D-Link DGS-3000-10TC Support and Manuals
Get Help and Manuals for this D-Link item
View All Support Options Below
Free D-Link DGS-3000-10TC manuals!
Problems with D-Link DGS-3000-10TC?
Ask a Question
Free D-Link DGS-3000-10TC manuals!
Problems with D-Link DGS-3000-10TC?
Ask a Question
Popular D-Link DGS-3000-10TC Manual Pages
Hardware Installation Guide - Page 3
DGS-3000 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide
Table of Contents
Intended Readers ...v Typographical Conventions ...v Notes, Notices, and Cautions ...v Safety Instructions...Connecting to the Switch ...26 Password Protection ...26 IP Address Assignment ...27 SNMP Settings...27 Traps...28 MIBs...28 Chapter 5 Web-based Switch Configuration ...29 Introduction ...29 Logging ...
Hardware Installation Guide - Page 4
DGS-3000 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide Web Pages ...31 Appendix Section ...32 Appendix A - Cables and Connectors...37 Ethernet Cable...37 Console Cable ...38 Redundant Power Supply (RPS) Cable ...39 Warranties & Technical Support Information ...40
iv Technical Specifications...32
General ...32 Physical and Environmental ...32 Performance ...33 LED Indicators...
Hardware Installation Guide - Page 5
...For all practical reasons the DGS-3000-10TC, and DGS-3000-26TC will be typed exactly as the Switch throughout this manual.
For example: [copy ...Instructions General Precautions Electrostatic Discharge
The DGS-3000 Series Hardware Installation Guide contains information for set up and management of data and tells how to avoid the problem. All example screenshots are taken from the DGS-3000...
Hardware Installation Guide - Page 6
...exceed 80 percent of all products plugged into properly grounded electrical outlets. DGS-3000 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide
Safety Instructions
Use the following conditions occur, unplug the product from the electrical outlet and replace the part or contact your trained service provider: o Damage to the power cable, extension cable, or plug. Throughout this...
Hardware Installation Guide - Page 7
... rests on any system as well as to various peripherals or supporting hardware. o Unplug the power cable before installing components in serious injury.
• Before working on or tripped... stand on any component when servicing other components in bodily injury under certain circumstances. DGS-3000 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide
• To help protect the...
Hardware Installation Guide - Page 9
... and features supported by the ...Link's managed switch product line. DGS-3000 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide
Chapter 1
Switch Description Features Ports Front Panel Components LED Indicators Rear Panel Description Side Panel Description
Introduction
Switch Description
The DGS-3000 Series is part of the Layer 2 family of switches: • DGS-3000-10TC...
Hardware Installation Guide - Page 10
... v2 • Port Mirroring • LLDP • NLB • Traffic segmentation • D-Link Safeguard Engine • Japanese Web-based Access Control (JWAC) • MAC-based Access Control ...ARP spoofing prevention • MIB support for all ports. DGS-3000 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide
• Single IP Management • Access Authentication Control...
Hardware Installation Guide - Page 11
... D-View, D-Link Corporation's proprietary SNMP management software, go to http://dview.dlink.com.tw/ and download the software and manual. Two Combo Copper/SFP ports (10/100/1000Mbps and 100/1000Mbps).
DGS-3000-26TC has an alarm port at the front panel.
Front Panel Components
The front panel of the Switch consists of the DGS-3000-10TC 3
Twenty...
Hardware Installation Guide - Page 13
... (i.e.
Figure 1-3 LED indicators for the DGS-3000-10TC
LED Power
Console
RPS
Fan Err Link/Act LEDs
Figure 1-4 LED indicators for the DGS-3000-26TC
Description This LED lights green after powering the Switch on .
This LED blinks red when any of the device. DGS-3000 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide
LED Indicators
The Switch front panel...
Hardware Installation Guide - Page 14
...supports the power cord. An optional external Redundant Power Supply (DPS-200) can be plugged into this optional external RPS will take over all the power immediately and automatically.
6 DGS-3000 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide...into a power outlet. Figure 1-5 Rear panel view of the DGS-3000-10TC
Figure 1-6 Rear panel view of the provided power cord into ...
Hardware Installation Guide - Page 15
... even severely damage components.
Figure 1-7 Identical side panels of the DGS-3000-10TC
Figure 1-8 Identical side panels of the Switch for proper ventilation. Leave at least 6 inches of space at the rear and sides of the DGS-3000-26TC
7 DGS-3000 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide
Side Panel Description
The system heat vents located on each...
Hardware Installation Guide - Page 16
... from and adequate ventilation around the Switch. DGS-3000 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide
Chapter 2 Installation
Package Contents Installation Guidelines Power On (AC Power) Alarm Connector (DGS-3000-26TC Only) Installing Power Cord Clip Installing SFP and SFP+ Ports Connecting the DPS-2000 to RS-232 console • One set of Power Cord Clip • One...
Hardware Installation Guide - Page 34
.... Logging in length.
26 NOTE: The first user automatically gets Administrator level privileges. Password Protection
The Switch does not have a default user name and password. DGS-3000 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide
First Time Connecting to the Switch
The Switch supports user-based security that can be given to the Switch's management software. To...
Hardware Installation Guide - Page 40
... 100BASE-TX UTP Cat.3, 4, 5 for 10BASE-T EIA/TIA-568 100-ohm screened twisted-pair (STP)(100m)
DGS-3000-10TC: Eight Copper ports (10/100/1000Mbps), Two Combo Copper/SFP ports (10/100/1000Mbps and 100/1000Mbps).
DGS-3000-10TC: 16.5 Watts (Max.) DGS-3000-26TC: 29.6 Watts (Max.)
32
DGS-3000 Series Layer 2 Managed Gigabit Switch Hardware Installation Guide
Appendix Section
Appendix A -
Hardware Installation Guide - Page 41
... Method Packet Buffer Maximum Forwarding Rate
Switching Capability
Priority Queues MAC Address Table Wire Speed Virtual Stacking / Clustering
Detailed Description Store-and-forward 1.5 MByte (Max) DGS-3000-10TC: 14.88 million packets per second. Support D-Link Single IP Management v1.6 2. RPS is connected and the RPS switch is turned off
Description Power on .
D-Link DGS-3000-10TC Reviews
We have not received any reviews for D-Link yet.