Mackie FRS-2800 Support and Manuals
Get Help and Manuals for this Mackie item
View All Support Options Below
Free Mackie FRS-2800 manuals!
Problems with Mackie FRS-2800?
Ask a Question
Free Mackie FRS-2800 manuals!
Problems with Mackie FRS-2800?
Ask a Question
Most Recent Mackie FRS-2800 Questions
Clipping Signals
I have been used a Mackie 2800 for a few years but recently the output sound got interrupted. I turn...
I have been used a Mackie 2800 for a few years but recently the output sound got interrupted. I turn...
(Posted by phongsouthernstar 5 years ago)
Mackie FRS-2800 Videos
The Mackie MixBusters: FRS-2800
Duration: 7:28
Total Views: 13,692
Duration: 7:28
Total Views: 13,692
Popular Mackie FRS-2800 Manual Pages
Owner's Manual - Page 1
... ©2007 "MACKIE", AND THE RUNNING MAN FIGURE ARE TRADEMARKS OF LOUD TECHNOLOGIES, INC. AND ICES-003, FOR CANADA.
SPEAKER OUTPUTS
PIN
PIN
PIN
1+ 1
BRIDGED
1+ 2+
1+ 1
PIN
CH
2
2+ 2
1+ 1
CH
1
FILTER
SUBSONIC @ 30Hz
CLIP LIMIT AMP MODE FRS Series
TWO CHANNEL POWER AMPLIFIERS FRS•1300, FRS•1700, and FRS•2800
OWNER'S MANUAL
FRS•2800
FAST RECOVERY...
Owner's Manual - Page 3
... SPECIFICATIONS 16 BLOCK DIAGRAM 17 DIMENSIONS 18
LIMITED WARRANTY 19
Need help with your new FRS amplifier?
• Visit www.mackie.com and click Support to find: FAQs, manuals, addendums, and user forums.
• Email us at: techmail@mackie.com. • Telephone 1-800-898-3211 to 5 p.m. POWER 8 2. VENTILATION 8 3. LEVEL CONTROLS 8 REAR PANEL FEATURES 9 5. THRU OUTPUTS 9 10. AMP...
Owner's Manual - Page 4
... channels on troubleshooting and repair.
This icon marks information that is fully protected against permanent damage caused by preventing the amplifier from being overloaded. FRS SERIES AMPLIFIERS
Introduction
Congratulations on connectors.
The amplifier can operate in three powerful models, with continuous power @ 4 ohms bridged of your own good, read these instructions to...
Owner's Manual - Page 5
... box specifically designed to both level controls on the amplifiers last.
4. Note: 4 ohms is used for each channel are wired as follows: 1+ = hot (+ speaker terminal) 2+ = cold (-
Using balanced cables, make the changes, turn the power back on . signal source to your signal source is used in bridge mode. 5. Owner's Manual
On the rear panel, set...
Owner's Manual - Page 6
... COMPLIES WITH PART 15 OF THE FCC RULES FOR THE U.S. SPEAKER OUTPUTS
PIN
PIN
PIN
1+ 1
BRIDGED
1+ 2+
1+ 1
PIN
CH
2
2+ 2
1+ 1
CH
1
??? Confused cat
Passive loudspeakers Mackie S215
Passive loudspeakers Mackie S215
FILTER
SUBSONIC @ 30Hz
CLIP LIMIT AMP MODE
AMP MODE SWITCH MONO
CH 1 AND CH 2 PLAY THE SAME
Bridged mono
FRS•2800
FAST RECOVERY POWER AMPLIFIER
1
OL -3 -6 -9 -20...
Owner's Manual - Page 7
...
CLIP LIMIT AMP MODE
AMPLIFIER END
1-
2+
1+
2- FOUR-CONDUCTOR SPEAKER WIRE
TO FIRST SPEAKER INPUT
FROM "THRU" OUTPUT
AMP MODE SWITCH STEREO
TO SECOND SPEAKER INPUT
Passive Speaker (Mackie C300z)
CHANNEL 1
Crossover Cable (Pin 2+ to Pin 1-)
CHANNEL 2
1- REFER SERVICING TO QUALIFIED PERSONNEL.
