Poulan P3314WS Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan P3314WS manuals!
Problems with Poulan P3314WS?
Ask a Question
Free Poulan P3314WS manuals!
Problems with Poulan P3314WS?
Ask a Question
Popular Poulan P3314WS Manual Pages
User Manual - Page 2
... saw . justing or making repairs except carburetor adjustments. S Wear protective gear.
PLAN AHEAD S Read this manual. Careless or improper use of this tool can cause serious injury. WARNING! Contacting the guide bar tip with your
right hand. Because a chain saw . S Restrict the use can follow all safety rules, precautions, and operating instructions before using the chain saw...
User Manual - Page 3
... not make contact
with the exception of chain saw . S Stop the engine before operating a chain saw control. Always
replace bar, chain, hand guard, or chain brake immediately if it becomes damaged, broken or is intended for two-handed use an approved, marked container for an instant. S Use only Poulan accessories and replacement parts as non-fogging, vented goggles or face...
User Manual - Page 5
... sample of saw has a low kickback chain and bar as set by allowing contact of kickbacks when tested in accordance with distance between handles and "in - S Tip contact in
the event of the guide bar. Kickback Chain
Deflects kickback force and allows wood to gradually ride into your unit to the nearest authorized master service dealer. The...
User Manual - Page 6
....3- 96 Chain Saw Kickback Occupational Health and Safety
ASSEMBLY
Protective gloves (not provided) should be worn during assembly. WARNING: The engine exhaust
from the saw. 2. An anti-vibration system does not guarantee the avoidance of California Codes 4442 and 4443.
Always wear gloves when handling the chain. Computed kickback angle (CKA) Table
MODEL
P3314 / P3314WS P3314WSA
P3416...
User Manual - Page 7
... in the clutch drum sprocket.
8. Always check chain tension each time before you start the chain saw . The chain is sharp and can cause damage. Chains stretch during the first few times you use . Slide guide bar on clutch cover 4. Hold chain with chain already installed)
WARNING: Wear protective gloves
when handling chain.
This should allow the pin to tension...
User Manual - Page 8
.... Damaged chain must be repaired or replaced. Compare the illustrations with your unit to stop the engine.
While lifting tip of guide bar, tighten bar nuts securely with the location of guide bar, then turn adjusting screw 1/4 turn counterclockwise.
Using bar tool, roll chain around guide bar.
7. Save this manual for sag. DO NOT operate the saw sitting in...
User Manual - Page 9
...chain brake activates manually if the front hand guard is recommended. The chain brake is normal for a new chain to oil and fuel separation. CHAIN TENSION It is disengaged by smoke coming from heat and friction.
FUELING ENGINE
WARNING: Remove fuel cap slow-
Poulan...saw .
These oils will cause problems...instructions printed on unleaded gasoline. Bar and chain... are set by ...
User Manual - Page 10
... manual. allow engine to return to idle speed. Allow the engine to run for starting , start the engine hold the saw ...after running out of the chain saw firmly on Front Handle
IGNITION SWITCH
ON STOP
Choke Lever
1. To set automatically. Avoid contact with...pulled out to the OFF CHOKE position) and then following these instructions, please call 1- 800- 554- 6723. STARTING A WARM ENGINE...
User Manual - Page 11
... movement). Grip the rear handle with your grip on drive links, which can cause the tree to idle. Inspect the saw and repair or replace parts as the tree is equipped with the saw . S Allow the chain to the chain, bar, and engine. If you force the cut at night since you start , refer to stop the...
User Manual - Page 14
... tree as instructed in BUCKING WITHOUT A SUPPORT. S Keep the tree between you work.
Do not cut 1/3 of the way through
the limb.
MAINTENANCE SCHEDULE
Check: Fuel mixture level . . . . S Once a year, replace the spark plug, air filter,
and check guide bar and chain for wear. Undercutting could cause limbs to fall and pinch the saw After each...
User Manual - Page 15
.../STOP switch to be completely cleaned. Make sure engine stops;
Remove these burrs with a new one side or at an angle. LUBRICATION
Bar Oil Fill Cap
S See GUIDE BAR AND CHAIN OIL under the OP- Loosen 3 screws on the chain saw in gasoline or other flammable solvent to avoid creating a fire hazard or producing harmful...
User Manual - Page 17
... with the bar and to the outside. If the chain moves, idle is labeled T. ing during most of the chain. S Saw will be necessary if you require further assistance or are using.
S File enough to remove any of : S Air intake on the starter S Air guide plate S Fins on the flywheel S Cooling fins on one...
User Manual - Page 18
... ratio. We recommend that any damaged, broken, or worn parts. Replace any sharp object cannot accidentally cause injury. S Replace your unit for a period of time:
S Clean saw well out of the reach of the next season, use : S Allow the engine to your chain saw is blended with new one season to the gasoline in the fuel tank...
User Manual - Page 20
... N.A., Inc., warrants to the original consumer purchaser that each new Poulan brand gasoline chain saw is free from defects in material and workmanship and agrees to repair or replace under this warranty any defective gasoline chain saw . ducing purposes.
30 DAYS - In the event you have any emissions related part on your year 2010 and later small off --road...
User Manual - Page 21
... owner is certified to be warranted for re- WHERE TO GET WARRANTY SERVICE: Warranty services or repairs shall be per- MAINTENANCE, REPLACEMENT AND REPAIR OF EMISSION RELATED PARTS: Any Poulan approved
replacement part used in the instruction manual. should be provided without charge to the owner if the part is purchased. spondence to [email protected]. This engine...
Poulan P3314WS Reviews
We have not received any reviews for Poulan yet.