Alpine PDR-M65 Support Question
Alpine PDR-M65 Support Question
Find answers below for this question about Alpine PDR-M65.Need a Alpine PDR-M65 manual? We have 1 online manual for this item!
Question posted by Icecreamed86 on May 11th, 2021
Is The Alpine Pdr M65 Amp Strappable So I Can Use 2 Amps To Work As 1?
Is the Alpine pdr m65 amp strappable so i can use 2 amps to work as 1?
Current Answers
Answer #1: Posted by Troubleshooter101 on May 12th, 2021 4:22 AM
Troubleshooter101
Member since:
September 30th, 2015 Points: 2,927,030
Member since:
September 30th, 2015 Points: 2,927,030
NO its not strappable its not come with that functionality and if you try to do that it can ruin the functionality for the AMP. You need to buy a much expensive AMP to make that working for you.
https://www.crutchfield.com/S-PKgHtU9BMeI/p_500PDRM65/Alpine-PDR-M65.html
Thanks
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Troublshooter101
Related Alpine PDR-M65 Manual Pages
Owners Manual - Page 1
...Paris Nord II, B.P. 50016, 95945 Roissy Charles de Gaulle
Cedex, France Phone 01-48638989
ALPINE ITALIA S.p.A. FOR CAR USE ONLY/POUR APPLICATION AUTOMOBILE/PARA USO EN AUTOMQVILES
PDR-M65
MONO POWER AMPLIFIER
I I
PDR-FSO
I
4 CHANNEL POWER AMPLIFIER
• OWNER'S MANUAL Please read before using this equipment.
• MODE D'EMPLOI Veuillez lire avant d'utiliser cet appareil.
• MANUAL...
Owners Manual - Page 2
Alpine cannot be dangerous and may result in an accident. LISTENING AT LOUD VOLUME LEVELS IN A CAR MAY ALSO CAUSE HEARING DAMAGE.
BEFORE WIRING, ...AT A LEVEL WHERE YOU CAN STILL HEAR OUTSIDE NOISES WHILE DRIVING. USE THIS PRODUCT FOR MOBILE 12V APPLICATIONS.
MAKE THE CORRECT CONNECTIONS. USE ONLY IN CARS WITH A 12 VOLT NEGATIVE GROUND. (Check with the manual to observe...
Owners Manual - Page 3
...authorized Alpine dealer or the nearest Alpine Service Center for installations or ground connections. Failure to do so may cause personal injury or damage to use a... HALT USE IMMEDIATELY IF A PROBLEM APPEARS. Return it as a permanent record. To ensure safety, always contact the dealer where you have the work done....This Amplifier has been type tested and found to comply with high incidence of...
Owners Manual - Page 4
.... Fig. 2
3. Using the amplifier as possible. Position the PDR-M65/PDR-FSO over the screw holes, and secure with four self-tapping screws. (Fig. 3)
Self-Tapping Screws (M4 x 20)
Fig. 1
2. Make sure there are no objects behind the surface that may become damaged during drilling.
5.
For alternate installation locations, please contact your authorized Alpine dealer.
1. Be...
Owners Manual - Page 6
...an optional noise suppressor, connect it as far away from the amp directly to the positive (+)terminal of the vehicle's battery with appropriate in -...Alpine dealer carries various noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
5-EN CONNECTIONS
.PDR-M65
• PDR...
Owners Manual - Page 7
...For PDR-M65 • The input is stereo but the output is not affected by checking for this unit are insert terminal. Do not use the ...RCA extension cable (sold separately) for driving a second subwoofer amp. This is not to be desirable
in relation to observe ... the battery lead as close as a common lead between the amplifier and head unit. NOTE: • When connecting the speaker ...
Owners Manual - Page 8
... of the product
iJ
-]!9/3~~, ~~/32")
PDR-M65/PDR-F50 BATTERY GROUND
lm (Max.)
~
...PDR-M65 8 AWG (8 mm2) PDR-F50 12 AWG (3 mm2) • If the wire gauge used . Fig. 8
NOTES: • If length of the exposed wire is too short, a poor
connection may occur.
3. ~CAUTION
About Power supply wires If the length of the power and ground cables exceed 1 m, or if you connect more than one amplifier...
Owners Manual - Page 9
...cannot sustain(+) 12V when connected to other Alpine component's Remote Turn-On
Leads
@ SPST ... amplifier will turn -on lead of the above , may be installed in-line on the PDR-M65/PDR-...Using this connection method, the PDR-M65/PDR-FSO will remain on
or power antenna lead.
Therefore, the switch should be used to the vehicle's power antenna. Make sure the switch is turned off ) the PDR-M65/PDR...
