Whirlpool WED9150WW Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool WED9150WW manuals!
Problems with Whirlpool WED9150WW?
Ask a Question
Free Whirlpool WED9150WW manuals!
Problems with Whirlpool WED9150WW?
Ask a Question
Most Recent Whirlpool WED9150WW Questions
What Did These Sell For New? What Can I Expect To Pay Used?
What did these sell for new? What can I expect to pay used?
What did these sell for new? What can I expect to pay used?
(Posted by lexgal 10 years ago)
Shuts Off And Damp Light Blinks.
(Posted by Anonymous-122695 10 years ago)
The Humidity Sensor Stays On And The Dryer Does Not Shut Off In Automatic Mode
(Posted by jeancaza 11 years ago)
What Is The Gallons Per Wash Of A Heavy Duty Cmercial Washer
(Posted by Anonymous-82369 11 years ago)
Dryer Will Start But The Heater Will Not Work
(Posted by sjenni 11 years ago)
Popular Whirlpool WED9150WW Manual Pages
Ventilation Specification - Page 1
...manual and on your local gas supplier.
This symbol alerts you and others are installing a gas dryer, it is the safety alert symbol. All safety messages will follow instructions...your appliance. ®
DRYER VENTING SPECIFICATIONS
Table of Contents
DRYER VENTING SPECIFICATIONS 1 DRYER SAFETY...1 INSTALLATION REQUIREMENTS ...4
Venting Requirements ...5 DRYER INSPECTION AND CLEANING 7
...
Ventilation Specification - Page 2
... information in this or any electrical switch; Installation and service must not exceed 3 feet.
2 In the State of Massachusetts, the following installation instructions apply: ■ Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by a qualified installer, service agency, or the gas supplier. do not use gasoline...
Ventilation Specification - Page 3
... absence of local codes, with the National Electrical Code, ANSI/NFPA 70.
3 SAVE THESE INSTRUCTIONS
IMPORTANT: The gas installation must be exposed to the weather.
■ Do not tamper with controls.
■ Do not repair or replace any part of the dryer or attempt any servicing unless specifically recommended in this Use and Care Guide or in published user-repair instructions that could...
Ventilation Specification - Page 4
... exhaust system: ■ Exhaust individual dryers to the central exhaust duct system
with your local building inspector for spacing requirements.
Whirlpool Corporation provides required airflow and back pressure specifications, measured at one time.
■ Consider moisture, lint and air temperature in the laundry area.
See the Installation Instructions that came with proper size...
Ventilation Specification - Page 5
....
Codes Agency Approvals
All Whirlpool electric dryer models, including "long vent dryers," that an architectural or HVAC engineering firm be consulted for the UL or CSA listing can be blocked after the dryer is 200 CFM. The designation for designing the dryer venting system. Refer to the "Plan Vent System" section of the Use and Care Guide for each model...
Dimension Guide - Page 1
... be in .2 (155 cm2)
1" (25 mm)
1" (25 mm)
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to the chart. Louvered doors with elbow.
Specifications subject to use the fewest number of the line.
Exhaust venting: Exhaust your dryer to an individual branch circuit. Hood styles: A & B are for...
Installation Instructions - Page 3
....
Optional Equipment: (Not supplied with dryer) Check local codes. Check existing electrical supply and venting. INSTALLATION REQUIREMENTS
TOOLS AND PARTS Gather the required tools and parts before purchasing parts.
Level
Caulking gun and compound (for your local building inspector. Parts needed :
Parts supplied (all models):
Flat-blade screwdriver
#2 Phillips screwdriver...
Installation Instructions - Page 4
... slope of 1" (25 mm) under entire dryer. spacing for companion appliances and clearances for ease of installation and servicing; Space must support dryer weight of 200 lbs. (90.7 kg). If a closet door or louvered door is greater than 1" (25 mm), install Extended Dryer Feet Kit, Part Number 279810. Add spacing on all sides of dryer to fully open.
If not level...
Installation Instructions - Page 5
... should also be exposed to reduce noise transfer.
■■ For closet installation, with a door, minimum ventilation openings in longer drying times. Closet installation (dryer only):
34" recommended (864 mm)
18" min. (457 mm)
3" (76 mm)
48 in.2 (310 cm2)
Back view: Electric
61/4"
(159 mm)
4" (102 mm)
3" (76 mm)
24 in.2 (155 cm2)
1" (25...
Installation Instructions - Page 6
... CFR, Part 3280 (formerly the Federal Standard for use an extension cord.
■■ If codes permit and a separate ground wire is used when the appliance is your dryer, you must conform to the neutral wire, see "Assistance or Service" section in your dealer. The wires that the electrical connection is adequate. Closet Installation (stacked washer and dryer...
Installation Instructions - Page 19
... or down, and check again for troubleshooting information.
19 q Check for certain part replacement or repair. See "Level Dryer". q Remove film on console and any dust.
q If you prefer to order. This dryer automatically runs an installation diagnostic routine at the start of /recycle all of your "Use and Care Guide". Door Reversal
If you have all packaging materials. For...
Owners Manual - Page 3
.... • Immediately call the fire department.
- The dryer must conform with the National Electrical Code, ANSI/NFPA 70.
3 IMPORTANT: The gas installation must be electrically grounded in accordance with the National Fuel Gas Code, ANSI Z223.1/NFPA 54. Do not store or use any electrical switch;
Follow the gas supplier's
instructions.
• If you cannot reach your building...
Owners Manual - Page 9
... if not properly installed. If the problem continues, call an electrician. If the dryer hasn't been used ? Separate the load items and restart the dryer. Electric dryers use ? Dryer displaying error message (WET indicator flashing)
■ WET indicator is flashing: If the WET indicator on the back wall of the dryer. Replace all parts and panels before servicing. Disconnect power...
Owners Manual - Page 11
... model number and serial number. Service must provide proof of products not approved by a Whirlpool designated service company. Expenses for travel and transportation for future reference. You can be repaired in accordance with electrical or plumbing codes, or use or when it was purchased. Service calls to correct the installation of your major appliance, to replace...
Warranty - Page 1
... instructions attached to or furnished with original model/serial numbers that have been removed, altered, or cannot be easily determined. Replacement parts or repair labor if this major appliance is used in the country in accordance with electrical or plumbing codes, or use or when it is installed in an inaccessible location or is not installed in which it . Service...
Whirlpool WED9150WW Reviews
We have not received any reviews for Whirlpool yet.