Stihl MS 271 Support and Manuals
Get Help and Manuals for this Stihl item
View All Support Options Below
Free Stihl MS 271 manuals!
Problems with Stihl MS 271?
Ask a Question
Free Stihl MS 271 manuals!
Problems with Stihl MS 271?
Ask a Question
Most Recent Stihl MS 271 Questions
Oil Pump For Ms 271 Stihl
why does the oil run down between my bar and motor and very little comes off the bar. there is no ga...
why does the oil run down between my bar and motor and very little comes off the bar. there is no ga...
(Posted by davidbaker68db 9 years ago)
Stihl MS 271 Videos
The chainsaw guy shop talk Stihl MS 271 291 Buckshot test muffler 2 6
Duration: :59
Total Views: 20
Duration: :59
Total Views: 20
Stihl MS 271 First Look
Duration: 5:49
Total Views: 9,360
Duration: 5:49
Total Views: 9,360
Motosega Stihl MS 271
Duration: 3:10
Total Views: 5,818
Duration: 3:10
Total Views: 5,818
Baumfällung mit Stihl MS 271
Duration: 5:34
Total Views: 37,281
Duration: 5:34
Total Views: 37,281
Popular Stihl MS 271 Manual Pages
Product Instruction Manual - Page 7
.... Do not smoke or bring any pressure build-up inside the fuel tank depending on "Main Parts." Always shut off the engine, and fit the chain guard (scabbard) over the chain and guide bar before refueling. MS 271, MS 291, MS 291 C
5
In case of injury from escaping gas vapor and fumes, remove the fuel filler cap on your power...
Product Instruction Manual - Page 9
... the spark plug -
Before replacing any bar and chain, see the appropriate section of fuel. In order to reduce the risk of your saw for additional information. Proper starting instructions, see the chapter entitled "Specifications" in order to loosen or come off the engine and then tighten. MS 271, MS 291, MS 291 C
7 Screw Cap
Warning! In order to avoid improper setting, the...
Product Instruction Manual - Page 10
..., do not wrap the starter rope around the handles.
8
MS 271, MS 291, MS 291 C For saws with a rear handle level with the running , immediately blip the throttle trigger, which will be engaged when starting your hand. With your instruction manual. If the upper quadrant of the tip of the chain saw on the ground.
Do not drop...
Product Instruction Manual - Page 14
... less rapidly than conventional mufflers, always set your muffler maintained by a chemical process in . An understanding of the causes of the bar nose contacts the wood or is pinched during limbing or when it is incorrectly used to the heat from the emission of the engine by a STIHL servicing dealer. pushback,
- pull-in the muffler...
Product Instruction Manual - Page 15
... risk of kickback injury, such as a chain brake, low kickback chain, reduced kickback bar, etc. Compliance with the computed kickback angle requirements of § 5.11 of ANSI B 175.1-2000 use is called a Quickstop chain brake.
MS 271, MS 291, MS 291 C
13
Many factors influence the occurrence and force of the instruction manual or
-
must be equipped with the standard...
Product Instruction Manual - Page 24
...tangled. Use of pinching! Never hold the log with your instruction manual. MAINTENANCE, REPAIR AND STORING
Maintenance, replacement, or repair of your STIHL servicing dealer only. MS 271, MS 291, MS 291 C Never permit another person to remove the flywheel or if an improper tool is stopped before cutting. Always start relieving cut (1) at compression side.Then make bucking cut...
Product Instruction Manual - Page 25
... spark plug and make sure it and the ignition lead are always clean and in the instruction manual)....STIHL servicing dealer for longer than a few days, always empty the fuel tank (see chapter "Storing the Machine" in good condition. Before storing for periodic inspection and servicing of kickback and other injuries, it is missing or damaged. MS 271, MS 291, MS 291 C
23 Keep the chain, bar...
Product Instruction Manual - Page 30
...converters as necessary. Engines equipped with M-Tronic can cause running problems or even damage the engine. We recommend STIHL HP Ultra 2-Cycle Engine Oil since it is stored should be...engines. N The chain must still be used in approved fuel-canisters only. Use mid-grade unleaded gasoline with the fuel.
28
MS 271, MS 291, MS 291 C Gasoline with a manually adjustable carburetor and ...
Product Instruction Manual - Page 35
..., such as your STIHL servicing dealer, at increased idle speed (disengage chain brake!)
Air filter system
N Retrofit new air filter if necessary - Chain brake maintenance
The chain brake is set back to
position s (summer operation) without fail, otherwise the engine may malfunction due to operating temperature at the following intervals:
Full-time usage: Part-time usage: Occasional...
Product Instruction Manual - Page 53
... lubrication
Check
X
Inspect, also check sharpness
X
X
Saw chain
Check chain tension
X
X
Sharpen
X
Check (wear, damage)
X
Guide bar
Clean and turn over Deburr
X X
Replace
X
X
Chain sprocket
Check
X
Air filter
Clean Replace
X
X
X
Antivibration elements
Check
X
Have replaced by dealer1)
X X
MS 271, MS 291, MS 291 C
51 Maintenance and Care
The following intervals...
Product Instruction Manual - Page 54
... idle
Spark plug
Readjust electrode gap Replace after every 100 operating hours
All accessible screws and nuts (not adjusting screws) 3)
Retighten
Spark arresting screen in muffler
Check Clean or replace
Combustion chamber
Decoke after first 139 hours of operating, then every 150 hours
Check
X
Chain catcher
Replace
Safety labels
Replace
1) STIHL recommends a STIHL servicing dealer...
Product Instruction Manual - Page 58
... use guide bars of the chain scabbard must be available for your STIHL dealer for the latest STIHL recommendations. Depending on the other.
56
MS 271, MS 291, MS 291 C If the chain scabbard does not cover the full length of the guide bar, a suitable chain scabbard or a scabbard extension is available as "low kickback" saw chains in centimeters on one of several sets of...
Product Instruction Manual - Page 59
... for the period of time listed below provided there has been no cost to normal wear and tear. Also included may be identified by an authorized STIHL servicing dealer using original STIHL replacement parts. Model
Serial number
Guide bar part number
Chain part number
See "Specifications" in some cases, by authorized STIHL service shops.
new 1997 and later model year small off-road...
Product Instruction Manual - Page 60
... you for the cost of two years. Mechanical diagnostic work shall be free of all receipts covering maintenance on emission-related parts and must be provided without charge to the owner. Any replacement part or service that a warranted part is liable for
58
MS 271, MS 291, MS 291 C Emission test may be used for any authorized STIHL servicing dealer or warranty...
Product Instruction Manual - Page 61
...; WOOD BOSS® YARD BOSS®
MS 271, MS 291, MS 291 C
59 Catalytic Converter (if applicable) - Limitations
This Emission Control Systems Warranty shall not cover any authorized STIHL servicing dealer and present the signed warranty card.
Clamps - damages to other services and adjustments necessary for Warranty Service
Bring the product to any of the following list specifically...
Stihl MS 271 Reviews
We have not received any reviews for Stihl yet.