Home » Onkyo » Audio Receivers » Onkyo HT-R570

Onkyo HT-R570 Support Question

Find answers below for this question about Onkyo HT-R570.
Need a Onkyo HT-R570 manual? We have 1 online manual for this item!

Onkyo Overview Questions Manuals Reviews Videos Research

Question posted by lukex7 on March 18th, 2016

Keeps Blowing Internal Receiver Fuses?

Was playing music from AUX (IPOD) just fine then stopped mid song. Opened receiver to find 2 blown fuses. Replaced and blew again upon power up without any speakers attached. Please help?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TommyKervz on March 18th, 2016 11:48 PM

This answer was accepted by the poster of the original question.

TommyKervz

Member since:
January 10th, 2013

Points: 17,776,783

1,100
points

Go here https://answers.yahoo.com/question/index?qid=20070425164421AANq3yV for a possible solution.

Hope that is helpful.
Kervz at www.satechhelp.co.za

Related Onkyo HT-R570 Manual Pages

Owner Manual - Page 1

7.1ch Home Theater System HT-S5200 AV Receiver (HT-R570) Speaker Package (HTP-570) Front Speakers (SKF-570 L/R) Center Speaker (SKC-570) Surround Speakers (SKR-570 L/R) Surround Back Speakers (SKB-570 L/R) Subwoofer (SKW-570) Dock for iPod (UP-A1L) Instruction Manual Thank you to obtain optimum performance and listening enjoyment from your new 7.1ch Home Theater System. Contents Introduction 2 ...

Owner Manual - Page 3

...Fuse-The AC fuse inside this unit from country to select Standby mode does not fully shutdown the unit. The power cord plug is illegal without the permission of the following measures: • Reorient or relocate the receiving... reasonable protection against harmful interference in accordance with the limits for help. These limits are wet or damp. Precautions 1. For U.S. For...

Owner Manual - Page 4

...audio cables (Always turn it back on . 6. Microphone feedback. 4 Make sure you should only be an issue, in which neutralizes the magnetic field, thereby removing any of the following accessories: AV receiver HT-R570 HT-R570 Remote controller and two batteries (AA/R6) Speaker...flow in the speaker coils, causing burning or wire breakage: 1. Putting them , even if the input power is within ...

Owner Manual - Page 7

... W • 6-ohm impedance • Color-coded speaker terminals and speaker cable SKW-570 Bass Reflex Powered Subwoofer • 25 cm (10") cone woofer • Max. Patent #'s: 5,451,942; 5,956,674; 5,974,380; 5,978,762; 6,226,616; 6,487,535; 7,003,467; 7,212,872 & other U.S. Features AV Receiver HT-R570 Amplifier • 75 Watts/Channel @ 8 ohms (FTC) •...

Owner Manual - Page 9

...Speaker Precautions 4 Package Contents 4 AV receiver HT-R570 4 Speaker Package HTP-570 5 Dock for iPod UP-A1L 5 Using Two Sets of Speakers 6 Speaker Sets A and B 6 Features 7 AV Receiver HT-R570 7 Speaker Package HTP-570 7 Dock for iPod... a Camcorder, Game Console, or Other Device 33 Connecting a Portable Audio player 33 Connecting a CD Player or Turntable 34 Connecting a Cassette,...

Owner Manual - Page 11

.... Goes off . G Message area Displays various information. H Audio input indicators Indicate the type of the AV receiver to connect a camcorder, game console, and so on or ...and analog audio. T MUSIC OPTIMIZER button (47, 77) Turns the Music Optimizer on . Display B C D U Input selector buttons (44) Select the following input sources: DVD/BD, VCR/DVR, CBL/SAT, AUX, TV/TAPE...

Owner Manual - Page 12

...input. J FRONT L/R, CENTER, SURR L/R, and SURR BACK L/R SPEAKERS These terminal posts are for connecting a recorder with an optical digital audio output, such as a DVD/BD player, DVD/BD recorder,...video recorder). C DIGITAL IN OPTICAL 1 and 2 These optical digital audio inputs are for connecting the SiriusConnect receiver (not supplied). They're assignable, which means you can assign each...

Owner Manual - Page 13

.... Front & Rear Panels-Continued O CBL/SAT IN A cable or satellite receiver can be connected to a powered subwoofer. R SUBWOOFER PRE OUT This analog audio output can be connected here for connecting the audio signal. S FRONT SPEAKERS B These push terminals are analog audio input jacks for connecting a DVD/BD player. There is composite video input jacks for connecting...

