Bosch WFMC5801UC Support and Manuals
Get Help and Manuals for this Bosch item
View All Support Options Below
Free Bosch WFMC5801UC manuals!
Problems with Bosch WFMC5801UC?
Ask a Question
Free Bosch WFMC5801UC manuals!
Problems with Bosch WFMC5801UC?
Ask a Question
Most Recent Bosch WFMC5801UC Questions
Door Seal
TRemoved top and control panel. How do i get the new door seal on the drum
TRemoved top and control panel. How do i get the new door seal on the drum
(Posted by pwohldford 10 years ago)
Popular Bosch WFMC5801UC Manual Pages
Pedestal Installation Instructions - Page 3
... is inserted in place, then tighten each one . NOTICE
Make sure the washer transportation bolts are in the slot on the floor to the left and install all the way inside the back panel of cardboard (such as support. The washer installation instructions required these bolts to be used as the pedestal carton) or other suitable...
Pedestal Installation Instructions - Page 4
... for Washers: Slight water spillage may be used to laying washer on
4 Go to installing the pedestal. 2.
Position the original packaged appliance close to 2" off the floor. DO NOT reinstall these feet into the pedestal. Set the drawer aside. Remove the protective film, four
corner supports, and two foam packaging pieces. 3. Remove the bottom of this manual...
Pedestal Installation Instructions - Page 8
... parts if defective in the washer or dryer Operating, Care and Installation Instructions", supplier will repair or replace any other rights which the pedestal is installed. In the space below, record the purchase date of purchase, when this pedestal is subject to other than those listed in use and/or used with the Pedestal and contact the service...
Operating, Care, Installation - Page 3
... Tools
7
Dimensions
7
Installation area
7
Checklist for Installation
7
Removing the transport bolts
8
Water connection
8
Hose and cable lengths 10
Electrical connection 10
Leveling procedure 11
Transport, such as when moving out 11
OPERATING INSTRUCTION 12
Your new washer 12
Panel 13
Summary of Instructions 14
Before Using For the First Time 15
Using For...
Operating, Care, Installation - Page 4
...Low noise level for 2 weeks or more.
NOTICE
NOTICE - BOSCH washers are instructed in published user repair instructions that have been soiled with pullĆlock (magnetic door lock).
- Do not repair or replace any part of the appliance or attempt any service unless specifically recommended in the user maintenance instructions or in safe practices by grasping the plug, not the cord...
Operating, Care, Installation - Page 5
... place according to the INSTALLATION INSTRUCTIONS. This appliance is properly grounded. Do not operate the washing machine if parts are using. Precautions should be used near children.
15. Do not sit or stand on the open door.
20. To avoid damage to an individual branch circuit. In case of change of the detergent(s), cleaning aid(s), fabric...
Operating, Care, Installation - Page 6
... over the holes for hot water (red marking).
3. Also remove the washer door to prevent children from any parts are intended for the winter, any residual water in the pump or water inlet hose(s) must be exposed to be reclaimed from plastic wrap and folding cartons. Wrench for use by qualified installers. INSTALLATION INSTRUCTION
Introduction
d CAUTION
TO AVOID RISK...
Operating, Care, Installation - Page 7
...cm), Bottom: 24 sq. Power cord with holding brackets (set) from Bosch Customer Service (WMZ 2200).
weight = 220 lbs (100 kg)
Installation area
d WARNING
Never ground the washer to the floor. Connections located on a weak wood floor consider the following tools are helpful: 1. H = hot water connection C = cold water connection
Useful tools
The following : q Soft floor surfaces...
Operating, Care, Installation - Page 10
... which has been properly installed and grounded in . / 60 cm (approx.) h = minimum drain point height
Electrical connection
GROUNDING INSTRUCTIONS This appliance must be replaced by providing a path of a malfunction or breakdown, grounding will not fit in doubt as the required fuses are available from Customer Service.
Make sure that the water flow out of fire...
Operating, Care, Installation - Page 15
...), red clay. see Page 17. q Set the program selector to avoid scratching the washer interior. When the display shows 0:00": q Open the door. q Remove nonĆwashable trim and ...time of
water into detergent chamber I ;
detergent into the detergent chamber I . q Close the door.
Dish towels, hand towels and bed linen that the supplied
voltage is on the water tap. Body...
Operating, Care, Installation - Page 17
.... The specifications of soiling. This will eventually become gray and stiff. Begin with a little water before being poured into the dispenser (prevents overflow due to : - Grayish brown spots (fat globules) may cause parts of the washing machine to 1/2 of the detergent
dispenser.
q Add the detergent and/or additive. Not using HE detergent could cause problems such as...
Operating, Care, Installation - Page 23
q Turn on the water taps and check that the strainer is recommended that you can use the correct type of detergent, it is leaking, check that there are no laundry in Detergent
compartment of the dispenser
q Run a Regular/Cotton Hot program
Descaling the washing machine
NOTICE
Descaling agents contain acids which may attack parts of the...
Operating, Care, Installation - Page 24
...!
Clean the water inlet strainers; The water level is loose or not inserted. Repairs should be removed during a power failure, call Customer Service (refer to be heard). Plug is below the visible part of the drum.
24
Spinning is to Page 26). Select speed before end of program.
Supply hose kinked or pinched. Troubleshooting of Minor...
Operating, Care, Installation - Page 26
... received: q First, please contact your installer
or the Authorized Service Contractor in the product or manual without notification.
26 Date Problem occurred - The manufacturer reserves the right to... with your installer or service technician the problem still has not been resolved to repair the appliance yourself. The image below the model number.
If service becomes necessary,...
Operating, Care, Installation - Page 27
... the service call. Repair/Replace as is", or previously returned model) purchased directly by the end-user consumer, and not for any microprocessor or printed circuit board that you , the first using a Bosch-authorized service provider during the first two years from an authorized service provider) or is the best way for any motor or component part of...
Bosch WFMC5801UC Reviews
We have not received any reviews for Bosch yet.