Kenwood KDC-132CR Support and Manuals
Get Help and Manuals for this Kenwood item
View All Support Options Below
Free Kenwood KDC-132CR manuals!
Problems with Kenwood KDC-132CR?
Ask a Question
Free Kenwood KDC-132CR manuals!
Problems with Kenwood KDC-132CR?
Ask a Question
Popular Kenwood KDC-132CR Manual Pages
Instruction Manual - Page 1
... the unit, in the space provided below. Refer to read through this instruction manual. For your Kenwood dealer for information or service on the warranty card, and in the spaces designated on the product. KDC-132 KDC-1032 KDC-132CR
CD-RECEIVER
INSTRUCTION MANUAL
Take the time to the model and serial numbers whenever you obtain the best performance from your...
Instruction Manual - Page 2
...features
Power Selecting the Source Volume Attenuator System Q Audio Control Audio Setup Speaker Setting Clock Display Adjusting Clock Theft Deterrent Faceplate
Tuner features
Tuning Tuning ...Play Random Play
3 Accessories/ Installation Procedure 15
4 Connecting Wires to Terminals 16
5 Installation
17
6 Removing the Unit
19
7 Troubleshooting Guide
20
Specifications
22
11 13
2 | English
Instruction Manual - Page 3
...installed and used in the instruction manual. This equipment may cause harmful interference to this equipment may cause harmful interference unless the modifications are expressly approved in accordance with the instructions...the product relating to Part 15 of the FCC Rules. However, there is made. KENWOOD CORPORATION 2967-3, ISHIKAWA-MACHI, HACHIOJI-SHI TOKYO, JAPAN
KENWOOD CORP. The user ...
Instruction Manual - Page 4
...water splashing. (Faceplate case : KDC-1032/ 132CR only) • To prevent ...equipment. • When replacing a fuse, only use your Kenwood dealer. Also avoid places ...with Canadian ICES-003. Using a fuse with the wrong rating may not allow CDs to evaporate. Do Not Load 3-in a spot exposed to a negative 12V
DC power supply. • Do not install...
Instruction Manual - Page 5
... the Unit If the faceplate of this manual are examples used to the unit may affect its mechanical parts. Wiping the faceplate with a dry soft...more clearly how the controls are used. Notes
• If you experience problems during installation, consult your Kenwood dealer.
• If the unit fails to factory settings when the Reset button is pressed. English | 5 If the faceplate ...
Instruction Manual - Page 6
...-RW are not round cannot be used • CDs that are easier to your CD-R/CD-RW writing software, and your CDR/CD-RW recorder instruction manual.)
Burrs
CD storage
• Do not place CDs in direct sunlight (On the seat
or dashboard etc.) or where the temperature is
high.
• Store...
Instruction Manual - Page 8
... source to set on the (page 8). Each time you press the knob, the item to adjust
Press the [SRC] button.
2 Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
Each time you press the knob, the item to be adjusted alternates between the items shown in audio control replace the...
Instruction Manual - Page 9
... Clock
1 Enter Standby
Press the [SRC] button. Select the "STBY" display.
2 Enter Speaker Setting mode
Press the [VOL] knob.
3 Select the Speaker type
Turn the [VOL] knob.
speaker...2 seconds. Speaker type OFF For 5 & 4 in. Each time you turn the knob, the setting alternates between the settings shown in . Adjust the minutes Push the Control knob towards [FM] or [AM]. Clock Display
Press...
Instruction Manual - Page 10
General features
Theft Deterrent Faceplate
The faceplate of the KDC-1032/ 132CR)
• Do not expose the faceplate and the faceplate case to direct sunlight or excessive heat or humidity.
The faceplate unlocks, allowing you to detach ...
Instruction Manual - Page 11
...or down band
Push the Control knob towards [FM] or [AM]. Tuning Mode
Choose the tuning mode.
Normal manual tuning control.
• During reception of the stations in the table below. Press the Control knob. Search in ...shown in the Preset memory. Preset station seek "AUTO 2" indicator
Manual
- Select the "TUnE" display.
2 Select the band
Push the Control knob towards [4] or [¢].
Instruction Manual - Page 16
... tab. Battery To front left speaker
To front right speaker To rear left output (White) (KDC-1032 only)
FM/AM antenna input
Wiring harness (Accessory1)
If no connections are made, do ...Terminals
Rear left output (White) Rear right output (Red) Fuse (10A)
FRONT
Front right output (Red) (KDC-1032 only)
Front left speaker
To rear right speaker
Ignition wire (Red)
Car fuse box ACC
Battery wire ...
Instruction Manual - Page 17
...
ø5mm
8 mm MAX.
4
ø5mm
8mm MAX. If the unit is installed securely in the unit (two locations on each
side) with the vehicle mounting bracket and secure the unit ... | 17
Installation
non-Japanese cars
Metal mounting strap (commercially available)
Firewall or metal support
Japanese cars
1 Refer to the main unit.
• Damage may skip).
• During installation, do not...
Instruction Manual - Page 20
...replace the fuse with one side. ☞ Center the fader and balance settings.
✔ The input/output wires or wiring harness are low. ☞ Turn up the Volume offset, referring to the section on .
20 | English Troubleshooting Guide... can 't switch to one with the same rating.
? Before calling service, first check the
following table for when in the car. ☞...problems.
General
?
Instruction Manual - Page 21
...):
The CD player section is quite dirty. The messages shown below display your nearest service center. E-04:
The CD is not operating properly. ➪ Reinsert the CD.
E-99:
The ...unit is upside- Disc source
? If the
"E-99" code does not disappear, consult
your systems condition. down.
The CD is malfunctioning for the specified disc....
Instruction Manual - Page 22
... : 10 Hz - 20 kHz
Total harmonic distortion (1 kHz) : 0.01 %
Signal to change without notice.
Specifications
Specifications subject to Noise ratio (1 kHz) : 93 dB
Dynamic range : 93 dB
Channel separation : 85 dB
Audio section...(11 - 16V allowable) : 14.4 V
Current consumption : 10 A
Installation Size (W x H x D) : 182 x 53 x 155 mm 7-3/16 x 2-1/16 x 6-1/10 inch
Weight : 2.9 lbs (1.30 kg)
22...
Kenwood KDC-132CR Reviews
We have not received any reviews for Kenwood yet.