Troy-Bilt TB4BP Support and Manuals
Get Help and Manuals for this Troy-Bilt item
View All Support Options Below
Free Troy-Bilt TB4BP manuals!
Problems with Troy-Bilt TB4BP?
Ask a Question
Free Troy-Bilt TB4BP manuals!
Problems with Troy-Bilt TB4BP?
Ask a Question
Most Recent Troy-Bilt TB4BP Questions
Need Pull Cord For Backpack Blower Tb4bp
(Posted by fidelaguilar66 8 months ago)
What Is The Gap For Tb4bp Ec Troy Bilt Backpack Blower
What is the spark plug gap for troy bilt tb4bp ec Backpack blower
What is the spark plug gap for troy bilt tb4bp ec Backpack blower
(Posted by mcoulombeg 10 months ago)
What Is The Spark Plug Gap For A Tb554 Edger
What is the spark plug gap setting for a TB 554 edger
What is the spark plug gap setting for a TB 554 edger
(Posted by Stratman2 2 years ago)
What Spark Plugs Are Used To Replace The Oem Plugs...also What Is The Oem Plug
i cant seem to find any info on the web for these troybilt weedwackers and blowers..any info would h...
i cant seem to find any info on the web for these troybilt weedwackers and blowers..any info would h...
(Posted by Yz4lifeperformance 2 years ago)
Dose The Valve Need Adjustnts
(Posted by Anonymous-167398 3 years ago)
Troy-Bilt TB4BP Videos
Troy-Bilt® TB4BP EC Backpack Gas Leaf Blower (FULL SETUP)
Duration: 6:44
Total Views: 2,047
Duration: 6:44
Total Views: 2,047
Popular Troy-Bilt TB4BP Manual Pages
Operation Manual - Page 1
... the information for Safe Operation 2 Know Your Unit 5 Assembly Instructions 6 Oil and Fuel 8 Starting/Stopping Instructions 9 Operating Instructions 10 Maintenance and Repair Instructions 11 Cleaning and Storage 13 Troubleshooting 14 Specifications 15 Warranty Information 18 Parts List E18
P/N 769-03148C
Copy the model and parent part number here:
Copy the serial number here:
All...
Operation Manual - Page 2
... to install the Accessory Part #753-05297 Spark Arrestor ...position while starting position whenever pulling the starter rope. ...instructions before starting .
Never allow it requires replacement, ask your careful attention and understanding. The instructions or warnings they give are no sparks or flames. Please read these requirements could subject you of information or instructions...
Operation Manual - Page 3
...; To reduce fire hazard, replace faulty muffler and spark arrestor. Do not use in cold weather has been linked to stop the engine immediately and check for this tool. These parts get extremely hot from operation, even after each use them . OTHER SAFETY WARNINGS
• Always disconnect the spark plug before repairing damage. Clean after the...
Operation Manual - Page 5
KNOW YOUR UNIT
Suspension System Shoulder Support
Choke Lever
Air Filter Cover
Starter Rope Handle
Gas Cap
Shoulder Support Buckle
Trigger Lock Throttle Grip
Trigger
Stand
Waist Support
Clip
Waist Support
Throttle Cables
Blower Tube
Primer Bulb
Muffler
Nozzle
Gas Tank Oil Fill Plug
Elbow Tube 5
Operation Manual - Page 7
...: To avoid serious personal injury, make
sure that the blower tubes are locked in place or firmly installed.
7 B
Throttle Cables
A
Hose Clamp
Upper Blower Tube
On/Off Switch Throttle Grip
Fig. 7
2. Align the throttle grip with the slot closest to
adjust. ASSEMBLY INSTRUCTIONS
The completed blower tube should look like Figure 6.
WARNING: Do not rotate the...
Operation Manual - Page 8
.... In order to avoid damage to Checking the Oil Level. Keep sparks and open flames at least 30 ft. (9.1 m) from the area. Never operate the unit without
oil. Wipe up any oil that may have
spilled and reinstall the oil fill
plug. it is extremely flammable. Check oil before starting the engine. It can keep fuel from the...
