Zenith SL-5597-BZ-E Support Question
Zenith SL-5597-BZ-E Support Question
Find answers below for this question about Zenith SL-5597-BZ-E - Heath - Quartz Halogen Motion-Sensing Twin Security Light.Need a Zenith SL-5597-BZ-E manual? We have 1 online manual for this item!
Question posted by lexmak2 on July 29th, 2012
Three Flashes
Of the four units mounted, 2 of them reamian illuminated. Both of these fixtures give off three red flashes. What are they telling me?
Current Answers
Related Zenith SL-5597-BZ-E Manual Pages
User Manual - Page 1
...Sensor
Light Control
2 Wire Connectors
Mounting Bolt
Mounting Strap
2 Lamps (installed)
6 Screws (3 sizes included)
Gasket
MANUAL MODE
Manual mode only works at dawn. Meets the ENERGY STAR® guidelines when DualBrite® function is off during daylight hours. • LED indicates motion was sensed...174; Motion Sensor Light Control
Model 5597
Requirements
• The light control ...
User Manual - Page 2
... rotate the sensor head clockwise 180° so the controls face down will be rotated as described in the AUTO mode. For best performance, mount the fixture about 8 ft. (2.4 m) above the ground. If motion is mounted higher than 3' (1 m). • Use only T4 100W (max.), G8 tungsten halogen
bi-pin 120 VAC lamps. DualBrite® Timer
Light comes...
User Manual - Page 3
... the shades in the mounting strap.
Bulb Installation
Mount the Light Control
NOTE: When re-lamping, turn shades counterclockwise and
Mounting Black to Strap Black
White to White
remove. Align the mounting screw with silicone weather
clockwise. The small end then goes into one of the cover plate.
Secure with tabs on fixture. Check that fit your...
User Manual - Page 4
... fixture is less sensitive to motion directly towards it will detect motion. The detector is mounted higher than 8 ft.(2.4 m), aiming the sensor down , or
sideways to the TEST position.
Sensor
Least Sensitive
Most Sensitive
MAX
B ON - TIME DUAL BRITE
OOST
MIN
TEST 1 5 2 0 OFF 3 6 DUSK TO
RANGE
MINUTES
HOUR DAWN
Bottom of TIME you want the lights on...
User Manual - Page 5
... a relatively dark location. (Relocate sensor, or use 3 hr or 6 hr setting). Light control may be sensing small animals or automobile traffic (re-aim sensor).
2. POSSIBLE CAUSE
1. Fuse is blown or circuit breaker is pointed toward a heat source like an air vent, dryer vent, or brightly-painted heat-reflective surface. (Reposition sensor. Lights flash once, then stay off...
User Manual - Page 6
... Service
Please call * for assistance at : www.hzsupport.com. For a period of ten years from state to state or province to misuse, abuse or negligence, light bulbs, batteries, and other expendable items are not covered by factory defective parts or workmanship will void this guide.
Similar Questions
How To Deactivate The Motion Sensor On The Heath/zenith Sl-5610-wh-b?
How to deactivate the motion sensor on the Heath/Zenith SL-5610-WH-B?
How to deactivate the motion sensor on the Heath/Zenith SL-5610-WH-B?
(Posted by emvilla 4 years ago)
Motion Sensor
Hi. Just bought a 10 year old house with Heath sensor on the back porch. I turn on the light and it ...
Hi. Just bought a 10 year old house with Heath sensor on the back porch. I turn on the light and it ...
(Posted by Barry95996 9 years ago)
How To Wire Health Motion Sensor Sl-5410a
(Posted by ranyog 9 years ago)
Can't Get My Secure Home Sh 5597 Motion Detector Light To Work
Tried following the manual bt can't get the light to off
Tried following the manual bt can't get the light to off
(Posted by patgore27 11 years ago)
