Stihl HS 46 Support and Manuals
Get Help and Manuals for this Stihl item
Stihl HS 46 Videos
Stihl HS46
Duration: :51
Total Views: 1,238
Duration: :51
Total Views: 1,238
Stihl HS 46 C-E hedge trimmer
Duration: 2:35
Total Views: 963
Duration: 2:35
Total Views: 963
Starting and stopping a petrol hedge trimmer ? HS 46
Duration: 1:05
Total Views: 28,894
Duration: 1:05
Total Views: 28,894
Stihl HS 46 C-E Hedge Trimmer Review
Duration: 4:33
Total Views: 44,051
Duration: 4:33
Total Views: 44,051
Popular Stihl HS 46 Manual Pages
Instruction Manual - Page 4
... a result, engineering changes and improvements are explained in different ways: N A bullet indicates a step or
procedure.
Depending on the model concerned, the following pictograms may be on the machine are made from those
2
HS 46, HS 46 C, HS 56 C English
Guide to Using this Manual
Pictograms
The meanings of the pictograms attached to or embossed on your special attention.
Instruction Manual - Page 5
...risk of your model. WARNING
Do not use it will cut you. When it is not in use (e.g. See the appropriate section of
HS 46, HS 46 C, HS 56 C
...parts and controls. It is a high-speed, fastcutting power tool with your body, it for other machines) exposing the operator to operate your instruction manual for cutting hedges, shrubs, scrub, bushes and similar material.
Different models...
Instruction Manual - Page 7
...
WARNING To reduce the risk of your instruction manual.)
WARNING
Gasoline is subjected to allow it...STIHL power tools, their use may, in fact, be extremely dangerous. Although certain unauthorized attachments are useable with the specific STIHL model... your STIHL servicing dealer. In case of burns and other ignition source, it is held in the horizontal position. HS 46, HS 46 C, HS 56 ...
Instruction Manual - Page 9
... easily in safe operating condition. HS 46, HS 46 C, HS 56 C
7 the throttle trigger must spring back from the fueling spot, outdoors only.
Keep the handles clean and dry at least 10 feet (3 m) from the l and n positions to the idle position. Replace damaged cutting blades before using the power tool. STIHL recommends that the spark plug boot...
Instruction Manual - Page 10
... you cannot set the correct idle speed, have your STIHL dealer check your fingers and thumbs around the handles. Special care must be colorless and odorless. For better footing, clear away fallen branches, scrub and cuttings.
WARNING
As soon as the engine is coated with a chemical substance (such as an active
8
HS 46, HS 46 C, HS 56...
Instruction Manual - Page 12
... or § 4443 of fire and burn injury, keep the area around the muffler clean. HS 46, HS 46 C, HS 56 C WARNING
To reduce the risk of the Public Resources Code to use any maintenance or repair work performed by your STIHL servicing dealer only. Remove excess lubricant and all debris such as pine needles, branches or leaves. Let...
Instruction Manual - Page 13
...Never repair damaged cutting attachments by welding, straightening or modifying the shape. Using the Unit
Cutting Season
Observe country-specific or...carburetor adjustment screws, after each use your power tool during other people's rest periods.
This may cause parts of the machine.
The solid jet of water may have similar requirements. lower the nose of children. HS 46, HS 46 C, HS...
Instruction Manual - Page 20
... the manual fuel pump bulb at least five times - Cleaning the Air Filter
If there is
properly connected. N Replace any damaged parts. N Check that the spark plug boot is a noticeable loss of ignition, until the engine runs.
Fuel tank run at idle speed so that all moving parts have to cool down firmly.
18
HS 46, HS 46 C, HS...
Instruction Manual - Page 22
... in this instruction manual Correct the problems that could...HS 46, HS 46 C, HS 56 C combination wrench). see "Specifications" N Use only resistor type spark plugs of fire and burn injury, use only spark plugs authorized by STIHL. See the chapter "Specifications...Install a new spark plug after approx. 100 operating hours or earlier if the electrodes are eroded/corroded. operating at part...
Instruction Manual - Page 29
...STIHL servicing dealers using genuine STIHL replacement parts. STIHL recommends that other repair work be identified by the STIHL part number, the { logo and, in this manual.
For repairs of any component of this unit should carry out only the maintenance operations described in this manual... carburetor with integral fuel pump
Fuel tank capacity:
9.5 oz (0.28 l)
Cutting Blades
HS 46
...
Instruction Manual - Page 30
... control system includes parts such as the carburetor and the ignition system.
A separate emissions control system warranty is performed at
www.stihlusa.com/warranty.html. Environmental Protection Agency (EPA) and STIHL Incorporated are pleased to the STIHL Incorporated Limited Warranty Policy, available at an authorized dealer), parts, and labor.
28
HS 46, HS 46 C, HS 56 C The equipment...
Instruction Manual - Page 31
..., please contact a STIHL customer service representative at no cost to a STIHL service center as soon as necessary" will be designed, built and equipped, at an authorized STIHL servicing dealer.
If you have any emissionrelated part on emission-related parts and must be provided without charge to communicate repair or recall information about your instruction manual.
As the small...
Instruction Manual - Page 32
...any of the following list specifically defines the emission-related warranted parts: - Choke (Cold Start Enrichment
System) (if applicable) - Maintenance Requirements
The maintenance instructions in writing by STIHL Incorporated,
and
N replacement of required maintenance,
N repairs improperly performed or replacements not conforming to STIHL Incorporated specifications that uses small off...
Instruction Manual - Page 33
...www.stihlusa.com
Coverage by the Emission Warranty Parts List (see below .
Any such part repaired or replaced under warranty must be warranted for the remaining warranty period.
2. A statement in the Emission Warranty Parts List (see above . Add-on or modified parts that is scheduled for replacement as the problem exists. STIHL Incorporated will begin on the date the utility...
Instruction Manual - Page 34
...-related parts and must be repaired or replaced by the failure of a warranted part still under the warranty must not be charged for the part.
4.
and #3,400,476)
AutoCut® FARM BOSS® iCademy® MAGNUM® MasterWrench Service® MotoMix® OILOMATIC®
32
HS 46, HS 46 C, HS 56 C If the part fails prior to the first scheduled replacement, the part must...
Stihl HS 46 Reviews
We have not received any reviews for Stihl yet.