Kenwood KMR-M312BT Support Question
Find answers below for this question about Kenwood KMR-M312BT.Need a Kenwood KMR-M312BT manual? We have 1 online manual for this item!
Question posted by garybradt on July 4th, 2016
My Stereo Wont Turn On.
I left my stereo on to where it drqined my boat battery. Now my stereo wont turn on. I hit the reset button but still nothing.
Current Answers
Answer #1: Posted by waelsaidani1 on July 4th, 2016 9:27 AM
it sounds like your deck's constant power wire may be connected to a key-switched power source, and the accessory power wire isn't connected to anything with voltage.
First, check your fuses: 15-amp "stereo" fuse under the driver's-side dash, and 7.5-amp "backup" fuse in the engine compartment fuse box. If you replace a blown fuse and the head unit starts working, make sure it retains the settings and station presets when you turn the car off. If it doesn't, switch the two power wire connections.
First, check your fuses: 15-amp "stereo" fuse under the driver's-side dash, and 7.5-amp "backup" fuse in the engine compartment fuse box. If you replace a blown fuse and the head unit starts working, make sure it retains the settings and station presets when you turn the car off. If it doesn't, switch the two power wire connections.
Related Kenwood KMR-M312BT Manual Pages
Similar Questions
Remotes Stop Working After Several Minutes
i have 2 remotes set up but they stop working after several minutes. when i initially turn on the ra...
i have 2 remotes set up but they stop working after several minutes. when i initially turn on the ra...
(Posted by wave88 1 year ago)
Radio Will Not Receive
My radio said miswirirng but did not change any wiring, now it says protecting. I was told by servic...
My radio said miswirirng but did not change any wiring, now it says protecting. I was told by servic...
(Posted by nreo 3 years ago)
I Have Power To The Radio Connector (12.4 V) Pins, But No Sign Of Power On The D
power to the connector pins, but won't turn on, no display. 10 amp fuse is ok. Is there an reset but...
power to the connector pins, but won't turn on, no display. 10 amp fuse is ok. Is there an reset but...
(Posted by Dmschilling 6 years ago)
Will Not Turn On
I have all the speaker wires disconnected and the power, ground and remote wires connected properly ...
I have all the speaker wires disconnected and the power, ground and remote wires connected properly ...
(Posted by plschaseme 7 years ago)