Smeg KD120XU Support Question
Smeg KD120XU Support Question
Find answers below for this question about Smeg KD120XU.Need a Smeg KD120XU manual? We have 1 online manual for this item!
Question posted by fernandotoll on December 16th, 2016
Control Panel
Hi,i Need To Replace The Control Panel
Current Answers
Answer #1: Posted by waelsaidani1 on December 16th, 2016 4:58 AM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,797
Member since:
May 12th, 2013 Points: 19,501,797
You order this item from Smeg directly. Tel. +39 0522 821 1 Fax +39 0522 821 452
[email protected]
[email protected]
Related Smeg KD120XU Manual Pages
Instruction Manual - Page 3
...anti-odour carbon filters and recirculated through the aerating grids on air discharge when operating the hood. • The extracted air must not be used by children without an adult supervision ...recycle the air. WARNING!
• Read the instructions carefully before installing and/or using the hood and other gas
appliances at the same time. • Comply with the regulations on the sides...
Instruction Manual - Page 4
... to the supports/hooks (fig. 5) and level by means of the holes for installation. b) The hood is supplied with two supports/hooks (a)
(Fig 3) or bracket (b) that need to fix the hood safely. (fig. 4) Drill and put the hood on the back of the adjusting screw
(fig.3). The L1 holes for these supports are on...
Instruction Manual - Page 5
... the chimney bracket to the wall by tightening the two H screws . Warning: if the hood is necessary to the wire. Then connect it is not supplied with the rules in force... holes on the wall for the load, compliant with an active carbon filter, it before using the hood. m) Chimneyassembly: Adjust the two telescopic chimneys to buy it separately and assemble it is
K
therefore necessary...
Instruction Manual - Page 6
... minutes before starting cooking and keep it on /off the hood's light. - Four-position Knob (B):
0
Motor OFF
1-2-3 Speed adjustment
(B)
04 OPERATING INSTRUCTIONS:
CONTROL PANEL:
In order to achieve the best performance, it is recommended to start the hood, identify your type of control panel and follow the instructions:
SLIDER:
A
B
- Key (A) to turn on for...
Instruction Manual - Page 7
...off timer" function that grease filters are cleaned every 100h and active carbon filters are replaced every 200h.
EN
05
Special attention should be a fire risk. EXTERNAL CLEANING: External ...not reset the filters cleaning memory It is advisable to
clean/replace the filters .
When cleaning the steel of the hood. Regular cleaning will activate the "Auto power-off after 10...
Instruction Manual - Page 8
... FILTERS REPLACEMENT: (For recirculated version only)
The carbon filters can also be washed, therefore, it is necessary to the metal grease filters. They cannot be a fire risk. Round filter: simply rotate the filters 90 degrees as affecting the performance of the hood, can only retain odours for the electronic controlled hood, reset the
filters...
Instruction Manual - Page 9
... lighting such as incandescent, halogen and neon lamps. To replace them, remove the transparent fixture from the control panel, unscrew the lamp and screw in , performing the same
operations backwards.
(d)
EN
d) Neon lamp: 15/18W neon tube. LIGHTS REPLACEMENT: (a)
(b)
Before performing any cleaning and/or maintenance operation, disconnect the hood from its seat and support.
Instruction Manual - Page 10
...Customer Service
0870 9909907 and provide the following data:
• The model indicated inside the hood (fig. 7) • Your full address • Your telephone number
• Information ... and filters are not covered by your warranty).
WARRANTY AND TECHNICAL ASSISTANCE SERVICE
The hood packaging includes, together with this operating and maintenance booklet, the Smeg Warranty Booklet. ...
Similar Questions
Where Can I Find This Vent A Hood?
looking for this item. I'm in west TN. Where can I find one
looking for this item. I'm in west TN. Where can I find one
(Posted by tewspw1973 2 years ago)