Answers
Answer #1: Posted by bobbyzarlinga on March 12th, 2013 4:41 PM
-
- 1
Turn off the Altima's engine. Open the hood.
- 2
Disconnect the negative cable from the battery.
-
- 3
Remove the four holding screws from the dash bezel with a Phillips screwdriver. There are two on the upper bezel and two on the lower bezel. Remove the bezel from the vehicle.
- 4
Remove the two retaining screws from the gauge cluster with a Phillips screwdriver. Disconnect the electric cable from the rear of the gauge cluster. Pull the gauge cluster out of the Altima.
- 5
Remove the front cover from the gauge cluster by disengaging the two snap clips on each side of the cluster.
- 6
Heat the "check engine" bulb with the soldering iron to remove it. Solder the new bulb onto the underside of the gauge cluster to install it. Be sure not to burn the circuit board.
- 7
Reassemble the gauge cluster and place it back into the vehicle. Reconnect the electrical cable and reinstall the two screws.
- 8
Reinstall the dash bezel and its four screws. Reconnect the battery and close the hood.
- 1