Toro 20333 Support Question
Toro 20333 Support Question
Find answers below for this question about Toro 20333 - BBC Personal Pace Walk Power Mower.Need a Toro 20333 manual? We have 2 online manuals for this item!
Question posted by tww1936 on August 28th, 2016
Grinding Noise When Starting Mower Forward Movement.
When pushing the handle to start mower forward movement there is a grinding noise. I have adjusted the cable to max possible but still get the grinding sound.
Current Answers
Answer #1: Posted by Odin on August 28th, 2016 12:57 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,670
Member since:
April 10th, 2010 Points: 41,236,670
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Toro 20333 Manual Pages
Operation Manual - Page 1
This rotary-blade, walk-behind lawn mower is a violation of California Public Resource Code Section 4442 to use or operate the engine on ...uses 2 words to avoid injury and product damage.
It is not equipped with Canadian ICES-002.
22in Recycler® Lawn Mower
Model No. 20333-Serial No. 312000001 and Up Model No. 20333C-Serial No. 312000001 and Up
Form No. 3371-840 Rev A
Operator...
Operation Manual - Page 2
... to alert you to potential personal injury hazards. If you start to slip and fall accidents, which could cause a slip and fall accident.
• Do not mow near or under the influence of slopes; Exercise extreme caution when changing direction on slopes.
• Watch for walk-behind rotary lawn mowers and the B71.1 specifications of...
Operation Manual - Page 3
...Handling of grass, leaves, or other debris build-up oil or fuel spillage and remove any adjustments...devices.
Repair, if necessary, before starting .
• Check grass catcher ...possible, then refuel such equipment with a portable container, rather than the operator.
• Be alert and turn mower...before filling.
• Remove gas-powered equipment from a gasoline dispenser nozzle....
Operation Manual - Page 4
Indicates the blade is identified as a part from moving parts.
5. Cutting/dismemberment hazard of hand or foot, mower blade-do not operate up .
108-8117
1. Cutting/dismemberment hazard of hand or foot, mower blade-stay away from the original
machine manufacturer.
94-8072
114-7982
1. Lock
112-8867 2. Manufacturer's Mark 1. operate side to...
Operation Manual - Page 5
Setup
Important: Remove and discard the protective plastic sheet that you install the handle. Remove the handle knobs from the mower housing (Figure 4). Important: Route the cables to the operating position. 3. Install and tighten the handle knobs that covers the engine.
1
Installing the Blade Control Bar
No Parts Required
Procedure
Install the blade control bar into...
Operation Manual - Page 6
...
12. Handle knob (2)
6. Recoil start handle
7. Dipstick...not shown) 13. Grass bag
Figure 7 2. Control bar lock
1. Do not overfill. (Max. change it does come with oil in the engine, but it yearly thereafter. Side discharge...(4)
2. 3
Filling the Engine with Oil
Product Overview
No Parts Required
Procedure
Your mower does not come with a bottle of SF, SG, SH, SJ, SL, ...
Operation Manual - Page 7
...octane minimum). Do not overfill. (Max.
Wait 3 minutes after adding oil...starting problems, add fuel stabilizer to stop.
• Do not put your fingers under the housing when adjusting the cutting height. Adjusting the Cutting Height
WARNING
Adjusting...Wipe up spills.
• Do not handle gasoline when smoking or around an open...place the container and/or mower directly on the ground before ...
Operation Manual - Page 8
... handle and your elbows at your mower (Figure 11) is a toggle switch (with you feel resistance, then pull it sharply (Figure 12). Starting the Engine
1. Using the Self-propel Drive
To operate the self-propel drive, simply walk with your hands on your sides, and the mower will automatically keep pace with both an "I" and a "Stop"), push...
Operation Manual - Page 9
... lock back (Figure 15). Ignition toggle switch
Disengaging the Blade
Release the blade control bar (Figure 18). You can also try reaching just under the personal pace handle to the metal handle and push the mower forward a couple of inches (centimeters...
Operation Manual - Page 10
...mower inspected and serviced by an...mower...mower, repeat steps 4 through 10.
11. Immediately push the mower over the newspaper ball.
9. Install the empty grass bag on the mower...your mower ...mower onto a paved surface...mower comes from the factory ready to stop . Take a half sheet of the mower.
5. Go to stop .
10. Note: If the bag does not immediately deflate, the blade is engaged and rotating. 4. Start...
Operation Manual - Page 11
... moving parts to Operating the Bag-on the handle (Figure 19).
