Troy-Bilt TB225 Support and Manuals
Get Help and Manuals for this Troy-Bilt item
View All Support Options Below
Free Troy-Bilt TB225 manuals!
Problems with Troy-Bilt TB225?
Ask a Question
Free Troy-Bilt TB225 manuals!
Problems with Troy-Bilt TB225?
Ask a Question
Most Recent Troy-Bilt TB225 Questions
How To Replace Pull Cord
(Posted by Ehauser 7 months ago)
How To Adjust A New Carburetor?
(Posted by Chuckthekeyman 1 year ago)
Is The Throttle Cable Adjustable On The Troy Bilt Tb225 Tiller? Also What Would
is the throttle cable adustable on the tb225 tiller and also what would make the fuel not stay in th...
is the throttle cable adustable on the tb225 tiller and also what would make the fuel not stay in th...
(Posted by tw285j 1 year ago)
Tb 225. Runs Fine. Times Won't Turn
(Posted by Paulehollandjr 1 year ago)
Carb Settings For Tb225 Tiller, Pleaase.
(Posted by brucewithers3 1 year ago)
Troy-Bilt TB225 Videos
Troy-Bilt® TB225 Gas Cultivator (FULL SETUP)
Duration: 10:37
Total Views: 3,719
Duration: 10:37
Total Views: 3,719
Popular Troy-Bilt TB225 Manual Pages
Operation Manual - Page 1
... the time of printing. Operator's Manual
2-Cycle Gas Cultivator
TB225
TABLE OF CONTENTS Service Information 1 Rules for Safe Operation 2 Know Your Unit 5 Specifications 5 Assembly Instructions 6 Oil and Fuel Information 7 Starting and Stopping Instructions 8 Operating Instructions 9 Maintenance and Repair 10 Cleaning and Storage 13 Troubleshooting Chart 14 Warranty Information 16...
Operation Manual - Page 2
...to follow all fasteners are approached, stop the engine and allow it requires replacement, ask your state or local authorities for later use.
• Read the instructions carefully. Read the Operator's Manual and follow these instructions for regulations pertaining to these instructions before starting the unit. Replace parts that may be constructed, equipped and maintained for...
Operation Manual - Page 3
... operator and unit must be performed by a authorized service dealer.
• Before inspecting, servicing, cleaning, storing, transporting or replacing any other than the speed needed to an authorized service dealer for this manual, should be in daylight or good artificial light.
• Avoid accidental starting . Refer to instruct other debris that meet current ANSI Z87.1 standards...
Operation Manual - Page 4
...instructions. You may appear on steep slopes or inclines.
• PLACE RIGHT FOOT HERE Avoid accidental starting .
4 These parts get burned. ROTATING TINES CAN CAUSE SEVERE INJURY
WARNING: Stop the engine... the starting position whenever pulling the starter rope. Be in conjunction with other symbols or pictographs.
• READ OPERATOR'S MANUAL
WARNING: Read the operator's manual(s) and...
Operation Manual - Page 5
.... NO ASSEMBLY TOOLS REQUIRED
KNOW YOUR UNIT
Air Filter Cover
Muffler Spark Plug
Starter Rope Grip
Choke Lever
Throttle Control
Handlebar Knobs
Upper Handle On/Off Control
Primer Bulb
Tine Guard Gear Box
Fuel Cap Lower Handle Wheel Assembly
Tines
SPECIFICATIONS*
Engine Type Air-Cooled, 2-Cycle Displacement 25 cc (1.52 cu.
We reserve the...
Operation Manual - Page 6
...wheel height. Readjust the throttle cable and switch wires so they are smooth
and tight against the handlebar assembly.
ASSEMBLY INSTRUCTIONS
INSTALLING AND ADJUSTING THE WHEEL ...Handlebar Knobs
Fig. 2
Throttle Cable and Switch Wires
Handlebar Knobs
Fig. 3 6 Set the unit on the inside of the wheel
assembly before using the unit. Installing the Wheel Assembly
1.
Loosen...
Operation Manual - Page 7
...starting the engine.
Do not start the engine until fuel vapors dissipate.
1. NOTE: Do not overfill the tank. 4. Mixing the Fuel
CAUTION: For proper engine... instructions carefully for specific gas and oil mixing ratios. It has been proven that may explode. WARNING: Remove fuel...Position the unit with unleaded gasoline in your operator's manual • Use the fuel additive STA-BIL®...
Operation Manual - Page 8
... Oil and Fuel Mixing Instructions.
2. Continue to Position 3 (Fig. 5).
11. Pull the starter rope 3-5 times to start after 2 attempts, move the choke lever to start the engine.
9. Move the choke lever to squeeze the throttle control. Run the unit for ALL further steps.
The engine fails to Position 3 and squeeze the throttle control. If the engine is properly warmed up...
Operation Manual - Page 9
... and continue use extreme
caution when reversing or pulling the unit towards you are digging too deep or not deep enough, adjust them according to starting the engine. If necessary, adjust the tines as described in the Assembly Instructions section. 3. OPERATING INSTRUCTIONS
WARNING: Dress properly to
increase the engine speed. 4.
Hold the handlebar firmly with both...
Operation Manual - Page 10
... unit to cool. Remove the click pins from starting accidentally. Click Pin
Convex Side
Hubs
Hubs Click Pin
Direction of the shaft. 4. Always allow it to cool before servicing or repairing the unit. NOTE: All installation instructions are facing as the spark arrestor, muffler, carburetor, etc. Grasp the spark plug wire
firmly and pull the cap from the...
Operation Manual - Page 11
... (Fig. 9). 3. Swing the air filter cover to the Starting and Stopping Instructions. Air Filter Cover
Screen
Cover Screw Slots
Air Filter Fig. 9
Air Filter Housing
Hooks
Cover Screw Hole
IDLE SPEED ADJUSTMENT
WARNING: The tines may strip the screw. Release the throttle control and let the engine idle. Checking the fuel mixture, cleaning the air...
Operation Manual - Page 12
... spark plug.
Grit in . (0.635 mm)
Fig. 12
12 Install the spark plug in . (0.635 mm) (Fig. 12).
5. Tighten the spark plug with a replacement part #753-06193, Champion® RDJ7J or equivalent spark plug.
4. socket counterclockwise. NOTE: If using a torque wrench, torque to set the air gap at 0.025 in the cylinder head. WARNING...
Operation Manual - Page 13
...service it stalls. The unit is ready for any moisture with federal, state and local regulations. 2. Remove the spark plug and put 5 drops of the oil from the carburetor...Remove the fuel cap, tip the unit and drain the fuel into the cylinder. Start the engine and allow it to cool before storing. • Store the unit in a locked up area to run until it . Repair or replace damaged parts...
Operation Manual - Page 14
TROUBLESHOOTING
CAUSE ENGINE WILL NOT START Empty fuel tank Primer bulb wasn't pressed enough
Engine...throttle trigger and pull the starter rope Drain the fuel tank and add fresh, properly mixed fuel Replace or clean the spark plug
ENGINE...Replace or clean the air filter Drain the fuel tank and add fresh, properly mixed fuel Adjust the idle speed
ENGINE... or replace the air filter
THE ENGINE LACKS ...
Operation Manual - Page 16
... oral, except as a gift. Spark Plugs, Carburetor Adjustments, Filters B. Wear items - Troy-Bilt reserves the right to change or improve the design of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for any Troy-Bilt product that is repair or replacement of the product as to any...
Troy-Bilt TB225 Reviews
We have not received any reviews for Troy-Bilt yet.