: AVIS RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
THIS DEVICE COMPLIES WITH PART 15 OF THE...
Owner's Manual - Page 8
... the music are detented to make it easy to set the overall volume for the mixer (or other signal source), adjust the level controls on . This connects/disconnects the AC power to a gain of the switch will not light.
434
2
1
FRS•2800
FAST RECOVERY POWER AMPLIFIER
1
OL -3 -6 -9 -20 MAX SIG
2
OL
-3
-6
-9
-20
SIG
MAX
OO...
Owner's Manual - Page 9
... with your amplifier. NE PAS OUVRIR
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES FOR THE U.S.
POWER CORD SOCKET
This is a straight copy of the amplifier.
There are restricted then the amplifier may overheat and shut down the power transistors. The linelevel output is where you to connect balanced XLR plugs or 1/4" plugs. REFER SERVICING TO...
Owner's Manual - Page 10
... have already placed a compressor/limiter in bridged mono. Leave this switch on . NO USER SERVICEABLE PARTS INSIDE.
CLIP LIMIT
When engaged, this filter can reduce low-frequency stage noise (footsteps) and accidental microphone pops that low. FAST RECOVERY POWER AMPLIFIER
CHANNEL 2
BRIDGED
CHANNEL 1
: WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO...
Owner's Manual - Page 11
.... They also require 14.65" depth inside the rack, including the rear support brackets.
MAINTENANCE
THERMAL CONSIDERATIONS
The power amplifier is to be dangerous. Usually, your amplifier will be available for the heatsinks. Owner's Manual
General Precautions
AC POWER REQUIREMENTS
The amplifier's power cord should be plugged into it !
However, you do several volume...
Owner's Manual - Page 12
... jack? If it plugged in?
• Make sure the power cord is present.
• If the speakers are no user serviceable parts inside the amplifier may have blown. See next page about service.
12
FRS SERIES AMPLIFIERS
Troubleshooting
No Power
• Our favorite question: Is it sounds bad there, the problem is being over driven. If so, contact your mixer...
Owner's Manual - Page 13
... cable between the mixer and the amplifier.
To locate your system? Service for Mackie products is with your speaker cabling. As the music gets loud, the amp shuts down the signal source or the amp level controls.
• Can the amp breathe?
Owner's Manual
13 Poor Bass response
For warranty repair or replacement, refer to the signal source with...
Owner's Manual - Page 16
... Program:
@ 8 ohms 4.0 A
5.3 A
8.4 A
@ 4 ohms 6.0 A
7.4 A
10.8 A
@ 2 ohms 8.2 A
11.4 A
18.3 A
AC Power Requirements
U.S. FRS SERIES AMPLIFIERS
Appendix C: Technical Info
Specifications
Continuous Sine Wave Average Output Power, per channel, both channels driven, 20 Hz to 20 kHz
FRS•1300 FRS•1700 FRS•2800
2 ohms: 650 W
830 W
1300 W
4 ohms: 420 W
540 W
850...
Owner's Manual - Page 18
... mm
1.50 in/ 38 mm
3.50 in/ 88.9 mm
OO
FRS•2800
FAST RECOVERY POWER AMPLIFIER
1
OL -3 -6 -9 -20 MAX SIG
2
OL
-3
-6
-9
-20
SIG
MAX
OO
19.0 in/ 483 mm
FRS•1300 WEIGHT
21 lbs. (9.5 kg) FRS•1700 WEIGHT 21.5 lbs. (9.7 kg) FRS•2800 WEIGHT
22 lbs. (10 kg)
1.50 in/ 38 mm
14.65...
Owner's Manual - Page 19
...the original sales receipt is plainly written on behalf of the warranty period. D. This warranty does not extend to damage resulting from an authorized Mackie dealer for repair or replacement. I. A copy of the sales receipt with LOUD Technologies. This warranty provides specific legal rights and you call Mackie Technical Support, explain the problem and obtain a Service Request Number...
Mackie FRS-2800 Reviews
We have not received any reviews for Mackie yet.