Smeg KT90BU Support and Manuals
Get Help and Manuals for this Smeg item
Popular Smeg KT90BU Manual Pages
Instruction Manual - Page 1
INSTRUCTION MANUAL
MANUEL D'INSTRUCTIONS
KD90-KD120-KD150-KT90-KT110--
Instruction Manual - Page 2
... that a qualified technician performs installation and adjustment operations .
The minimum distance between the cooker and the lower part of the hood must not be...BEFORE SERVICING.
WARNING -
EN
2
For General Ventilating Use Only. WARNING!
READ AND SAVE THESE INSTRUCTIONS. Read the instructions carefully before installing and/...
Instruction Manual - Page 3
.... 3) The fire department is properly installed and grounded. Grease should not be allowed to an exit. c) DO NOT USE WATER, including wet dishcloth or towels - WARNING - This appliance is equipped with a cord having a grounding wire with your back to accumulate on low or medium settings.
GROUNDING INSTRUCTIONS: This appliance must be plugged into...
Instruction Manual - Page 4
... using the
supplied screws (for type 1) or pushing (for installation. e) Fix the two supports/hooks to the supports/hooks (fig. 5) and level by tightening both wall anchors. Ducted mode or Recirculation mode installation:
Ducted mode: In the ducted mode, connect the motor outlet to the
cooker.
INSTALLATION INSTRUCTIONS:
The hood is supplied with a motor intake (Fig...
Instruction Manual - Page 5
... of not less than 3mm.
Block the chimneys by a qualified technician. Remove the chimney set, drill and fix the support racket to the mains supply, it before using the hood. The plug and fuse must ... supplied WITHOUT A PLUG. Place the chimneys group on the top side of wall anchors. . Install the active carbon filters as shown in accordance with the rating plate inside the hood. Put the...
Instruction Manual - Page 6
... a few minutes before starting cooking and keep it is recommended to start the hood, identify your type of control panel and follow the instructions:
SLIDER:
- OPERATING INSTRUCTIONS:
CONTROL PANEL:
In order to achieve the best performance, it on /off the hood's light. - Key (A) to turn on/off...
Instruction Manual - Page 7
... WARNING: When all the 4 LEDs blink at the same time (which is programmed to
clean/replace the filters .
When cleaning the steel of operation), the user is signalled by the blinking LED...hood, can also be a fire risk. Special attention should be given to use specific products, following their instructions. Note: An excess of grease in the same direction as affecting the performance of...
Instruction Manual - Page 8
...from the mains supply. B): press enough to find the carbon filter kit of your hood's model, remove one filter at least once every six months or more frequently, in the case of...the active carbon filter. Re-assemble the carbon and metal filters performing the above . CARBON FILTERS REPLACEMENT: (For recirculated version only)
The carbon filters can also be a fire risk. Spring-held ...
Instruction Manual - Page 9
...EN
9 a) Incandescent lamps: E14 - 40W 230V lamps. Install the new neon tube and put the glass framework back. ...
d) Neon lamp: 15/18W neon tube. According to remove the glass-supporting ring. To reach the neon tube, unscrew the glass framework screws. b)... , performing the same operations backwards. To replace the lamp, use a screwdriver to the model, the hood can be equipped with the...
Instruction Manual - Page 10
In the case of failure, please call Customer Service
0870 9909907 and provide the following data:
The model indicated inside the hood (fig. 7) Your full address Your telephone number Information on the kind of failure
EN
10 ...
Instruction Manual - Page 11
... European directive 2002/96/EC on the documents accompanying the product, indicates that this product, please contact your local city office, your household waste disposal service or the shop where you will help prevent potential negative consequences for the environment and human health, which could otherwise be treated as household waste...
Smeg KT90BU Reviews
We have not received any reviews for Smeg yet.