Sharp UX 355L Support Question
Sharp UX 355L Support Question
Find answers below for this question about Sharp UX 355L - B/W Thermal Transfer.Need a Sharp UX 355L manual? We have 1 online manual for this item!
Question posted by waynehill08 on October 2nd, 2015
Wide Black Lines
When trying to make copies on my UX 355L fax machine it prints out wide black lines on my pape
Current Answers
Answer #1: Posted by TommyKervz on October 2nd, 2015 7:33 AM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,813
Member since:
January 10th, 2013 Points: 17,776,813
Any dirt or material on the scanning glass will cause spots to appear on copies and transmitted faxes. Clean the scanning glass as explained on page 129.
OR see page 126 for print head maintenance: http://www.manualslib.com/manual/151556/Sharp-Ux-355l.html?page=128#manual
Related Sharp UX 355L Manual Pages
UX-355L Operation Manual - Page 3
... pels/inch (8 pels/mm) Vertical:
Standard: 98 lines/inch (3.85 lines/mm) Fine /Halftone:
196 lines/inch (7.7 lines/mm) Super fine:
391 lines/inch (15.4 lines/mm)
10 pages max. (20 lb paper)
Thermal transfer recording
*Based on ITU-T Test Chart #1 at standard resolution, excluding time for choosing a Sharp facsimile machine! Introduction
Welcome, and thank you for protocol signals...
UX-355L Operation Manual - Page 6
... electric shock from lightning.
• Do not use a telephone to use on a line which has call waiting, call forwarding, or certain other than a cordless type) during a lightning storm.
• Never install telephone jacks in wet locations unless the jack is specifically designed for use the fax machine in conjunction with digital telephone systems.
4
UX-355L Operation Manual - Page 10
... the line and fax tones through the speaker when faxing a document. At any other time, press this key to print out the Help List, a quick reference guide to the operation of your fax.
14 STOP key Press this key to cancel an operation before it is completed.
15 START/MEMORY key Press this key to make a copy...
UX-355L Operation Manual - Page 15
... into the TEL. SET jack.
TSEELT. Do not insert it into a standard (RJ11C) single-line wall telephone jack.
If you are on a pulse dial line, you must set for pulse dialing. STOP
13 LINE.
Note: The fax machine is set the fax machine for tone dialing. TONE PULSE
1 or 2
3 Press the STOP key to return to
select...
UX-355L Operation Manual - Page 18
... the green release on the right side
of Sharp UX-3CR imaging film. When replacing the film, use a roll of the machine forward, and open the print compartment cover.
16 Note: If there is paper in the fax applies heat to the imaging film to transfer ink to load or replace the film.. Follow the...
UX-355L Operation Manual - Page 34
... have connected an answering machine to the fax (see Chapter 7).
FAX mode: Select this mode when you go out to the fax machine.
mode: Use this mode when you only want to receive both phone calls and faxes on the line connected to receive voice messages in your answering machine and faxes on your fax machine. TEL FAX
JUN 01 10:30...
UX-355L Operation Manual - Page 37
.... (Once you have requested your telephone company to withhold your Caller ID information when you place calls, your fax will still automatically transmit this feature, you will need to register with OpenLCR, your fax machine automatically makes this call.)
♦ All calls routed by automatically routing each call for and use OpenLCR if you...
UX-355L Operation Manual - Page 38
... OpenLCR Line Activation Form, and then fax the form as follows:
1 Place the form with the side you
wrote on face down, and push it gently into by fax, fill in your fax that it must receive new rate data. After OpenLCR
the form is not between you and any carriers.
Your fax will print out...
UX-355L Operation Manual - Page 40
... same line, please call OpenLCR at OpenLCR's Web site, www.OpenLCR.com. This will receive the rate data from OpenLCR.
After registering you will need to respond. (This makes your fax temporarily issue tone signals when you press the number keys.)
♦ When registration is completed, your fax machine will last one OpenLCR-enabled device to...
UX-355L Operation Manual - Page 42
.... The test is free of the Fax Transmission Test and OpenLCR Line Activation Form and faxing it to OpenLCR as shown below. Setting Up and Using OpenLCR
Fax transmission test
Even if you are not... receiving the test sheet, the current date and time will automatically be programmed in your fax machine. The display will show:
READY TO SEND
2 Press the OpenLCR key, the 5 key,
and then ...
UX-355L Operation Manual - Page 46
Be sure that you are on the fax
machine.
2 Press the OpenLCR key and then the
3 key.
3
OpenLCR
3 If the display shows the alternating
messages ... Pick up the handset on a pulse dial line, press the * key before pressing the number keys to respond. (This makes your fax temporarily issue tone signals when you press the number keys.)
