American Standard Champion-4 Support Question
American Standard Champion-4 Support Question
Find answers below for this question about American Standard Champion-4 - 3180.016.165 Townsend Right Height.Need a American Standard Champion-4 manual? We have 2 online manuals for this item!
Question posted by Vince61038 on June 12th, 2022
My 6 Year Old Toilet Has A Lot Of Hair Line Cracks In The Area Where The Seat Re
toilet has many hair line cracks in the area where the seat rests, should I be concerned?
Current Answers
Answer #1: Posted by SonuKumar on June 12th, 2022 10:15 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,609,800
Member since:
May 9th, 2021 Points: 16,609,800
https://www.thespruce.com/assessing-and-repairing-a-cracked-toilet-2719016
https://www.fourseasonsplumbingsewer.com/blog/p.150803000/3-possible-ways-your-toilet-cracked/
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Answer #2: Posted by Odin on June 12th, 2022 9:44 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Yes, you should fix it. See instructions at https://www.thespruce.com/assessing-and-repairing-a-cracked-toilet-2719016.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related American Standard Champion-4 Manual Pages
Installation Instructions - Page 1
... for over is installed! Disconnect and remove supply line. RECOMMENDED TOOLS AND MATERIALS
Putty Knife Hacksaw Closet Bolts
Regular Screwdriver Wax Ring/Gasket Tape Measure
Adjustable Wrench Flexible Supply Tube Carpenters Level
Sealant 1/2" Deep Well Nut Driver or Deep Well Socket Wrench
1 REMOVE OLD TOILET
a. NOTE: Pictures may not exactly define contour of...
Installation Instructions - Page 2
... closet flange so bolts project through mounting holes. V ROUGHING-IN DIMENSIONS: Right Height™ Elongated Two Piece Toilet
FINISHED WALL
Right Height™ Round Front Two Piece Toilet
ROUGHING-IN DIMENSIONS: Normal Height Elongated Two Piece Toilet
FINISHED WALL
Normal Height Round Front Two Piece Toilet
772mm (30-3/8")
*(72281-3m/8m")
19mm ± 6mm (1 ± 1/4")
A
772mm
(30...
Installation Instructions - Page 3
...to flanged tubing). SCREWDRIVER
DO NOT SPIN BOLTS INSIDE TANK WITH A SCREWDRIVER
8 INSTALL TOILET SEAT Install toilet seat in tank kit. DO NOT use plumber's putty to help get nuts started on ...tightening, replace the supply line. Install caps on washers. (If necessary, cut bolt height to wall, alternately tighten hex nuts keeping tank even and level until toilet is used as illustrated to...
Installation Instructions - Page 4
....
VALVE BODY
SHANK WASHER
WATER LEVEL ADJUSTMENT
ROD
ADJUSTABLE HEIGHT
LOCK NUT CONE WASHER
COUPLING NUT (HAND TIGHT ONLY)
THREADED...take up or down. Turn off water supply and flush toilet to level indicated in tank by turning WATER LEVEL ADJUSTMENT ... turn thumbscrew until 2 clicks are felt. Remove thumbscrew by removing hair pin cotter
and clevis pin. 3.
Adjust water level. Water level...
Installation Instructions - Page 5
... sand and rust from seal surface. Leave water supply off water supply, disconnect supply line and inspect all
gaskets and washers. MAKE CERTAIN TIP IS TURNED TO THE LOCKED POSITION. Always use for any damages caused by toilet tank number which can be needed . (see Step 14) c.
TROUBLESHOOTING IF FILL VALVE SHUTS...
Valve Replacement - Page 1
...Alternate view of the refill tube.
Reconnect the water supply. Remove the old flush tower and discard.
Affix the end of the refill tube to 1...and tighten the tank mounting fasteners in a alternating manner. pillM0111=11111171
Remove the Hair Pin Cotter from lift arm. Replace the tank lid. Place the tank on... the supply line.
Insert the clevis pin through the inbound hole location.
• &#...
Similar Questions
Part That Should Be Covered By 10 Year Warranty. In The Champ 4 I'm Asking F
the blue seal ring on the flapper to be sent to me at no charge. I did not register the product and ...
the blue seal ring on the flapper to be sent to me at no charge. I did not register the product and ...
(Posted by rwyckoff1 7 years ago)
American Standard Toilets How To Fix Loose Seat On Cadet 3
(Posted by Nigelhosyo 9 years ago)
American Standard Champion 4 Toilet Valve Won't Stop Running
(Posted by langmom3 9 years ago)
Need A Bolt Kit For Tank To Bowl On A Cadet Toilet. 1/4' X 3' Long 1/4-20 Thre
Bolt kit for tank to bowl Cadet toilet. Bolt sz 1/4"x3" L. Thread 1/4-20 incl washers, nuts & ga...
Bolt kit for tank to bowl Cadet toilet. Bolt sz 1/4"x3" L. Thread 1/4-20 incl washers, nuts & ga...
(Posted by affordable1010 10 years ago)
Why Has Does This Toilet Not Flush Properly?
I purchased THREE of the same toilets and replaced one while it was still in warranty. All three toi...
I purchased THREE of the same toilets and replaced one while it was still in warranty. All three toi...
(Posted by throon2003 12 years ago)