Asko T781 Support Question
Find answers below for this question about Asko T781.Need a Asko T781 manual? We have 5 online manuals for this item!
Question posted by mmaoate on July 13th, 2017
How Do I Repair Dryer When It Stops.screen Said Fault Señor?
Current Answers
Answer #1: Posted by alexowoade on July 13th, 2017 11:51 PM
The thermal fuse is a safety device found in some dryers to prevent overheating. It is a heat sensitive fuse and will open if the temperature becomes too hot and will typically interrupt power to the drive motor and cause the dryer to be inoperable. The thermal fuse is about an inch or more long and normally embedded in a white plastic housing. Some brands of dryers use more than one thermal fuse, and they are normally located on the blower housing and/ or the heating element housing in an electric dryer and/or the burner housing on a gas dryer. The fuse will not have any continuity when tested with a multi-meter. Disconnect power to the dryer before testing the fuse
Located in the dryer's main console is the start switch. When depressed it sends power to the drive motor and starts the dryer tumbling. If the dryer doesn't start then the start switch may be defective. The switch can be tested for continuity using a multi-meter. Unplug the dryer before you test the start switch.
Gas and electric dryers have a motor that turns the blower and the dryer drum. A defective motor can cause your dryer to not start and may even produce a humming noise from a bad winding or switch on the motor. To check for a defective motor you will need to remove the front panel and the drum to gain access. You will then need to supply line voltage to the proper terminals on the motor to verify if it is defective. This is a live voltage test and should only be performed by qualified persons.
Electronic controlled dryers will use a circuit board to operate the dryer's electrical components much like the timer in timer controlled models. The circuit board is normally located in the dryer's main control panel. If the dryer is not starting then inspect this part as a potential cause. Symptoms that the board is faulty include burn marks on the board itself and/or parts on the circuit board appear to be shorted out. If the board is defective then it normally cannot be repaired and will need to be replaced.
Timer
Located in the control console of the dryer the timer consists of a small motor connected to a series of gears that rotate cams, which turn electric contacts off and on inside the timer. The timer contacts control the dryer motor as well as the heat circuit and the timer motor itself. A defective timer contact can prevent power from getting to the drive motor and the timer will need to be replaced. The contacts can be checked for continuity with a multi-meter. This test should only be made with the power removed from the dryer.
Answer #2: Posted by Odin on July 14th, 2017 5:59 AM
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Asko T781 Manual Pages
Similar Questions
My T731 asko dryer stopped running. It makes a loud clicking sound which I think is coming from the ...
Asko T702C butterly dryer stopped working T702C butterfly dryer it was making a loud thumping sound ...
My ASKO T761/T781 dryer stops working in the middle of a cycle. There is no error message. The lint ...
Im getting a f10 error message on my T754c dryer. What does this mean please.
When start button pushed and released dryer stops if I tape button on it will keep running but have ...