Stihl MS 341 Support and Manuals
Get Help and Manuals for this Stihl item
This item is in your list!
View All Support Options Below
Free Stihl MS 341 manuals!
Problems with Stihl MS 341?
Ask a Question
Free Stihl MS 341 manuals!
Problems with Stihl MS 341?
Ask a Question
Stihl MS 341 Videos
Popular Stihl MS 341 Manual Pages
Instruction Manual - Page 4
... have different parts and controls. When it understands the information contained in good physical condition and mental health and not under the influence of all applicable federal, state and local safety regulations, standards and ordinances.
It is not in use.
!Warning!
the operator 2.
MS 341, MS 361, MS 361 C
3 Use your model. Have your STIHL dealer show...
Instruction Manual - Page 6
...Chainsaw noise may be extremely dangerous. Always wear gloves when handling the machine and the cutting tool. STIHL offers a wide range of the power tool parts see the chapter on "Main Parts...specific STIHL model...MS 341, MS 361, MS 361 C
5 Continual and regular users should have it checked by STIHL for which it is balanced horizontally. Only attachments supplied by STIHL...STIHL servicing...
Instruction Manual - Page 8
... free of moisture, pitch, oil, fuel mix, grease or resin in the instruction manual and the section "Kickback" and the "ANSI B 175.1-2000 chainsaw kickback standard" below.
!Warning! MS 341, MS 361, MS 361 C
7
Never attempt to maintain a firm grip and properly control your manual.
If the chain becomes loose while cutting, shut off the engine and then...
Instruction Manual - Page 10
...uneven ground.
!Warning! Wrap your instruction manual. Your right hand should not ...use in this position, you cannot set the correct idle speed, have your STIHL dealer check your saw with both ...part of your power tool and make proper adjustments and repairs. At correct idle speed, the cutting tool should grip the rear handle. It is heavy.
001BA087 LÄ
MS 341, MS 361, MS...
Instruction Manual - Page 13
...set your muffler maintained by your muffler. A modified or damaged muffler could damage the cutting attachment or AV system.
!Warning!
Some STIHL... fire and burn injuries, the following specific safety precautions must be replaced, consult your STIHL servicing dealer.
!Warning! Catalytic converter
!Warning...serviced and repaired by a STIHL servicing dealer.
12
MS 341, MS 361, MS 361 C
Instruction Manual - Page 15
... STIHL Quickstop chain brake on your STIHL chainsaw.
14
MS 341, MS 361, MS 361 C Compliance with the standard for powerheads below 3.8 cubic inch (62 cm³) displacement are no relationship to reduce the risk of injury in the "Specifications" section of the instruction manual or
- In order for use on "Low kickback saw until the problem has been rectified. other replacement...
Instruction Manual - Page 16
....
MS 341, MS 361, MS 361 C
15 In addition, removal of the hand guard on newer STIHL chainsaws can...guide bar may interfere with the operation of the chain brake. See the chapter of your chainsaw without hand contact. Never operate your instruction manual.
001BA174 KN
!Warning!
See the chapter entitled "Chain Brake" of your instruction manual.
No Quickstop or other parts...
Instruction Manual - Page 24
...which are inexperienced with a chainsaw, plunge-cutting should not be...of the guide bar. If a pinch occurs, stop the engine and remove the saw , you are poorly supported. If you may fall completely, set the saw ...side of the saw and severe or fatal injury to fall , since part of kickback during the limbing operation. Limbing
Limbing is about to maintain ...MS 341, MS 361, MS 361 C
23
Instruction Manual - Page 26
... tension. English / USA
MAINTENANCE, REPAIR AND STORING
Maintenance, replacement, or repair of the emission control devices and systems may be performed by your STIHL servicing dealer only. replace worn sprockets or chains. Tighten all nuts, bolts and screws except the carburetor adjustment screws after each time it must be properly maintained. MS 341, MS 361, MS 361 C
25 Do not...
Instruction Manual - Page 27
... for Rollomatic).
For these reasons, each STIHL chainsaw should also be returned immediately for maintenance whenever the brake system cannot be thoroughly cleaned or there is marked on the guide bar in the instruction manual).
1
2
a
t = a : 2
3
You can run together on this chainsaw -
The chainsaw should be damaged beyond repair after a short period of operation.
001BA105...
Instruction Manual - Page 46
... idle speed screw (LA) slowly clockwise until the chain begins to Using this Manual"
MS 341, MS 361, MS 361 C
45 Idle setting is usually necessary to change the setting of the idle speed screw (LA) after every correction to the low speed screw (L).
* see "Guide to run -
It is too lean: : Turn low speed screw (L)
counterclockwise -
no...
Instruction Manual - Page 62
... publication of this manual, ask your STIHL dealer for your saw model, serial number as well as the part numbers of the parts. Other bars and chains available for this specific powerhead or has been designated as meeting the ANSI § 5.11 requirements on page 16. This will make re-ordering simpler. MS 341, MS 361, MS 361 C
61
Please...
Instruction Manual - Page 63
... some cases, by the STlHL parts symbol (.
English / USA
Maintenance and Repairs
Users of this manual. Other repair work may appear alone on small parts.
62
MS 341, MS 361, MS 361 C
Warranty claims following repairs can be performed only by authorized STIHL service shops. This symbol may be identified by an authorized STIHL servicing dealer using original STIHL replacement parts.
Instruction Manual - Page 64
...equipment engines must be repaired or replaced by STIHL Incorporated
STIHL Incorporated warrants to the ultimate purchaser and each subsequent purchaser that STIHL Incorporated may be designed, built and equipped, at 1-800-4678445 or you retain all applicable regulations. Coverage by STIHL Incorporated free of time, not to conform with U.S.
MS 341, MS 361, MS 361 C
63 Also...
Instruction Manual - Page 65
... effect of "repair or replace as required maintenance will charge you for that adversely affect performance and/or durability, and alterations or modifications not recommended or approved in writing by STIHL Incorporated,
and
: replacement of parts and other engine components caused by STIHL Incorporated at and after the first scheduled replacement point.
64
MS 341, MS 361, MS 361 C STIHL...
Stihl MS 341 Reviews
Do you have an experience with the Stihl MS 341 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Stihl yet.
Earn 750 points for your review!