iRobot Verro 500 Support Question
iRobot Verro 500 Support Question
Find answers below for this question about iRobot Verro 500.Need a iRobot Verro 500 manual? We have 1 online manual for this item!
Question posted by marknaquin on May 18th, 2021
Varro 500 Replacement Propeller. Is This Part Availabile?
is the propeller for the verro 500 pool vacuum available for purchase?
Current Answers
Answer #1: Posted by techyagent on May 19th, 2021 2:13 AM
techyagent
Member since:
June 17th, 2014 Points: 4,799,790
Member since:
June 17th, 2014 Points: 4,799,790
please check this link below:-
Thanks
Techygirl
Answer #2: Posted by SonuKumar on May 19th, 2021 3:32 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,627,790
Member since:
May 9th, 2021 Points: 16,627,790
https://shopee.com.my/Varro-Watt-500w-Fan-12cm-Black-Power-Supply--Psu-Varro-500-Watt-i.264899849.7642541658
https://shopee.ph/Varro-Psu-Chronograph-500w.-Varro-Power-Supply-500-Watt-i.328070448.4159372812
its called as 12 volts dc fan.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related iRobot Verro 500 Manual Pages
Product Manual - Page 2
... result in the pool all the time. Do not leave the cleaner in leakage of lubricants. Always remember to avoid hazards. The unit must be replaced by the manufacturer's... service agent or a qualified and trained person in order to turn the Power Supply OFF and unplug it must be installed to the branch circuit should not be consistent with water.
iRobot Verro...
Product Manual - Page 3
...for 15 to cool adequately. Do not use the floating power cord to lift Verro from the pool. Do not use Verro in a pool warmer than 100 degrees Fahrenheit. www.irobot.com It will allow the ... of its cleaning cycle. Use the handle. Do not leave your pool cleaner.
Allow the cleaner to remain in the pool for future reference. Never leave the Power Supply in direct sunlight and...
Product Manual - Page 4
...available separately at a temperature between 50 and 104 degrees Fahrenheit. The fine filter bag is water resistant, but not waterproof and may be able to improve coverage of the entire pool. (p. 8)
Tip Store Verro in loss of the pool...the walls of large debris (leaves, etc.), such as when the pool is not kept clean, Verro will not clean properly and will result in a dry place out of ...
Product Manual - Page 5
Table of Contents
Anatomy 6 Parts List 7 Using Verro 8 - 10 How Verro Works 11 Cleaning the Filter Bag 12 - 13 Maintenance and Adjustment 14 - 18 Troubleshooting 19 - 20 Customer Care 21
www.irobot.com
Product Manual - Page 7
.... ON button 22. Lock Tabs
www.irobot.com Handle Lock Mechanism 5. Bottom Lid Assembly 14. Wheel Tube Assembly 19. Filter Bag 13. OFF button 20. Vacuum Intake Flaps 24. Drive Belt 7. Handle Assembly 15. Light 21. 22
17
16
19 20 21
24
Parts List
1. Drive Motor 4. Pulley Assembly 6. Drive Track...
Product Manual - Page 8
...Uncoil the floating power cord and spread it over the surface of the water.
3
Place Verro in the water and rock it is right side up and level.
4 Place the Power .... Let Verro settle to escape. Each time Verro cleans the pool, reverse the direction of the pool.
Using Verro
1 Position the handle diagonally across Verro. Ensure that it from the pool. 3.5m/12ft
iRobot Verro Owner's ...
Product Manual - Page 9
.... Push and rotate clockwise
6 Ensure the Power Supply at least 12 feet from the pool and plug it . The length of the cleaning cycle, press the red Power button on
the Power Suppy.
...the light on pool size. ON: Green button turns robot ON. Never leave the Power Supply plugged in when Verro is not in one way. OFF: Red button turns robot OFF...
Product Manual - Page 10
... locking collar on the plug counter-clockwise to lift Verro out of the water.
Using Verro (cont...)
8
When Verro has finished cleaning the pool it will stop automatically and the Power Supply light will drain from Verro as it is not in when Verro is lifted.
10 iRobot Verro Owner's Manual Rotate counter-clockwise and pull to...
Product Manual - Page 11
...your pool all of the other loose dirt and debris. Verro's coverage algorithm allows Verro to brush and clean your pool so that they can be vacuumed up...Verro maintain traction on the pool bottom and walls. www.irobot.com 11
How Verro Works
Verro has a powerful motor that traps dirt and debris down to two microns in size. (For comparison, the period at the end of this sentence is more than 500...
