2003 Nissan Maxima Support Question
2003 Nissan Maxima Support Question
Find answers below for this question about 2003 Nissan Maxima.Need a 2003 Nissan Maxima manual? We have 1 online manual for this item!
Question posted by Anonymous-145876 on November 5th, 2014
Headlight Lens Cover
what are the steps to changing lens cover
Current Answers
Answer #1: Posted by sabrie on November 5th, 2014 9:07 PM
sabrie
Member since:
May 23rd, 2013 Points: 3,306,778
Member since:
May 23rd, 2013 Points: 3,306,778
video instructions on the link below
www.techboss.co.za
Related Manual Pages
Owner's Manual - Page 1
... should be seated in the rear seat. ¼ Always provide information about the warranties covering your Owner's Manual carefully. READ FIRST - THEN DRIVE SAFELY
Before driving your vehicle please...in the Additionally, a separate Customer Care/Lemon Law Booklet (U.S. NISSAN reserves the right to change specifications or design at the time of the vehicle. ¼ Always review this manual ...
Owner's Manual - Page 17
... front seat. Do not allow anyone to place their hand out of the front seat.
They may be properly restrained. ¼ Do not use seat covers on the side of the seatback of the window or lean against the door. If the supplemental side air bag inflates, you are shown in...
Owner's Manual - Page 20
... the chest of the front occupants. This smoke is impacted. The supplemental side air bag (on the air bag system. * The SRS wiring harnesses are covered with yellow insulation either just before the harness connectors or over . The seat belts should be heard, followed by a qualified repair facility. Supplemental side air...
Owner's Manual - Page 21
... done by an authorized NISSAN dealer. It must be replaced together with the retractor as seat covers, around the side air bag system. ¼ Work around and on the side air bag..., several supplemental side air bag system components will turn off after activation.
Also, do not change the front seat assembly by placing material near the seatback of the supplemental side air bag system...
Owner's Manual - Page 40
...CHILD RESTRAINT
If your NISSAN dealer for adult seat belts or harnesses. Remove the anchor cover from side to side and tug it must be used for details. To install ... restraints and supplemental air bag systems
1-35 Secure the top tether strap to the cover.
Keep the removed cover in this section for installation instructions. 2. Anchor point locations
SSS0157
Anchor points are ...
Owner's Manual - Page 47
Headlight, fog light (if so equipped) and turn signal switch (P.2-18) 3. Windshield wiper/washer switch ...Tilting steering wheel lock lever (P.3-14) 21. Ignition switch/steering lock (P.5-4)
SIC1736
2-2
Instruments and controls Clock (P.2-32) 11. Fuse box cover (P.8-24) 15. Outside mirror remote control (P.3-15) 18. Traction control system (TCS) cancel switch (if so equipped) (P.2-24) 4. ...
Owner's Manual - Page 53
... moves to an area where the geomagnetism is stabilized.) it may cause the liquid cleaner to the vehicle by means of a magnet.
If the vehicle changes zone, repeat steps 1 thru 3. 10 seconds of the compass. ¼ When cleaning the mirror, use a paper towel or similar material dampened with glass cleaner.
Owner's Manual - Page 60
... The alarm can be deactivated. Restart the engine using the following alarm: ¼ The headlights blink and the horn sounds intermittently. ¼ The alarm automatically turns off .
If, ...switch in the vehicle, the system will stop if the ignition switch is now activated. Repeat step 1 and 2 again. 4.
The alarm will give the following procedures: 1. Vehicle security system...
Owner's Manual - Page 65
...
SIC1230
Be sure not to the or position. if it is covered, the photo sensor reacts as if it is dark and the headlights will illuminate.
¼ Never leave the light switch on the top...a click sound is turned to the OFF position.
2-20
Instruments and controls ¼ When the headlight switch remains in the or position after the ignition switch has been turned to the right until a...
Owner's Manual - Page 66
... position.
