Genie ChainLift 800 Support and Manuals
Get Help and Manuals for this Genie item
View All Support Options Below
Free Genie ChainLift 800 manuals!
Problems with Genie ChainLift 800?
Ask a Question
Free Genie ChainLift 800 manuals!
Problems with Genie ChainLift 800?
Ask a Question
Most Recent Genie ChainLift 800 Questions
I Have A Model Isd 995 That Has The Green Light Blinking 2 Times.
I have disconnected the ribbon cable and reinserted it, it cycles up and down then wont operate agai...
I have disconnected the ribbon cable and reinserted it, it cycles up and down then wont operate agai...
(Posted by sramsland 7 years ago)
Popular Genie ChainLift 800 Manual Pages
Owner's Manual - Page 1
... Genie Company PN# 37026500123, 5/15/2009
ALWAYS AT YOUR COMMAND
Models 2022/2024/2042 GARAGE DOOR OPENERS
Includes: 2-Bulb Light System Wall Console
Includes INTELLICODE® Remote Control Safe-T-Beam® System must be installed to close door. Homelink® and Car2U® compatible
For Answers and Assistance:
1.800.354.3643
or visit www.geniecompany.com SAVE THIS MANUAL...
Owner's Manual - Page 2
..., will result in this manual. WARNING: CoourldSererisouultsinInDjueryath
Do NOT try to remove, install, repair or adjust springs or anything to and identify different levels of opening while door is the safety alert symbol. CAUTION indicates a potentially hazardous situation which door spring parts are not pinched or near moving parts. IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL...
Owner's Manual - Page 3
... 9 LIGHT BULB AND LENS INSTALLATION 24 SAFETY INSTRUCTIONS 25 MAINTENANCE & TROUBLESHOOTING 10 ROUTINE MONTHLY MAINTENANCE 25 WIRING DIAGRAM 26 TROUBLESHOOTING GUIDE - Lighted Wall Control* Operates door opener from inside garage. (Refer to Section 10.) Safe-T-Reverse® Contact Reversing System. OPENER FEATURES INTELLICODE® Rolling Code Security System. Automatically stops and...
Owner's Manual - Page 4
... jams, binds, is possible that your opener. (Refer to Section 1.)
Remove
Remove
7 Insure that ceiling joists may not be installed within code specifications. Insure that you read and fully understand all information and instructions contained herein before choosing a "Do-it repaired or adjusted by a trained door system technician. WARNING
4 Is your garage does not have it -yourself...
Owner's Manual - Page 6
...;nea y estire la camisa de plástico fuera de la cadena o lazo plástico de la correa. Follow instructions in the Installation Manual for easy access. If door fails to reverse door, repair or replace opener.
Place next to wall control.
©1999
Entrapment Warning Label
Safe-T-Beam® Source with wire (Red LED)
Safe-T-Beam...
Owner's Manual - Page 9
...door system technician make inoperative all locks connected to the garage door before installing the opener.
3. Remove all moving parts of power until opener is fully assembled and instructed to do so.
6. Install...FOLLOW ALL SAFETY, INSTALLATION AND OPERATION INSTRUCTIONS. (If you have questions or do not understand an instruction, call The Genie Company or an authorized Genie® Dealer.)...
Owner's Manual - Page 12
2 OPENER INSTALLATION
HEADER AND DOOR MOUNTING BRACKETS:
WARNING Header bracket must be above header for garage door opening, you need to add a "mounting surface." Do NOT fasten to wall studs on header & above door
(Fig. 2-1, c). - a) Mark center of garage door (one-half overall width) on pressure treated lumber. 2. This is location for header bracket. door at each screw hole mark. - a) -...
Owner's Manual - Page 16
... 321
wire guide
6 54 3 21
+- Controls door opener lights from
2 inside garage - ero. Staples should remain in the center of wire (Fig. 3-2 on wall near Wall Control.
Securely fasten wires.
• Securely fasten wires to ceiling and
wall using insulated staples provided.
- Split and strip ends of this manual. -
Vacation Locking Switch - Open and closes door from...
Owner's Manual - Page 17
...; Source (Red LED) and Sensor (Green LED). • If garage has only one garage door.
- Red
Green
3a.
PN# 37026500123 05/15/2009
17 If not: a) Mounting bracket extensions are available through an authorized Genie® Dealer. Preventing crossed signals is beyond door, tracks or any door hardware. -
Use insulated staples.
- Check if brackets extend out from...
Owner's Manual - Page 19
...-T-Beam® is installed improperly, press and hold the Wall Control "open /close .
3. All work performed by aiming the unit directly at least 6" in order to prevent personal injury and damage to eliminate the problem first. WITH POWER SUPPLIED: Check Safe-T-Beam® alignment (Fig. 5-4). • Insure that no part of door or its fully...
Owner's Manual - Page 20
... the desired position, press and release the "Close SET Limit" SET button. Belt Connector
Latch Movement
FIG. 6-2 Engage Chain/Belt Connector to move the door slightly in Section 10. LED Indicator Light
Open
Open
Set Limit
Travel Limit Button
Up Force
OPEN Control
Adjustment
To Garage Door
SET
LEARN MANUAL LIMIT FORCE
SET
A) ENGAGE CHAIN/BELT CONNECTOR TO CARRIAGE 1. Once the...
Owner's Manual - Page 23
... protection against harmful interference in a residential installation. Red LED will move in your local dealer. Operating. • Press remote button once. - These limits are designed to operate 2 doors.
Remote is connected. • Consult your car owner's manual. NOTE: For remote control locate Box 3.
1a. To Garage Door
SET
LOST OR STOLEN REMOTE 1.
Door will go out.
Owner's Manual - Page 25
... contact Genie® customer service at the center of garage door opening. • Close door by using this release with the door open. If door moves quickly, CONTACT A TRAINED DOOR SYSTEM TECHNICIAN. • Close the door. • Pull emergency release knob towards the opener to repair or adjust door springs or any hardware, and DO NOT OPERATE garage door automatically or manually if door...
Owner's Manual - Page 27
... in good repair, properly lubricated and balanced (See Maintenance section 10).
• Check "OPEN" limit setting (See section 6 ). • Check "OPEN FORCE" adjustment (See section 6 ). • WARNING: If you suspect a problem with the garage door hardware or springs, contact
an authorized Genie® Dealer or a trained door system technician, or contact The Genie Company at 1-800-35-GENIE...
Owner's Manual - Page 30
... warranty period (which is specifically limited to speak with a trained representative.
PURCHASER: INSTALLATION ADDRESS: DATE PURCHASED: OPENER MODEL: REMOTE CONTROL MODEL: DEALER NAME: DEALER ADDRESS...to Product installed in the Magnuson-Moss Warranty Act.
There are excluded and will supply the purchaser with replacement parts or, at 1-800-354-3643 to repairing or replacing, at its...
Genie ChainLift 800 Reviews
We have not received any reviews for Genie yet.