Operation Manual - Page 9
...or firmly installed.
Fig. 14
Trigger Lock
On/Off Switch
Trigger
Fig. 15
Starter Rope
Fig. 16 9 HOT RESTART: If the unit is locked in the starting (Fig. 15). 5. STOPPING INSTRUCTIONS
1. Primer Bulb
STARTING INSTRUCTIONS
1. Place the choke lever in the crankcase. IF... STARTING/STOPPING INSTRUCTIONS
WARNING: Operate this unit only in smooth and rapid pulls to start engine...
Operation Manual - Page 11
... poor performance or can result in the cleaning process for the port. Replace the oil fill plug. Squeeze the filter to ensure that may be a part of oil and recheck. NOTE: Some maintenance procedures may result from initial use to a Troy-Bilt or other qualified service dealer. FREQUENCY Before using
Every 25 hrs Every 50 hrs
MAINTENANCE REQUIRED...
Operation Manual - Page 12
...spark plug from the cylinder head by an authorized service dealer.
12
Fig. 30
2. Remove the screw holding the rocker arm cover with a large flat blade screwdriver or Torx T25 bit (Fig. 31).
Pull the starter... around the spark plug. Clean dirt from around the rocker arm cover. An idle adjustment screw is at a high idle for a minute to Starting/Stopping Instructions.
2.
Clean...
Operation Manual - Page 13
.... Repair or replace damaged parts and tighten loose screws, nuts or bolts. Check alignment of children. Reinstall the spark arrestor screen, spark arrestor cover and screws. Drain all gasoline has been drained from the cylinder head by
turning a 5/8 in •lb (2.2-3.4 N•m).
10. Pull the starter rope slowly to Changing the Oil. Reinstall the spark plug. Thoroughly...
Operation Manual - Page 15
... 0.003-0.006 in. (0.076-0.152 mm) Spark Plug Gap 0.025 inch (0.635 mm) Lubrication SAE 30 Oil Crankcase Oil Capacity 3.04 oz (90 ml) Fuel ...Unleaded Carburetor Diaphragm, All-Position Starter Auto Rewind Muffler Baffled with Guard Throttle Manual Spring Return Fuel Tank Capacity 20 oz (591 ml)
*All specifications are based on the latest product information...
Operation Manual - Page 16
... standards. Warranty services or repairs will not reduce the warranty obligations of "Repair or Replace as a problem exists. The 2007 and later small off-road engines are additionally included if your warranty rights and responsibilities, you including diagnosis, parts and labor.
In California and the 49 states, new small off -road engine, but Troy-Bilt cannot deny warranty...
Operation Manual - Page 17
... instructions must be warranted for disallowing a warranty claim made in fact defective, provided that use of warranty coverage, it must be repaired or replaced by Troy-Bilt. CALIFORNIA EVAPORATIVE EMISSION CONTROL WARRANTY STATEMENT Your Warranty Rights and Obligations
The California Air Resources Board and Troy-Bilt LLC (Troy-Bilt) is pleased to the first scheduled replacement, the part...
Operation Manual - Page 18
... the applicable period of express written warranty above as to the parts as set forth in the United States, its option, repair or replace, free of original retail purchase for any Troy-Bilt product that is available, WITH PROOF OF PURCHASE THROUGH YOUR LOCAL AUTHORIZED SERVICE DEALER.
To locate your property and/or to others and their...
Operation Manual - Page 55
PARTS LIST
REPLACEMENT PARTS - MODEL TB4BP 4-CYCLE GAS BACKPACK BLOWER
7 5
6
24
14 17
5
3
4
20 2
2 1
13
12
19
17 16
15 17 18
15 14
14
21 22
23
9
10
8
11
Item 1 2 3 4 5 6 7 8 9 10 11 12
Part No. 753-05637 753-05638 753-05652 753-05639 753-05640 753-05641 753-05642 753-05655 753-05656 753-05647 753-05646 753...
Troy-Bilt TB4BP Reviews
We have not received any reviews for Troy-Bilt yet.