If the parking brake is applied before the engine is released. SIC1760
Lane change signal
To indicate a lane change, move the lever up or down to the position. To turn the fog lights on, turn the headlight switch to the position, then turn the switch to the point where lights begin flashing...
Owner's Manual - Page 68
The heater is controlled by built-in the switch will remain on as long as a blanket, cushion, seat cover, etc. When the vehicle's interior is on. 3.
The switches located on the center console can be operated independently of the switch. (Low) side (High)
¼ ...
Owner's Manual - Page 81
... interior, personal, and vanity mirror lights will go off. To turn on the vanity mirror is closed, the light will automatically turn on when the cover on the light again, insert the key into the ignition switch and move it to the OFF position. CAUTION
¼ Turn off 30 minutes after...
Owner's Manual - Page 83
...and released the program button on the garage door opener's motor to assist when performing this step. 7. NOTE: Once you have 30 seconds in which to complete the programming which may be... (after 20 seconds). If the indicator light on the HomeLink flashes, changing from under a light lens, you will need to remove the lens to a "rapidly flashing blink". If the wire originates from a "...
Owner's Manual - Page 85
...2 to 5 inches (50 to 127 mm) away from the HomeLink surface. 3.
Changes or modifications not expressly approved by pushing the HomeLink button that has been programmed into ... transmitter has been tested and complies with FCC rules part 15. Do not release the button until step 4 has been completed. 2. The HomeLink indicator light will not affect any other programmed HomeLink buttons....
Owner's Manual - Page 173
...stain or bleach the seat material. Some fabric protectors contain chemicals that may damage the lens cover. Salt could damage the electrical conductors, radio antenna elements or rear window defogger elements.
...life of the window, do not use glass or plastic cleaner on meter or gauge lens covers. Never use car wax. ¼ Never use fabric protectors unless recommended by the...
Owner's Manual - Page 197
..., see your NISSAN dealer. The pedal height should not change. 4. This could damage the electrical system or cause a fire. Remove the fusible link cover. 4. If the fuse is released from one minute without...one pedal application to the next step. 2. If the brakes do -it off , press and release the brake pedal several times. Be sure the ignition key and headlight switch are OFF. 2. FUSES ...
Owner's Manual - Page 204
SDI0969
Maintenance and do-it-yourself
8-29 When replacing a bulb, first remove the lens and/or cover. SDI1334
MDI0006
Replacement procedures
All other lights are either type A, B, C or D.
Owner's Manual - Page 212
... spare tire is smaller than 50 MPH (80 km/h). ¼ Do not use tire chains on roads covered with snow or ice, the T-type spare tire
should be damaged or involved in the "9. Such damage may... vehicle to maintain their appearance. ¼ Clean the inner side of the wheels when the wheel is changed or the underside of the vehicle is washed. ¼ Do not use abrasive cleaners when washing the ...
Owner's Manual - Page 221
... vehicle. SAE 10W-30, 10W-40 viscosity oil may require more frequent oil and filter changes. ¼ repeated short distance driving at cold outside temperatures, ¼ driving in this refrigerant...used if the ambient temperature is not covered by improper maintenance or use of any other than the specified quality, or oil and filter change interval. RECOMMENDED SAE VISCOSITY NUMBER
AIR...
Owner's Manual - Page 230
and cause personal injury. ¼ Overloading can change the way your vehicle's engine, drive train, steering, braking and other ...front and rear axle to carry passengers and cargo. Technical and consumer information
9-15 Failures caused by overloading are not covered by your NISSAN dealer. Doing so will place additional loads on your vehicle handles. TOWING A TRAILER
ceeded.
Do...
Similar Questions
2009 Maxima Nissan Selt Belt Not Clicking. Is It Covered Under Your 10 Yr.warran
Nothing is broken that i can see but it just does not lock.
Nothing is broken that i can see but it just does not lock.
(Posted by ernestinanarvaez 10 years ago)
