Miele T 8023 C Support Question
Miele T 8023 C Support Question
Find answers below for this question about Miele T 8023 C.Need a Miele T 8023 C manual? We have 2 online manuals for this item!
Question posted by DaphneLM on October 18th, 2022
Miele T8033 C Water In Condensor Part
Hi, I just opened my dryer to clean and there was a ton of water in the condensor part. I had water coming out when I pulled the condensor out to clean it. Is it ok to have that much water standing in there if the machine has not worked in 24 hours?
Current Answers
Answer #1: Posted by SonuKumar on October 18th, 2022 9:19 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,648,140
Member since:
May 9th, 2021 Points: 16,648,140
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Miele T 8023 C Manual Pages
Operating and Installation manual - Page 2
... Canceling or changing a program 12 Adding or removing laundry during a program 12 Child lock 13 Dryer care 14 Cleaning the lint filter 14 Cleaning the exterior and the control panel 15 Cleaning the drum 15 Emptying the condensed water container 16 Cleaning the condenser 17 Quick Guide 19 Dryer Care 19 Changing the light bulb 19 Frequently asked...
Operating and Installation manual - Page 3
...dryer if the
drum is a danger that they may contribute to a chemical reaction that have not been washed.
- Always close the door after being removed from buffing, etc.
- items that could cause the laundry... with gasoline, dry-cleaning solvents or other deposits...machines may give off vapors that sufficient detergent is essential to read all instructions
before using your dryer...
Operating and Installation manual - Page 5
...button
Turns power to the machine on , the drum interior will light when the door is left open, the light will go off .
If the dryer is on and off ...after a few minutes to save energy.
f "FAULT" indicators
An illuminated indicator will sound at the end of the program.
If the door is opened. d "Status" display Shows the current cycle of the finished laundry...
Operating and Installation manual - Page 7
... swing - Fabric softener sheet may clog the filters and cause the dryer to open the door.
^ Load the laundry loosely into the drum.
^ Make sure the lint filters are in the closed door.
7 button until the desired program indicator lights. Using the dryer
1. Select a program
For best results use liquid fabric softener when washing...
Operating and Installation manual - Page 8
...-
cottons. Rotary Iron
Cotton or linen fabrics which allow machine drying. permanent press items.
Fluff
Individual items to be freshened....
-
To prevent moisture loss, roll up the laundry until ironing.
If fabrics are still damp, dry ...press
fabrics made of sturdy cottons, e.g. Using the dryer
Program
Fabric
Note
Normal Available drying options: Turbo, Gentle, Anti...
Operating and Installation manual - Page 9
Using the dryer
OPTIONS
Turbo Fast drying for about 1 hour.
9
Select a drying option (if needed)
^ A drying option can be selected or deselected with increased temperature...sturdy fabrics with each press of a program. 3. Gentle For drying delicate fabrics slowly at a lower temperature. Anti-crease Prevents wrinkles if laundry is not removed immediately after the end of the button.
Operating and Installation manual - Page 11
... asked questions" for details.
^ Press the "Door" button. ^ Open the door. ^ Remove the laundry. ^ Check that the drum is empty. ^ Clean the lint filter after each use
(see "Dryer care"). ^ Close the door.
^ Press the "On/Off" button to turn off the dryer.
^ Empty the condensed water container weekly (if not connected to a drain).
11 Start...
Operating and Installation manual - Page 12
...the new program by pressing the e or - Adding or removing laundry during a program
^ Turn off the dryer using the "On/Off" button.
^ Press the "Door" button.
^ Open the door.
,CAUTION -
Using the dryer
Canceling or changing a program
^ Press and release the "Start/Stop... level (available in the drum.
^ Add or remove items.
^ Close the door.
^ Turn the dryer back on with the "On/Off" button.
12
Operating and Installation manual - Page 15
... of electric
shock, disconnect the dryer from the power supply by turning the knob at the filter top.
^ Rinse all lint filters with hot water and dry thoroughly.
^ The exterior and the control panel can be cleaned with warm water and liquid dish soap applied with a soft cloth.
15 Cleaning the drum
The filters must...
Operating and Installation manual - Page 16
..., or if it clicks into its opening until it becomes full during normal operation:
- The buzzer will light.
- The container holds approximately 1 gallon of the machine.
Should the container be emptied weekly. Do not drink the condensed water!
16 The container should be full when the tumble dryer is empty, push it
back into...
Operating and Installation manual - Page 18
... in all the way and locked in the reverse order. Dryer care
Rinsing the condenser
Returning the Condenser
^ Put the condenser back in place in place.
