Zanussi ZWJ14591W Support Question
Zanussi ZWJ14591W Support Question
Find answers below for this question about Zanussi ZWJ14591W.Need a Zanussi ZWJ14591W manual? We have 1 online manual for this item!
Question posted by michelechi on July 9th, 2015
It Doesnt Rinse Properly....
the machine has given an E20 error code, but it started again when i press the start button. now it doesnt rinse even the program is done.
Current Answers
Answer #1: Posted by TechSupport101 on July 9th, 2015 5:47 AM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
Here http://homeguides.sfgate.com/clothes-not-rinsing-properly-washer-84719.html are possible causes of a washer rinse issues.
Related Zanussi ZWJ14591W Manual Pages
Product Manaul - Page 1
EN User manual Washing Machine
ZWJ 12591 W ZWJ 14591 W
Product Manaul - Page 3
... can not be fully opened. • Always be connected to the "Programme chart" chapter). Directives.
Safety instructions
Installation
• Remove all metal objects from the laundry.
• Do not put flammable products or items that are wet with the appliance. • Make sure that you move the appliance because it is...
Product Manaul - Page 4
... the door catch to prevent children
and pets to get closed in an economical way. Your new washing machine is fitted with a moist soft cloth.
the Service to ensure which detects the laundry amount in some programmes for cotton and synthetic items and chooses the best cycles for washing in the appliance...
Product Manaul - Page 5
.... Any fabric softener or starching additives must be poured into the compartment before starting the wash programme. The stain remover is a picture of the wash programme. Light 4 PREWASH button www.zanussi.com
2345 6
7
8
5 EXTRA RINSE button 6 ECONOMY button 7 Display 8 START/PAUSE button 9 DOOR LOCKED pilot light
5
Compartment for stain remover used during the stain action...
Product Manaul - Page 6
... normally soiled laundry and at a temperature of the programme». The machine is working or has stopped with any programme.
Prewash By selecting this option if you want to interrupt the selected programme. This option is very soft. The programme is designed to select a programme.
10 DELAY START button
Table of symbols
= Rinse hold By...
Product Manaul - Page 7
.... The washing time is updated every minute. Duration of button 7 starts flashing with the set a programme, the duration is displayed in a few seconds, then the display show again the duration of the set programme. The light of the selected programme
After you set wash programmed, the display shows the message Err for a few...
Product Manaul - Page 8
...indicate that the appliance has
started the heating phase of the water in the tub. load 8 kg -
Rinses Maximum spin speed at the...RINSE HOLD
HEAVY / LIGHT1) / ECONOMY2)4) PREWASH3) EXTRA RINSE
SPIN REDUCTION RINSE HOLD
LIGHT1) / ECONOMY2)
PREWASH3) EXTRA RINSE
8
www.zanussi.com Heating phase icon 5 During the washing cycle the display shows a temperature icon to the amount of Laundry...
Product Manaul - Page 9
...spin. Mini 30° 30° Main wash - The machine performs some rinses, followed by hand. Drain Draining of the last rinse in programmes with «hand washing» care symbol. Cold ...Maximum Fabrics Load Type of Laundry
Proportional Programmes
Delicates 40° - 30° - Wool -
Rinses Maximum spin speed at 700 rpm Max.
Cold Main wash - Rinses Maximum spin speed at ...
Product Manaul - Page 10
... cotton cloth.
Before loading the laundry Never wash whites and coloureds together. Button up in the first wash;
...running or to switch the machine off .
1) If you select the 'LIGHT' option (button 3), we recommend that you...laundry as indicated. Remove hooks or tie them prior to be washed separately the first time. Helpful hints and tips
Sorting out the laundry Follow the wash code...
Product Manaul - Page 11
...lightly and treat with bleach and then rinse thoroughly. Detergents and additives
Good washing results...coloureds only). All commonly available washing machine detergents may be used
The type ... washing a small load
• the laundry is medium or high we suggest you ... temperature and degree of the dispenser drawer before starting the wash programme. Although biodegradable, detergents contain ...
Product Manaul - Page 12
... programme/option it stops.
By pressing these 2 buttons again, the acoustic signal is not working. Before pressing button 7: it will be impossible to start the machine. Close the door. If required, pour fabric softener into the main wash compartment and start the machine.
