Smeg KD120XU Support and Manuals
Get Help and Manuals for this Smeg item
View All Support Options Below
Free Smeg KD120XU manuals!
Problems with Smeg KD120XU?
Ask a Question
Free Smeg KD120XU manuals!
Problems with Smeg KD120XU?
Ask a Question
Most Recent Smeg KD120XU Questions
Popular Smeg KD120XU Manual Pages
Instruction Manual - Page 3
... minimum distance between the cooker and the lower part of the hood must be
750mm for gas cookers and 650 mm for electric cookers. • Before carrying out any carbon filters.
• RECIRCULATION MODE: If it is intact.
WARNING!
• Read the instructions carefully before installing and/or using the hood and other...
Instruction Manual - Page 4
...supports/hooks (fig. 5) and level by
the manufacturer, you can assemble it using the supplied screws (for type 1) or pushing (for installation. The minimum distance between the cooker and the lower part...two supports/hooks (a)
(Fig 3) or bracket (b) that need to be removed (see page 7)
H(obo)d levelling screw
EN
02 Fig.2 Type 1
Type 2
The following instructions will assist installation: a)...
Instruction Manual - Page 5
...to buy it separately and assemble it before using the hood. Remove the chimney set, drill and fix the support racket to the wall by a qualified technician.
The appliance is
K
therefore ...in figure 6. The switch must have a minimum contact opening of wall anchors. . Z
03 Install the active carbon filters as shown in
force. Then connect it to a nearby, easily
reachable ...
Instruction Manual - Page 6
... :
- Key (A) to turn on/off the hood's light. - Two-position Knob (A) to start the hood, identify your type of control panel and follow the instructions:
SLIDER:
A
B
- OPERATING INSTRUCTIONS:
CONTROL PANEL:
In order to achieve the best performance, it is recommended to turn on/off
the light (0-1)
- Four-position Knob (B):
0
Motor...
Instruction Manual - Page 7
...attention should be given to
clean/replace the filters .
It is ...replaced every 200h. When cleaning the steel of operation), the user is advisable to happen every 100h of the hood, we suggest rubbing in the filter, as well as the grain. FILTERS CLEANING WARNING: When all the 4 LEDs blink at the same time (which is programmed to use specific products, following their instructions...
Instruction Manual - Page 8
... enough to find the carbon filter kit of the appliance. Note: only for a limited
period of the hood
CARBON FILTERS REPLACEMENT: (For recirculated version only)
The carbon filters can also be washed, therefore, it is disconnected
Fig.A
from their
seats....An excess of grease in the case of a heavy use of your hood's model, remove one filter at a time as shown in these pictures.
Instruction Manual - Page 9
... lamps: G23 11W lamp. To reach the neon tube, unscrew the glass framework screws. To replace the lamp, use a screwdriver to the model, the hood can be equipped with the ring. According to remove the glass-supporting ring.
LIGHTS REPLACEMENT: (a)
(b)
Before performing any cleaning and/or maintenance operation, disconnect the hood from its seat...
Instruction Manual - Page 10
Fig.7
In the case of failure, please call Customer Service
0870 9909907 and provide the following data:
• The model indicated inside the hood (fig. 7) • Your full address • Your telephone number
• Information on the kind of failure
EN
08
bulbs and filters ...
Instruction Manual - Page 11
... of this product. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you will help prevent potential negative consequences for the environment and human health, which could otherwise be handed over to the...
Smeg KD120XU Reviews
We have not received any reviews for Smeg yet.