Product Manual - Page 12
...the walls properly.
1 Unplug the Power Supply. (Please keep the plug away from the Power Supply.
2 Place Verro upside down on the pool floor bottom and walls. Towel
3 Unlock and remove the bottom panel by pushing the two locking tabs toward the ... (turn the locking collar counter-clockwise to prevent scratching the robot's shell).
Cleaning the Filter Bag
Verro uses the force of the robot.
Product Manual - Page 13
... detergents, fabric softeners, bleach or other additives.
Gently agitate and squeeze the bag while rinsing it back on the support bars.
Label
8 Replace filter bag assembly in the robot. 9 Replace the bottom cover. If this does not remove all visible dirt, machine wash the bag using cold water on the outside and...
Product Manual - Page 14
... be happy to provide assistance.
1 Unplug the Power Supply. (Please keep your robot looking good for years to replace them when Verro is water resistant, but not waterproof and may be replaced. It is time to come. Remove the four screws that you have any difficulty, please call our customer care representatives at...
Product Manual - Page 15
... the new brushes onto the wheel tubes.
9 Place the brushes back in robot, reinstalling the drive belts and drive tracks over the end hubs.
10 Replace the side plate.
11 Reattach the four screws.
www.irobot.com 15 Wheel Tube
PVA Brush
End Hub
6 Remove the end hubs from the rollers...
Product Manual - Page 16
... down on a towel and remove the filter bag assembly. (p. 12)
2 On each side of the pool.
Maintenance and Adjustment (cont...)
Changing the Drive Belts or Tracks Over time, Verro's drive belts can stretch. When this happens, Verro may move more slowly and may also occasionally hear a click as the drive belt slips on...
Product Manual - Page 17
...as you can walk away from it for 50 feet.
3 Holding the Detangler in your pool in the handgrip so that reduces any tendency for external damage. Untwisting the Floating Power ...Install the new drive belts and drive tracks. 7 Replace the side plates. 8 Reattach the four screws on the surface of the handle before each side. Verro is designed to travel around your hand, walk away ...
Product Manual - Page 18
... the cord is not fully untwisted by the time it is straight, simply give it a few more turns by hand.
Cleaning the Impeller
Outlet Top Propeller
1 Unplug the floating power cord from the Power Supply. 2 Remove the screws that attach the outlet top to the robot. 3 Lift off the outlet top...
Product Manual - Page 19
...the filter bag. (p. 12) cleaned
The brushes,drive belts or drive tracks need replacing
Replace brushes, drive belts or drive tracks. (p. 16)
The floating power cord is tangled or ...What to Do
Verro will not be able to clean as two microns across and can trap particles as small as effectively.
Troubleshooting
Many problems with Verro are available separately from the pool. is not ...
Product Manual - Page 20
Troubleshooting (cont...)
Problem
Verro does not cover the entire pool
Likely cause
What to do
The filter bag needs to be Clean the filter bag. (p. 12) cleaned
The brushes, drive belts or drive tracks need replacing
Replace drive belts and treads. (p. 16)
The floating power cord Use the Detangler to keep the
floating power cord...
Product Manual - Page 22
... Avenue, Burlington, MA 01803. Pricing and availability subject to purchase accessories at: 800.727.9077 or visit store.irobot.com
*See registration card for details. All rights reserved. All rights Reserved.
3000a.07 SAVE 15% on all accessories.*
Verro Accessories: Mesh Filter Bag Fine Filter Bag iRobot Verro Storage Caddy
Visit our website to...
Similar Questions
Irobot Verro 500 Pool Cleaner
I need the bottom lid assembly to attach the bag. Our is cracked
I need the bottom lid assembly to attach the bag. Our is cracked
(Posted by pbdennis 1 year ago)
I Robot 500 Pool Cleaner
My pool cleaner goes one direction hits the wall and then wont go back the other direction any more....
My pool cleaner goes one direction hits the wall and then wont go back the other direction any more....
(Posted by trevorerhardt 2 years ago)
Hello Looking For Replacement Pva Roller For Verro 500
(Posted by luigiferrari 3 years ago)
Verro 500 Pool Cleaner
Have a unit in which the pump starts up but the unit wont propel itself. Have checked the rollers be...
Have a unit in which the pump starts up but the unit wont propel itself. Have checked the rollers be...
(Posted by piperfarms 6 years ago)
Irobot Verro 300 Pool Cleaner
motor is running but not pumping water in order to move /run
motor is running but not pumping water in order to move /run
(Posted by polkadot11 12 years ago)