3. Bagging the Clippings
Use the ...personal injury or death to Removing the Side Discharge Chute) before leaving the operating position.
1. Install the grass bag, ensuring that the pins on the mower...other similar debris to collect grass and leaf clippings from the lawn.
Note: Ensure the bag is sharp; If the side ...
Operation Manual - Page 12
...grass. Bag-on -Demand Lever).
If the grass bag is on the mower and the bag-on-demand lever is in serious personal injury. Operating the Bag-on-Demand Lever
The bag-on-demand feature allows... the grass bag is attached to the mower.
• For bagging the grass and leaf clippings, press the button on the bag-on-demand lever and move the lever forward until the button on -demand door
2....
Operation Manual - Page 13
...Adjusting the Cutting Height.
• When cutting grass over any object.
• If the mower strikes an object or starts to vibrate, immediately stop the engine, disconnect the wire from the spark plug, and examine the mower...setting and walk slower; Cut the grass more of the following:
- Operating Tips
General Mowing Tips
• Clear the area of the grass blade at a slower pace while ...
Operation Manual - Page 14
... mm) and the rear wheels at 2-1/2 inches (64 mm). set the front cutting height one or two notches higher than 5 inches (13 cm) of the lawn shows through the cut the leaves finely enough.
14 You may need to make more than one pass over the leaves.
• If there are...
Operation Manual - Page 15
..., allow the fuel tank to the spark plug.
Gasoline is flammable, explosive and can cause personal injury.
Run the engine dry or remove the gasoline with the air filter up.
If you must tip the mower prior to your engine operator's manual for additional maintenance procedures. Disconnect the spark plug wire from...
Operation Manual - Page 16
... properly at a local recycling
center. Loosen the cable support nut (Figure 28).
1. Dipstick
Figure 26
3.
Pull down the cable jacket (toward the mower) until the oil level reaches the Full line on the dipstick (Figure 27). Adjusting the Self-propel Drive Cable
Whenever you install a new self-propel cable or if the self-propel drive is...
Operation Manual - Page 17
... the nut on the cable support.
Install the new... it . If the blade edge is damaged or cracked, replace it immediately.
Tip the mower onto its side with the air filter up . 3. Blade driver 5.
If you run out... Every 25 hours
Clean the blade brake clutch shield yearly to 37 N-m). Tip the mower onto its side with the air filter up .
3. Stiffener
3. Refer to Preparing ...
Operation Manual - Page 18
... to
27 ft-lb (20 to its lowest cutting height setting. Start the engine and run it from under the mower housing.
• Wear eye protection.
• Stay in the area. Allow the engine to Adjusting the Cutting Height.
2.
Refer to cool before storing the mower in both the fully forward and fully rearward positions.
4.
Operation Manual - Page 19
... (20 N-m). 9. Run the mower until it with a torque wrench to prevent cylinder corrosion during the off-season. 8. Start the engine again. 5. Remove the spark plug, add 1 oz. (30 ml) of any unused fuel properly. Remove the ignition key (electric-start the engine, it is sufficiently dry. 6. Fold the upper handle forward as you can move...
Operation Manual - Page 20
...not apply to you , is covered under "Lawn Mowers") or access our web site at their ...starts such as filters, fuel,
lubricants, oil changes, spark plugs, air filters blade sharpening or worn blades, cable/linkage adjustments, or brake and clutch adjustments...Starting Guarantee
A 3-Year Full Warranty (Not Applicable for Commercial Use)
22 in Recycler® 20 in Mulcher/Bagger
Walk Power Mowers...
Similar Questions
How To Change Drive Belt On Toro Personal Pace Mower Model # 20333
(Posted by sewPhila5 10 years ago)
Toro 22 Personal Pace Will Not Start
(Posted by cirrmazur 10 years ago)
My Toro Personal Pace Mower Will Not Stay Started
(Posted by psthiibry 10 years ago)
How Do You Replace The Traction Bar On A Toro Personal Pace Mower
(Posted by pdfecool 10 years ago)
Person Pace Feature Stopped Working, Is There An Adjustment I Can Make?
The Personal Pace feature stopped within 10 minutes of first use. The grass was damp at the time. Is...
The Personal Pace feature stopped within 10 minutes of first use. The grass was damp at the time. Is...
(Posted by jhcook1755 13 years ago)