Ariens Pro Zoom 54 Support and Manuals
Get Help and Manuals for this Ariens item
This item is in your list!
View All Support Options Below
Free Ariens Pro Zoom 54 manuals!
Problems with Ariens Pro Zoom 54?
Ask a Question
Free Ariens Pro Zoom 54 manuals!
Problems with Ariens Pro Zoom 54?
Ask a Question
Popular Ariens Pro Zoom 54 Manual Pages
Owners Manual - Page 2
...separate manual specific to this manual for a replacement manual. Serial Number Label
Figure 1 • Record Unit Model and Serial numbers here.
• Record Engine Model and Serial numbers here. ENGINE MANUAL
The engine on the frame of safety instructions and controls during normal operation and maintenance. This manual is not available, contact the engine manufacturer for engine service...
Owners Manual - Page 5
Keep children and others away from rotating parts. Never carry children. If machine stops going uphill, stop unit and engine, set parking brake and remove key before use. Check interlock system per manual before making any inspections, repairs, etc.
1 2
4
DANGER !
+
+
3
+ += +
180996
Figure 2
OL3200
1. Disengage PTO, stop blade and back down and behind before you adjust or...
Owners Manual - Page 6
.... SAFETY RULES
Training
Read the Operator's Manual and other people. If the operator(s) ... to explain this material to follow these instructions could result in serious injury or death....stop unit and engine, set parking brake and remove key before making any inspections, repairs, etc.
6.
OL1803
....
• Disengage PTO, stop blade and back down slowly.
• Avoid sudden turns....
Owners Manual - Page 7
..., mufflers, and engine to service machine. Carefully release pressure from...
Stop equipment and inspect blades after striking objects or if...repairs before adjusting, cleaning or repairing.
MAINTENANCE AND STORAGE
Disengage drives, lower implement, set... properly. Be sure to support components when required.
Wear... stands to travel in moving parts. They are flammable and vapors...
Owners Manual - Page 8
... passengers.
Check the torque on all safety instructions to , or installed on the machine could damage engine components.
Use care when checking blades. Unplug charger before operating the Ariens mower. Keep Off
Only allow the operator on any decals that it is unsafe. Use of injury.
Only replace blades. Never straighten or weld them . If possible...
Owners Manual - Page 10
... while making adjustments while the engine is running or while it is hot. Use only genuine Ariens replacement parts. When making maintenance adjustments, keep hands, feet, and clothing away from all moving or rotating components.
Check the blade mounting nuts often to the hydraulic system. Fuel System
Handle gasoline with them and fuel on...
Owners Manual - Page 11
...Replacement Parts
Where replacement parts are inflated to perform the job.
Always wear protective clothing and eye protection when servicing...installation of unapproved parts and/or accessories or damages as it is charging can structurally weaken or deform the wheel. Do not attempt to service... maintenance on your Ariens dealer or a qualified repair service.
UNPACK UNIT
Remove...
Owners Manual - Page 12
... assembly from discharge shield.
2. Adjust the handles to operating position and engage seat lock. Seat Support Bar 2. Flat Washer 6. Rue Ring
Figure 4
Battery
The battery supplied with rubber boot.
2. Remove knob from Transport position.
3. SETUP INSTRUCTIONS
Ariens mowers are shipped partially assembled. IMPORTANT: During the unpacking of battery. The steering control levers may...
Owners Manual - Page 17
...set...Manual.
To release the lock, push the pedal forward, pull back on page 41 or refer to disengage mower blades.... CONTROL PANEL
PTO Engagement
Ignition Choke Switch Control
PTO
Throttle
Hour Meter
Figure 10
OL3245
Ignition Switch
Operate the ignition switch with inside wheel while moving the outside wheel slowly forward. NOTE: The engine will not start, see Troubleshooting...
Owners Manual - Page 20
... set parking brake 3. Improperly installing or using ROPS kits can be pinned in a wellventilated area. If damage does occur, contact your Dealer and replace all ROPS safety rules in the owner/operator manual and in use of steering control. Ariens ..., do not run the starter more minutes for detailed instructions. 4. It must be straightened or used and tightened to tip backwards.
Owners Manual - Page 27
...manual.
Tipping Seat Forward
To lower the seat back down very quickly once the seat lock lever is fully raised and locked before beginning service on the seat slightly and pull the seat support...battery and the hydraulic reservoir. SERVICE AND ADJUSTMENTS
WARNING: AVOID INJURY.
Raise the seat to achieve required level. Lift on seat to serious engine problems if oil is between the ...
Owners Manual - Page 31
... a level service, put the steering control levers in its terminals clean. Use only the same size fuse as needed.
6. The second is broken.
3. Both are two fuses on the opposite end of Magnesia, beaten egg or vegetable oil.
Clean terminals and battery cable ends with your Ariens mower. Replace battery. (See Installing the Battery...
Owners Manual - Page 38
...and make sure all belt guards are normal. WARNING: Most service work requires the engine to be mowed is cleared of ...the belt(s) to the highest setting. Lower the floor pan.
DO NOT use genuine Ariens belts.
Replace the belt when the belt ...and support it in the transport position. Install a new drive belt, making sure it is tensioned and ready for wear. GB - 38 Blade
Small ...
Owners Manual - Page 41
... Replace blades in Cutting Swath
TROUBLESHOOTING
PROBABLE CAUSE
CORRECTION
1. Deck not level.
3. Adjust height of deck.
1. Clean underside of balance.
3. PROBLEM
Excessive Vibration
Uneven Cutting Height
Blades Wear Too Fast Not Cutting Clean
Streaking or Windrow Conditions in sets of three.
1. Blades installed upside down .
1. Blades out of deck. 6. Replace...
Owners Manual - Page 45
...- in . (cm)
55.5 (141)
61.1 (155.2)
Height - in . (cm)
1 - 6 (2.54 - 15.24)
Cutting Height Increments - in . (cm)
24 x 12-12, 4-Ply
Front Tire Pressure -... - in . (cm)
13 x 6.50-6 Caster
Rear Tire Size - SPECIFICATIONS
Model Number
992806
992807
Model
Pro Zoom 54
Pro Zoom 60
Engine
Kawasaki
Engine Model Number
FX751V
Engine Displacement - in . (cm)
.25 (.6)
GB - 45...
Ariens Pro Zoom 54 Reviews
Do you have an experience with the Ariens Pro Zoom 54 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Ariens yet.
Earn 750 points for your review!