Hikvision DS-2CD2212-I5 Support and Manuals
Get Help and Manuals for this Hikvision item
View All Support Options Below
Free Hikvision DS-2CD2212-I5 manuals!
Problems with Hikvision DS-2CD2212-I5?
Ask a Question
Free Hikvision DS-2CD2212-I5 manuals!
Problems with Hikvision DS-2CD2212-I5?
Ask a Question
Hikvision DS-2CD2212-I5 Videos
Demo Camera IP HIKVISION DS 2CD2212 I5 xem ban ?êm
Duration: 1:07
Total Views: 33
Duration: 1:07
Total Views: 33
HikVision DS-2CD2212-I
Duration: :05
Total Views: 482
Duration: :05
Total Views: 482
IP ??????????? ???????? Hikvision DS-2CD2212-I5
Duration: :29
Total Views: 7
Duration: :29
Total Views: 7
?????? ????? DS-2CD2212-I5 - 4??, ??? ?????????? ?????? DS-2CD2212-I5. Testing HikVision CCTV camera
Duration: 2:14
Total Views: 1,194
Duration: 2:14
Total Views: 1,194
Popular Hikvision DS-2CD2212-I5 Manual Pages
User Manual - Page 5
...problems caused by a qualified service person and should conform to all the local codes.
Please install... models) according...service center. User Manual of Network Camera
Safety Instruction
These instructions are intended to ensure that the ceiling can support more than 50(N) Newton gravities if the camera is divided into the power supply circuit for problems caused by unauthorized repair...
User Manual - Page 16
...supports the PPPoE auto dial-up after rebooting the camera. Refer to a modem. Configure the DDNS settings in order to better protect your product.
4. In the router, set the PPPoE user name, password and confirm the password. Apply a domain name from the DDNS provider (E.g. User Manual of strong passwords...function. You need to solve the problem.
15 Please call the router ...
User Manual - Page 26
... and you can enable the WPS function.
Note: Support of this mode is never easy.
Choose the connection...wireless connection. User Manual of Network Camera
4.2 Easy Wi-Fi Connection with WPS function
Purpose: The setting of the WPS connection...avoid the complex setting of the encrypted connection between the device and the wireless router. WPS (Wi-Fi Protected Setup) refers to ...
User Manual - Page 28
... Mode 2. User Manual of wireless network interface controller is 120 seconds. 1. If the PIN code is generated from the router side, you should enter the PIN code you can generate the PIN code on the camera side. Choose Use route PIN code. Enter the code to the router.
4.3 IP Property Settings for the PIN code is 192.168...
User Manual - Page 32
... PTZ control, the camera connected to the network must support the PTZ function or a pan/tilt unit has been installed to the camera. Turn on the Configuration > Local Configuration page. Please properly set on /off microphone. Turn on RS-485 settings page referring to Section 7.2. Manually capture the picture. Turn on and adjust volume /Mute...
User Manual - Page 33
User Manual of pan/tilt movements
5.4.2 Setting / Calling a Preset
Setting a Preset: 1.
Light on/off
Wiper on/off Auxiliary focus ...Table 5-2 Descriptions of PTZ Control Panel
Icon
Description
Zoom in the relative positions.
For the cameras which support lens movements only, the direction buttons are
invalid. Notes:
There are 8 direction arrows in the live ...
User Manual - Page 40
... before you operate the camera over network. Steps: 1. Enter TCP/IP Settings interface:
Configuration > Basic Configuration > Network > TCP/IP Or Configuration > Advanced Configuration > Network > TCP/IP
Figure 6-6 TCP/IP Settings 2. The camera supports both the IPv4 and IPv6. Configure the basic network settings, including the NIC Type, IPv4 or IPv6
Address, IPv4 or IPv6...
User Manual - Page 48
User Manual of the LAN. Please apply and register a user name and password for all functions and network devices.
It enhances the security level of Network Camera
6.3.6 Configuring 802.1X Settings
Purpose: The network camera supports IEEE 802.1X standard. Check the Enable IEEE 802.1X checkbox to the network. When devices connect to this...
User Manual - Page 49
...the settings to take effect.
6.3.8 Configuring UPnP™ Settings
Universal Plug and Play (UPnP™) is a networking architecture that of the router or the switch. 4. User Manual of... settings. Click Save to save the settings. Configure the QoS settings, including video / audio DSCP, event / alarm DSCP
and Management DSCP. Enter the user name and password to the Differentiated Service Code...
User Manual - Page 50
.... Note: The wireless dial function requires the support of Enable to enable the wireless dial settings. 3. Auto and Manual are configured.
49 If Auto is selected, you can set the offline time and manual dialing parameters.
2) Set the access number, user name, password, APN, MTU and verification protocol. You can set the arming schedule for dialing; With the...
User Manual - Page 54
...Check the checkbox to send
53 Configure the following settings:
Sender: The name of Network Camera
set the IPv4 Address, IPv4 Subnet Mask, IPv4 Default...TCP/IP port for detailed information. 2. User Manual of the email sender. Enter the Email Settings interface: Configuration > Advanced Configuration > Network > Email
Figure 6-22 Email Settings 3. Sender's Address: The email address of ...
User Manual - Page 61
...it is required. Video Quality: When bitrate type is updated and it maintains image quality throughout. The frame rate is.... User Manual of the H.264/AVC standard. Max. Note: The supported video encoding may not be so satisfied. SVC: Scalable Video Coding is to...the network bandwidth is set to 32~16384 Kbps. Profile: Basic profile, Main Profile and High Profile for coding are selectable, and ...
User Manual - Page 71
.... Note: The settings saved automatically if any parameter is changed.
70 User Manual of the switch. 2. Day/Night Scheduled-Switch
Day/Night scheduled-switch configuration interface enables you to the actual camera model for day mode.... Interface Steps: 1. Note: The detailed information of the camera supports CVBS, SDI, or HDMI output. Click Day tab to the day
mode and night mode.
User Manual - Page 159
... enter the service settings interface. Set the RS-485 parameters and click Save to the actual demands.
158 For the cameras support IR LED, ABF (Auto Back Focus), Auto Defog, or Status LED, you can go to the hardware service, and select to enable or disable the corresponding service according to save the settings. User Manual of Network...
Data Sheet - Page 1
...
CB130 Junction Box
Order Model DS-2CD2212-I5
104.8mm(4.13")
DS-2CD2212-I5
Camera
Image Sensor
1/3" progressive scan CMOS
Minimum Illumination 0.01 lux @ ƒ/1.2, AGC on )
Weatherproof Rating IP66
EXIR Range
Approximately 50 meters
Dimensions
105 mm × 104.8 mm × 263.1 mm (4.13" × 4.13" × 10.38")
Weight
950 g (2.09 lbs)
Hikvision USA Inc., 908...
Hikvision DS-2CD2212-I5 Reviews
We have not received any reviews for Hikvision yet.