Miele DA 289 Support and Manuals
Get Help and Manuals for this Miele item
View All Support Options Below
Free Miele DA 289 manuals!
Problems with Miele DA 289?
Ask a Question
Free Miele DA 289 manuals!
Problems with Miele DA 289?
Ask a Question
Popular Miele DA 289 Manual Pages
Operating and Installation manual - Page 1
en - US
M.-Nr. 07 782 280 Operating and Installation Instructions
Ventilation System DA 289-4
To prevent accidents and appliance damage, read these instructions before installation or use.
Operating and Installation manual - Page 2
Contents
IMPORTANT SAFETY INSTRUCTIONS Functional description Guide to the Ventilation System Operation Turning on the fan 10 Selecting the ... and air intake panel 18 Changing the light bulb 20 After Sales Service Installation instructions Caring for the environment Appliance dimensions Installation accessories Plywood backing Installation Dismantling 31 Air extraction Electrical connection
2
Operating and Installation manual - Page 3
...Miele.
~ b) Before servicing or cleaning the
appliance, switch power off at the service panel and lock the service disconnecting means to prevent power from being switched on to the service panel.
~ c) Be certain your appliance is intended for
residential use only. Read these instructions... odors only.
~ This appliance is suitable for
installation above gas or electric cooking surfaces.
~ This ...
Operating and Installation manual - Page 4
... be opened. Repairs and other parts of this manual. Heat oils slowly on low or medium settings.
~ b) Always turn the hood on when
cooking at high settings. Always
use cookware appropriate for the size of the cooking area.
~ e) Do not flambé or grill with an
open the housing as
described in the enclosed "Installation diagram" and...
Operating and Installation manual - Page 6
... hood with all applicable codes and standards, including fire-rated construction.
~ b) Sufficient air is not
given by the National Fire Protection Association (NFPA) and the American Society for
combustion and exhausting of gases through the flue (chimney of the appliance, (e.g. IMPORTANT SAFETY INSTRUCTIONS
Installation
,WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR...
Operating and Installation manual - Page 11
..." data.
11
The maximum air flow capacity is not stored within 4 minutes of programming, the hood will affect this value. Level 1 operates at 40% capacity Level 2 operates at 60% capacity Level... 3 operates at 80% capacity Level 4 operates at 100% capacity
^ To save the setting press the "Delay Shut Down" button. If the procedure is 625 cfm. Operation
Fan performance
If the...
Operating and Installation manual - Page 17
... TO PERSONS, OBSERVE THE FOLLOWING:
^ Glass surfaces can be cleaned with a mild solution of burns. cleaning agents containing soda, acids or chlorides,
Before cleaning or servicing the hood, disconnect it from the power supply, see "Important Safety Instructions".
,The halogen bulbs are very hot
when in addition to the general "Cleaning the casing...
Operating and Installation manual - Page 20
... Safety Instructions". Do not touch the bulb surface.
See the phone numbers on the back of its life. Cleaning and care
Changing the light bulb
,WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
Before changing the light bulbs, disconnect the hood from Miele's Technical Service Department...
Operating and Installation manual - Page 21
...the only Extended Service Contract in writing by Miele's Service department, Extended Service Contracts offered by other providers for Miele products will not be recognized by Miele.
MieleCare
(USA only)
MieleCare, our Extended Service Contract program, gives you the assurance of knowing that guarantees repairs by a Miele Authorized Service Provider using genuine Miele parts. These are shown...
Operating and Installation manual - Page 30
It must be installed. Failure to adequately support the weight as outlined on the "Installation diagram".
^ Make a cutting line 3" (76 mm) above and 3" (76 mm) below the outline of the retaining plate.
30 Tape the joints and refinish the wall.
^ Proceed to the enclosed "Installation diagram" to complete the installation.
^ Determine and mark the location of...
Operating and Installation manual - Page 32
... vent exhaust air into the appliance.
- Please read and follow the "IMPORTANT SAFETY INSTRUCTIONS" to prevent condensation dripping into spaces within walls or ceilings or in attics, crawl spaces or garages. Make sure all local building codes when installing the hood. The ducting should not be vented outside wall, a Telescopic Wall Vent can be...
Operating and Installation manual - Page 33
... and if possible directly above the exhaust outlet. When installing a condensate trap, ensure that it may need to be required to collect and evaporate any condensate which may also be insulated to reduce condensation.
33 Seek professional advice before connecting an exhaust hood vent to an active chimney, dryer vent, flue, or...
Operating and Installation manual - Page 34
...Instructions
This appliance must be plugged into an outlet that is performed.
^ Verify that have been investigated and found acceptable for connection to your power supply, please consult a licensed electrician or contact Miele's Technical Service Department. Improper grounding can result in strict accordance with ventilation hood... installation or repair work is properly installed and...
DA289 - Page 1
SPECIFICATION SHEETS 010405 Standard 110 Volt Outlet
Notes
• All installations must be done in accordance with local codes.
• 6" duct connects to scale.
O -
NOTE: Drawing is not to blower system inside chimney. Product Dimensions Decorator Wall Hood
DA289-3
E O
12 5/8"
9 7/8"
5 1/4"
Front Perspective
37 13/16" - 51 15/16"
22 3/16"
35 1/4"
Location Codes
E - 110 Volt ...
DA289 - Page 2
... - 14 3/8" for all surfaces
• Area behind mounting plates MUST be reinforced with a minimum of 1/2" plywood. Installation Dimensions Decorator Wall Hoods
DA289-3
Structural member
Ceiling Line
Mounting plate "B"
Mounting plate "C"
Mounting Holes
15 3/4 "
Area must be reinforced using a ... structural wall members
Center Line
NOTE: Drawing is not to scale. SPECIFICATION SHEETS 010405
Miele DA 289 Reviews
We have not received any reviews for Miele yet.