2.
Close the drawer gently.
12
www.zanussi.com laundry in the machine, to remove any other programme...
Product Manaul - Page 13
... 9 illuminates to indicate that programme. (See "Washing programmes" for that the appliance starts operating and the door is displayed to be turned either clockwise or anticlockwise. The machine will begin the countdown.
Start the programme by pressing button 7.
2. If you want your laundry to indicate a wrong selection. The selected delay time value will blink 3 times...
Product Manaul - Page 14
...to press button 7. By pressing any change some options before opening the door. Altering an option or a running . Start the new programme by pressing the relevant button.
4. Press the button again ...draining. Press button 7. Remove the laundry from the drum and carefully check that ends with the draining programme. The brightness of the programme
The machine stops ...
Product Manaul - Page 15
... not clean the drain pump if the water in the machine. It is hot. Cleaning the dispenser drawer The washing ... manufacturer's instructions.
Replace the drawer and run the rinse programme without any laundry washing, and according to periodically use normally contains lime...can carry out any traces of the addidownwards and by pressing the catch top part of accumulated powder. You must ...
Product Manaul - Page 17
... the water tap. Frost precautions If the machine is not responsible for more than 0 °C before you must activate again the drain system: 1. press the two levers and pull forward the
drainage...you drain the water with water, the starting button blinks yellow or the display (if available) shows the relevant alarm (see chapter "What to the machine and make sure the connection is tight...
Product Manaul - Page 18
Problem The machine does not start . The selector dial is closed. • Open the water tap.
The water tap is not correctly positioned and/or the button 7 has not been pressed. • Please turn the selector dial and press the button 7 again. Certain problems are due to lack of the following alarm codes appears on the display and...
Product Manaul - Page 19
...washing cycle. The programme is very little laundry in the drum. • Select drain or spin programme to treat the stubborn stains. The filter has not been properly screwed in after cleaning action. • ...There is water on the floor:
Unsatisfactory washing results:
The door will not open:
The machine vibrates is noisy:
Possible cause/Solution
The drain hose is clogged. • Clean the...
Product Manaul - Page 20
... a water tap with other traditional motors.
This new motor ensures a softer start and more items, redistribute the load manually and then select the spinning programme. If, after 10 minutes, the laundry is redistributed by reverse rotation of the drum.
No
Ser. Machines based on modern technology operate very economically using very little water...
Product Manaul - Page 21
...
53
44
53
44
53
44
Off Mode (W)
Left On Mode (W)
0.10
0.98
The information given in the charts above are advised to keep all transit devices so that they can change the data:...with the kit. The data of laundry, the water and ambient temperature. You are in the fixing plates. Water consumption (li- Different causes can be refitted if the machine ever has to prevent vibration, ...
Product Manaul - Page 25
When the appliance is disposed of this product.
Instead it should not be caused by inappropriate waste handling of correctly, you purchased the product. The appliance should be treated as household waste. For more detailed information about recycling of safely. Packaging materials
The materials marked with the symbol are recyclable. >PEPSPP The symbol on the product or on ...
Similar Questions
Can't Start The Machine
Power is on to display, all symbols, but nothing works.
Power is on to display, all symbols, but nothing works.
(Posted by hughwolfson 10 months ago)
Noisy Zanussi Zwj 14591 W Washing Machine
Hello, our washing machine has started making a horrible noise most of the time during every cycle, ...
Hello, our washing machine has started making a horrible noise most of the time during every cycle, ...
(Posted by pallavik 2 years ago)
Zanussi Zwt 71401 Wa Washer/dryer
starting problem. when turning the dial to select a program nothing is showing in led display. somet...
starting problem. when turning the dial to select a program nothing is showing in led display. somet...
(Posted by derekhenson 7 years ago)
Machine Wont Empty And Wont Start Lights Are On On Machine
(Posted by yasminbutler15 10 years ago)
Spin Setting Not Working
I have just bought a zanussi washer ZWJ14591W. The water is being retained in the drum after putting...
I have just bought a zanussi washer ZWJ14591W. The water is being retained in the drum after putting...
(Posted by swestwell920 10 years ago)