44 If not, your fax may not dial the correct number to connect ...
UX-355L Operation Manual - Page 60
... pressing the number keys.
♦ If a person answers, you can talk with them through the handset before sending the fax. (If you pressed the SPEAKER key, you must pick up the handset or press the
SPEAKER key.
The display will ...2 Pick up the handset to talk.)
♦ Normal Dialing allows you to listen to the line and make sure the other fax machine is responding.
1 Load the document(s).
UX-355L Operation Manual - Page 71
....
If no names have been stored at which the fax machine makes automatic redialing attempts.
1 Press these keys:
The display will make up to scroll
through the names (numbers if you can...automatic dialing (including Direct Keypad Dialing) and the line is established. Stop when the desired
or
name appears in the list. The fax machine will show: RECALL INTERVAL
FUNCTION
4
69 Recall...
UX-355L Operation Manual - Page 73
...
FUNCTION
4
2 Press 1 to turn on the telephone line before printing at the receiving end. 3.
This will increase slightly the amount of memory available for both transmissions and receptions, and is called Error Correction Mode (ECM). Sending Documents
Sending a Fax by Automatic Dialing
Error Correction Mode
The fax machine is set to automatically correct any distortions...
UX-355L Operation Manual - Page 76
... with the fax's handset
1 When the fax machine rings, pick up the fax machine's handset or... an extension phone connected to begin reception.
74
When the reception mode is set to TEL, you must answer all calls by picking up
the handset.
2 If you have set the Fax Signal Receive setting to NO, press the START/MEMORY key to the same line...
UX-355L Operation Manual - Page 133
... or
correct jack. Try sending the document again.
• Make a copy of the document on page
press the SPEAKER key. 11. LINE jack, and not the TEL. The power is
• Noise on page 13. See Connecting the handset on your fax machine.
received at the receiving end.
• Make sure that the telephone line is plugged into...
UX-355L Operation Manual - Page 134
... that is appropriate for the thermal transfer printer in the feeder of your machine's printing ability. Make a copy or print a report to send higher contrast documents. Have the other party to check your machine. Received images are distorted.
• Noise on the telephone line may need service.
132 See Print head on page 126.
• Make a copy or print a report on page 99...
UX-355L Operation Manual - Page 135
... telephone line jack (not the answering machine's extension phone jack).
• Make sure your fax machine's reception mode is poor and/or black spots appear. Reception/copying is set to appear on copies and transmitted faxes. Answering machine connection
Problem
The answering machine connection does not operate properly.
Troubleshooting
A received document or copy prints out...
UX-355L Operation Manual - Page 149
...Black
Cas No. 1333-86-4
Proportion 9%
OSHA PEL 3.5 mg/m3
Paraffin Wax (fume)
8002-74-2
23%
- Ethylene-vinyl acetate copolymer 24937-78-8
1 - 5%
-
Others
-
1 - 5%
- If an "F" does not appear, please read pages 147 to base an opinion of carcinogenicity. Polyethylene terephthalate
25038-59-9
50 - 55%
-
This classification is given to chemicals for thermal transfer... UX-3CR...
UX-355L Operation Manual - Page 151
... Black
CAS No. 25038-59-9
1333-86-4
Proportion 51.0% 8.5%
OSHA PEL ACGIH TLV
-
-
3.5 mg/m3 3.5 mg/m3
Other Limits - Polyester resin
27923-68-8
1.3%
-
-
- Others
-
1.5%
-
-
- Ingestion? Signs and Symptoms of Entry :
Inhalation? Product Identification
Product Code : UX-3CR Imaging Film Section 2. It is a thin film coated with ink.
Telephone number for thermal transfer...
Similar Questions
Machine Is Hooked Up But No Dial Tone. Just Using To Send Faxes
I have no dial tone on the fax machine. Only uses the machine to send faxes.
I have no dial tone on the fax machine. Only uses the machine to send faxes.
(Posted by tgales67 8 years ago)
Sharp Mx-5001n / Multifunction Devices
I want to scan a color print and email to myself. 1) Can this machine scan to TIFF rather than pdf? ...
I want to scan a color print and email to myself. 1) Can this machine scan to TIFF rather than pdf? ...
(Posted by garbagebinz 9 years ago)
How To Clean Up The Black Line When Make Copies
there are black lines or areas after copies
there are black lines or areas after copies
(Posted by pyang 12 years ago)
How To Clean Up The Black Line When Make Copies
there are black lines or areas after copies
there are black lines or areas after copies
(Posted by pyang 12 years ago)
2-inch Wide Black Line On Faxes And Copies
(Posted by dmg2 13 years ago)