^ Restore power.
^ Rinse the condenser along the left side with warm water.
^ Rinse the condenser from the front with warm water.
^ Check the condenser for visible soiling.
Operating and Installation manual - Page 20
... the button. Quick Guide
1.Turn on the dryer.
^ Press the "Door" button to tumble freely.
^ Press the e or - button until the desired program indicator lights.
3. do not push it shut.
^ A drying option can be caught in the drum for clothes to open the door.
^ Load the laundry into the drum. Select a program
^ Press...
Operating and Installation manual - Page 21
4. Select the buzzer (if desired) 6. At the end of a program The "Anti-crease / End" indicator will light. ^ Press "Door" and remove the laundry. ^ Clean the lint filter. ^ Press the "On/Off" button to turn off
the dryer. Select the dryness level
Quick Guide
5. Start the program
^ Press the selection button until the desired indicator illuminates.
^ Press the "Start/Stop" button.
7.
Operating and Installation manual - Page 23
Dryer Care
Changing the light bulb
,To reduce the ...off the power main, tripping the circuit breaker or unplugging the power cord before performing maintenance.
^ Open the door.
The light bulb must not exceed the maximum wattage listed on the data plate.
... along the upper rim of the drum opening.
^ Replace the light bulb with a wide head underneath the side edge of electric
shock, disconnect...
Operating and Installation manual - Page 24
.../Stop" button was not pressed.
What if the drum light does not come on the dryer. Press the "Start/ Stop" button to laundry when washing or select the "Less Dry" setting on ?
See "Child Lock." Frequently asked questions
What if the dryer will not operate when the drum is on and a program cannot be...
Operating and Installation manual - Page 25
... too many dissimilar items (size and fabric.)
What if water has collected around the drum opening? Possible fault
This is overloaded.
Metal zippers interfere with lint or Clean the condenser periodically (see "Dryer care").
What if the laundry is lit?
Open a window or door to increase
the dryer. The lint filters are clogged.
The condenser is clogged...
Operating and Installation manual - Page 26
...please contact Miele's Technical Service Dept. For ...providers for Miele products will be found on your Miele products,...the Miele Service department, Extended Service Contracts offered by Miele....http://miele.com/mielecare
22
MieleCare...opening.
(only USA)
MieleCare, our Extended Service Contract program; Only genuine Miele parts installed by a Miele Authorized Service Provider using genuine Miele...
Operating and Installation manual - Page 28
...1360 [email protected]
V 1-800-565-6435 service@miele.ca
SAVE THESE INSTRUCTIONS
24 Extension cords do not ...machine in doubt as to
the manufacturer's instructions and local codes.
~ Repair and maintenance work
should be grounded. IMPORTANT SAFETY INSTRUCTIONS
, WARNING - Work by unqualified persons could void the warranty.
~ Before installation, disconnect the
tumble dryer...
Operating and Installation manual - Page 29
Height of a Miele washing machine for a stacked installation.
The tumble dryer can also be performed by a Miele authorized technician. An appropriate stacking kit is available from your Miele dealer or the Miele Technical Service Department.
,Installation of the stacking kit
must be placed on top of a stacked installation
5' 6 3/8" (168.6 cm) (Stacking kit with a pull out shelf)
Washer /...
Operating and Installation manual - Page 35
... damaged!
^ The drain hose holds a small amount of the dryer. Keep a container at the back of remaining water. Installing the drain hose
Do not pull or kink the drain hose, it from becoming kinked.
31 The condensed water can also be drained directly if the machine is installed near a sink or a standpipe so that the...
Similar Questions
I Get Nothing, No Lights And Does Not Start
I have power to plug but dryer does not light up or start, could it be the thermal fus
I have power to plug but dryer does not light up or start, could it be the thermal fus
(Posted by michaelcamp21 2 years ago)
Lint Behind Condenser Miele T8023c
I had have this exact dryer for a few years. I clean the condenser as you have shown regularly since...
I had have this exact dryer for a few years. I clean the condenser as you have shown regularly since...
(Posted by nancyroscelli 4 years ago)
Hi My Dryer Is Not Heating Up. What Can The Problem Be ?
Hi my dryer is not heating up. What can the problem be ?
Hi my dryer is not heating up. What can the problem be ?
(Posted by Payalkedia 6 years ago)
Miele Vario Pw 6065
When installing the machine we selected an option which was unsuitable for the machine now we cant a...
When installing the machine we selected an option which was unsuitable for the machine now we cant a...
(Posted by benholmes 10 years ago)