Owner Manual - Page 16

... button (45) Adjusts the display brightness. L RETURN button Returns to change audio settings. Note: An Onkyo cassette recorder connected via V can also be controlled in parentheses... used to turn speaker sets A and B on or off. 16 E Arrow [R]/[X]/[F]/[S] and ENTER buttons Used to change settings. K VOL [R]/[X] button (44) Adjusts the volume of the AV receiver regardless of the currently...

Owner Manual - Page 17

... toward the AV receiver's remote control sensor, as shown below. Keep this in mind ...open the battery compartment, press the small lever and remove the cover. Aiming the Remote Controller When using the remote controller, point it and the AV receiver...replacing the batteries. • Don't mix new and old batteries or different types of the same type is used in the same room, or the AV receiver...

Owner Manual - Page 22

... receiver is for use only. 1 Attach the FM antenna, as shown. 2 Connect both wires of the AM loop antenna to the AM push terminals, as possible from your AV receiver, TV, speaker cables, and power ...the insulation. Push Insert wire Release Once your AV receiver is for use, you must connect the antenna to achieve the best possible reception. Keep the antenna as far away as shown. (The...

Owner Manual - Page 24

... or malfunctions). • To prevent interference, keep audio and video cables away from power cords and speaker cables. Note: The AV receiver does not support SCART connections. 24 AV Cables...receiver's optical digital jacks have shutter-type covers that open when an optical plug is the same as for analog audio and can carry uncompressed standardor high-definition digital video and audio...

Owner Manual - Page 25

... player, etc. Coaxial Analog Analog 25 Connecting the AV receiver-Continued Connecting Audio and Video Signals to the AV receiver By connecting both the audio and video outputs of your DVD player and other AV components to the AV receiver, you choose will output the signal. Speakers (see page 42). When choosing a connection format, bear in...

Owner Manual - Page 26

...picture. Until now, several separate video and audio cables have been required to the AV receiver via HDMI must also support HDCP. The AV receiver's HDMI interface is a new digital interface ... and Silicon Image, this open industry group's objective is compatible with DVI (Digital Visual Interface),*1 so TVs and displays with some components) to connect the AV receiver's HDMI OUT to eight ...

Owner Manual - Page 27

..., video signals from a component connected via HDMI, check its speakers output no HDMI signal will be seen on the TV screen (on your HDMI-compatible player to an analog and/or digital audio input on the AV receiver. ■ Audio Signals • Audio and video signals received via inputs other Sound off Notes: • The HDMI...

Owner Manual - Page 28

... that matches your TV ( a , b , or c ), and then make the connection. If your TV has no audio outputs, connect an audio output from your VCR or cable or satellite receiver to the AV receiver and use connection b or c . Connection A B a b c AV receiver COMPONENT VIDEO OUT MONITOR OUT V TV/TAPE IN L/R DIGITAL IN COAXIAL 1 (DVD/BD) DIGITAL IN...

Owner Manual - Page 29

... b or c . (To record as well, use the main left and right outputs, be assigned (see page 42) VIDEO OUT L R AUDIO OUT Y PB PR COMPONENT VIDEO OUT DVD/BD player 29 Connection A B a b c AV receiver COMPONENT VIDEO IN 1 (DVD/BD) DVD/BD IN V DVD/BD IN L/R DIGITAL IN COAXIAL 1 (DVD/BD) DIGITAL IN OPTICAL...

Owner Manual - Page 30

... VCR or DVR to listen to your favorite TV programs via the AV receiver, which is useful if your VCR or DVR ( A or B ), and then make the connection. Step 2: Audio Connection Choose an audio connection that matches your TV has no audio outputs. You must be assigned (see page 42) OPTICAL OUT COAXIAL OUT...

Owner Manual - Page 31

...⇒ ⇒ VCR or DVD recorder Composite video input Audio L/R input C A a VIDEO IN L R AUDIO IN VCR or DVR Notes: • The AV receiver must be connected to composite video inputs can only be turned...record directly from your TV or another video source without going through the AV receiver, connect the audio and video outputs from your source TV or VCR is connected to a composite...

Owner Manual - Page 47

...Music Optimizer function only works with PCM digital audio input signals with music files that use "lossy" compression, such as MP3. Specifying the Digital Signal Format The following issues when playing...Normally, the AV receiver detects the format of digital input signals automatically. RECEIVER F, S AUDIO 1 Press the [RECEIVER] button, and then press and hold [AUDIO] button for each ...