Harbor Freight Tools 62548 - 26 in. Front Tine Tiller Support and Manuals
Get Help and Manuals for this Harbor Freight Tools item
This item is in your list!
View All Support Options Below
Free Harbor Freight Tools 62548 manuals!
Problems with Harbor Freight Tools 62548?
Ask a Question
Free Harbor Freight Tools 62548 manuals!
Problems with Harbor Freight Tools 62548?
Ask a Question
Popular Harbor Freight Tools 62548 Manual Pages
User Manual - Page 2
... the last pages of Contents
Specifications 2 Safety 3 Setup 6 Operationr 8
Maintenances 13 Troubleshooting 18 Parts List and Diagram 20 Warranties 23
Specifications
Front Tine Tiller Specifications
Maximum Tilling Depth Maximum Tilling...mm 1560 ± 50 RPM
The emissions control system for this manual. Table of this Engine is warranted for standards set by the U.S. ITEM 62548
User Manual - Page 3
...Setup
Operation
Symbol Definitions
Symbol
Property or Statement
RPM Revolutions Per Minute
HP Horsepower
WARNING marking concerning Risk of Fire while handling fuel. Wear ANSI-approved safety goggles with side shields.
WARNING marking concerning Risk of Eye Injury.
IMPORTANT SAFETY INSTRUCTIONS... Specifications chart...manual cannot cover all instructions. Read the manual before set...
User Manual - Page 4
...of ditches.
If both hands are holding the Handles and your model. Do not use . Avoid any damage found before use ...in the presence of drugs, alcohol or medication.
23. Repair any actions that may become hazardous when used . Do ...common sense when operating this equipment with both hands only. Safety
Setup
Operating Precautions
1. If the Tines jam or strike a foreign object...
User Manual - Page 5
... this manual or any service or ...replacement parts. If damaged, have the equipment serviced before starting engine. Use the correct equipment for a replacement.
6. Do not smoke, or allow excess to cause cancer and birth defects or other reproductive harm. (California Health & Safety Code § 25249.5, et seq.)
Service... repair person using . This will ensure that may adjust parts that...
User Manual - Page 6
... 62548 Safety
Set Up
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before assembling or making any adjustments to the equipment.
At high altitudes, the engine's carburetor, governor (if so equipped), and any other devices used with proper spark arrestor installed. Assembly...
User Manual - Page 8
...problems...manual including all text under the fill neck of both oil and
unleaded gasoline treated with oil before set up to enter the carburetor, affecting engine performance and/or causing damage.
4. ITEM 62548 Safety
Setup...off with no engine oil. Then replace the Strainer. Then replace the Fuel Cap.
6.
b. Operation
...parts before adding fuel.
Note: Do not use E85 ethanol.
User Manual - Page 9
... then pull it doesn't hit the Engine. Allow Cable to the
START position.
1
To restart a warm engine, leave the Choke in the
RUN position.
2. Safety
Manual Start
1. Open the Fuel Valve.
2
Setup
Operation
3. Repeat until resistance is felt. Then pull the Starter Handle gently until the Engine starts.
User Manual - Page 10
...Manual Start on page 9.
4.
Before starting the Engine, set... depth.
b. Tiller Operation
Setup
Operation
TO PREVENT SERIOUS INJURY...error is difficult to Figure B. Breaking-in period will vary with Tines raised off of the ground. During this period. Set the Drag Bar below the level of use . Replace the Clevis Pin and R-Clip. Start the Engine following instructions...
User Manual - Page 11
.... Note: When installed properly the cutting ...sets of the two Tine Blade Assemblies using the following soil conditions can affect tilling results:
a.
d.
Setup...replaced in the same orientation as when removed. Page 11 To move the Tiller in a reverse direction, make sure the Reverse Clutch Lever (90) is found have the problem corrected before tilling and use a shallow depth setting...
User Manual - Page 13
...service instructions in addition to the regular checks and maintenance explained as a general guide.
Procedure
Brush off outside of the engine and equipment. of use hr. Safety
Setup... safely service the equipment or engine, have the problem corrected ...part of the regular operation of engine Check engine oil level Check for loose hardware Clean debris from
combustion chamber Replace...
User Manual - Page 18
...technician diagnose/ repair ignition system. If that does not work, replace spark plug. Move Choke to RUN position. Do not use gasoline with fuel stabilizer. If problem persists, may require further cleaning.
7. Engine valves or tappets mis‑adjusted or stuck.
4. Gasoline with screwdriver handle.
8.
ITEM 62548 Safety
Setup
Troubleshooting
Problem
Engine will...
User Manual - Page 19
...Clutch Lever.
2.
Diagnose and repair compression. (Use Engine will ... engine.
3. Throttle set too deep for soil...Safety
Setup
Problem
Engine ...replace fuel tank cap.
4. Refuel with fresh 87+ octane unleaded gasoline treated with more than 10% ethanol (E15, E20, E85, etc.).
2. Have qualified technician
worn engine, or other mechanical problems. diagnose and service...
User Manual - Page 20
Parts List and Diagram
Parts List
Safety
Setup
Part
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 ... On/Off Switch Assembly Throttle Control Reverse Gear Tension Pulley Assembly Reverse Clutch Belt 9 x 1133LW Left Drag Bar Support Right Drag Bar Support Forward Clutch Lever Reverse Clutch Lever Drag Bar Forward Clutch Cable Reverse Clutch Cable Throttle Cable Lock Nut M8 Large ...
User Manual - Page 22
... THE PRODUCT.
THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.VV
Safety
Setup
Operation
Maintenance
Record Product's Serial Number Here:
Note: If product has no serial number, record month and year...
User Manual - Page 23
... warranty center
c) Failure to follow the maintenance and operating instructions set forth below to goods, loss of the previous page. Also included may be repaired or replaced by HFT. Coverage Exclusions
Warranty claims shall be hoses, belts, connectors and other emissions‑related assemblies. Service and Maintenance
Engines are warranted for the period of maintenance...
Harbor Freight Tools 62548 Reviews
Do you have an experience with the Harbor Freight Tools 62548 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Harbor Freight Tools yet.
Earn 750 points for your review!