Owners Manual
Page 1
... in the illustration. Carefully remove the cutting blades, retaining the blade bolts for reinstallation when the mulch kit is not being used. 2. Clean any grass out from underneath the deck. 1 1 2 2 4. NOTE: Only two hardware sites are sharp. INSTALLATION INSTRUCTIONS 60" MULCH KIT - 966 444701 IMPORTANT: BEFORE PROCEEDING, PLACE...247027 R1 08/15/09 Remove the three nuts and bolts that protect the mulch kit fastening locations (2). Block the front of the mower up to give access to the outside of the front deck. Bolt left hand corner mulch baffle to the underside of the deck ...
... in the illustration. Carefully remove the cutting blades, retaining the blade bolts for reinstallation when the mulch kit is not being used. 2. Clean any grass out from underneath the deck. 1 1 2 2 4. NOTE: Only two hardware sites are sharp. INSTALLATION INSTRUCTIONS 60" MULCH KIT - 966 444701 IMPORTANT: BEFORE PROCEEDING, PLACE...247027 R1 08/15/09 Remove the three nuts and bolts that protect the mulch kit fastening locations (2). Block the front of the mower up to give access to the outside of the front deck. Bolt left hand corner mulch baffle to the underside of the deck ...
Owners Manual
Page 3
...exceed 1/3 of all hardware is 3", the mower deck cutting height should be set at not less than 2". • Ground speed should normally be reduced to allow clippings to be finely mulched. • Engine RPM should be set at maximum. • Blades must be kept sharp. • The ... well and grass accumulates under deck. Make sure all baffles. 9. Remove blocks and return the mower to 90 ft./lbs.). 8. P/N 115 247027 R1 08/15/09 Install the kit mulching blades using the existing blade bolt (torque to its normal position. INSTALLATION INSTRUCTIONS 7. Example: If grass height is tight. ...
...exceed 1/3 of all hardware is 3", the mower deck cutting height should be set at not less than 2". • Ground speed should normally be reduced to allow clippings to be finely mulched. • Engine RPM should be set at maximum. • Blades must be kept sharp. • The ... well and grass accumulates under deck. Make sure all baffles. 9. Remove blocks and return the mower to 90 ft./lbs.). 8. P/N 115 247027 R1 08/15/09 Install the kit mulching blades using the existing blade bolt (torque to its normal position. INSTALLATION INSTRUCTIONS 7. Example: If grass height is tight. ...
Installation Instructions
Page 3
...loosen the locknut and adjust bolt up until rear blade tips are positioned 1/8" to 3/8" higher than the front blade tips. 23. Blades are inflated to the bottom of the mower deck. Confirm measurements once again. In the front, blade tips should be required to leveling the deck. 20...side manner. 21. Turn both side-to -side. INSTALLATION INSTRUCTIONS Deck Leveling Adjust the deck while the mower is on the discharge side of the mower deck. Blade tip height should be properly adjusted. Protect your Operators Manual. Wear heavy gloves. Measure from side-to...
...loosen the locknut and adjust bolt up until rear blade tips are positioned 1/8" to 3/8" higher than the front blade tips. 23. Blades are inflated to the bottom of the mower deck. Confirm measurements once again. In the front, blade tips should be required to leveling the deck. 20...side manner. 21. Turn both side-to -side. INSTALLATION INSTRUCTIONS Deck Leveling Adjust the deck while the mower is on the discharge side of the mower deck. Blade tip height should be properly adjusted. Protect your Operators Manual. Wear heavy gloves. Measure from side-to...