Owners Manual - Page 10
... (Hz) 400
CROSSOVER
MIN
MAX
GAIN
dt----~
_
W
,.~. ~· '~I, .e~. CD Crossover Frequency Adjustment Knob
(PDR-M65: LP FILTER) Use this case the maximum Bass EQ
boost level is reduced.
~
OFF HP LP FILTER
c) Set to the "LP" position when the amplifier is used to the speakers with no longer distorted). The frequencies below the tuning frequency...
Owners Manual - Page 11
...Operating temperature is too high. Use the correct power supply voltage. C9 Bass EQ Selector Switch (CH-3/4) (PDR-FSO
only)
Set to +6 11 dBII or II+ 12 dB" position when using
for Y-adapters.
~
1/2 ...blue.
10-EN The center frequency is off when power is 50 Hz. Is off .
Amplifier circuit is abnormal.
If it remains red, turn on . Decrease the vehicle's interior temperature ...
Owners Manual - Page 12
SYSTEM DIAGRAMS
fD Subwoofer
G) Front Speakers
G) Rear Speakers
~Head Unit, etc. ~ Front Output
~ Rear Output
e~ Subwoofer Output RCA Extension Cable (Sold Separately)
f) Y-Adapter (Sold Separately)
.PDR-M65
TYPICAL SYSTEM CONNECTIONS
1 Subwoofer System
2 Subwoofer System {MONO)
Fig. 14
Fig. 1S
11-EN
Owners Manual - Page 13
• PDR-FSO
TYPICAL SYSTEM CONNECTIONS
4 Speaker System (4-Channellnput)
1=-:Jtl Input Channel Selector Switch: 3/4
1/2 3/4 INPUT CHANNEL
8
L
R
L
R
4 Speaker System (2-Channellnput)
'J2 Input Channel Selector Switch: 1/2
1/2 3/4 INPUT CHANNEL
(L) f)
Fig. 16
L
R
L
R
12-EN
(R)
(L) f)
Fig. 17
Owners Manual - Page 14
...L
R
YU (L) (R) (R) (L) ~ ~
l t F======O:Q)0 ~-
--
G)
(L)
(R)~
(R)
9 (L)
Fig. 18
Important Tips on Bridging an Amplifier
NOTE:
• Low output will result if only one channel input is used . Proper connection
X Improper connection
Fig. 19
i
T~~
~
(One signal)
13-EN TheY-adapter is not required if a stereo/mono pair
0line output is used to drive both inputs of the bridged...
Owners Manual - Page 15
... Power Output
THD+N
S/N Ratio
Frequency Response Damping Factor Control Input Select Input Sensitivity
Crossover
Equalizer Remote Level* General Input Impedance Preamp Output Dimensions Weight
PDR·M6S
PDR-FSO
Per Channel, Ref: 4 0, 14.4 V
Per Channel, Ref: 2 0, 14.4 V
Bridged, Ref: 4 0, 14.4 V Ref: 10 W into 4 0
Variable HPF/LPF
Variable Subsonic
Bass EQ (fc=50...
Owners Manual - Page 19
...DAMAGED WHEN THIS PRODUCT DOES NOT WORK PROPERLY.
CAR AUDIO 1-800-ALPINE-1 (1-800-257-4631) NAVIGATION...amplifier level is recommended to an
Authorized Alpine Service Center or Alpine for repair and for repair (claims must reside in the Owner's manual. @ Damage caused by act of the first consumer purchase.
eHOW WE LIMIT IMPLIED WARRANTIES: ANY IMPLIED WARRANTIES INCLUDING FITNESS FOR USE...
Similar Questions
Problem Getting Power To Amp
everything is hooked up correctly and still no power to amp or subs
everything is hooked up correctly and still no power to amp or subs
(Posted by Anonymous-168700 2 years ago)
Alpine V12 Mrs M605 Amp Cooling Fans Do Not Come On At All
The fans in my Mrs m605 mono amp do not come on no matter how hot they get the amp works but a buddy...
The fans in my Mrs m605 mono amp do not come on no matter how hot they get the amp works but a buddy...
(Posted by josht232320 8 years ago)
How Many Watts Does This Amp Put Out?
(Posted by darylr6661 9 years ago)
Wiring My Alpine Amp To Head Unit And Speakers
I HAVE A ALPINE V-POWER MONO AMP MRP-M500 CAN I HOOK THIS UP TO MY ALPINE HEAD UNIT AND 2 FRONT SPEA...
I HAVE A ALPINE V-POWER MONO AMP MRP-M500 CAN I HOOK THIS UP TO MY ALPINE HEAD UNIT AND 2 FRONT SPEA...
(Posted by WRDINDUSTRIES1 11 years ago)
Using The Rca Plugs On The Amp
my radio has front rca for right and left speakers and rear rca for right and left speakers, how to ...
my radio has front rca for right and left speakers and rear rca for right and left speakers, how to ...
(Posted by bernardmeyers68 12 years ago)