Home » Bosch » Laundry Dryers » Bosch WTMC3521UC

Bosch WTMC3521UC Support Question

Find answers below for this question about Bosch WTMC3521UC - Nexxt 500 Series Gas Dryer.
Need a Bosch WTMC3521UC manual? We have 3 online manuals for this item!

Bosch Overview Questions Manuals Reviews Videos Research

Question posted by jgstroh on August 9th, 2011

Bosch Wtmc3521uc/05 Will Not Start. Display Is Good. Solenoid Clicks.

what would cause the dryer to be inoperative. also have a lint filter light (filter is clean)

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Bosch WTMC3521UC Manual Pages

Pedestal Installation Instructions - Page 2

... appliance is used to draw the user's attention to the Operating, Care and Installation Instructions" provided with the pedestal. Warranty Card (not pictured) Before You Start i Important: If your appliance for tools and information required. NOTICE NOTICE -

Pedestal Installation Instructions - Page 3

...the washer drum. Pull the appliance away from the bolt prior to pedestal installation. 2. For dryers go directly to washers. To reinstall the transportation bolts: q Locate the four transportation bolt assemblies...each one . d CAUTION When lifting or lowering the appliance onto its side. 5. Start with four transportation bolts installed to fit the slot. Align each one into the ...

Pedestal Installation Instructions - Page 5

... before removing any of 10 ftĆlb (14 N-m) to allow it may cause injury or damage. 6. The front two feet should fit up against the floor.... when moving). q Loosen all screws are hand tight, use the feet that are started into their threads. Using the 6 mm Allen (Hex) wrench, install the socket head...For dryers go directly to slide against the appliance housing.

Pedestal Installation Instructions - Page 6

... removed using the wrench. Figure 16 8. Follow the Installation Instructions that direction. Storing the transport bolts Always keep the transport bolts for leveling (moving out). Start with the bolts, otherwise the bushings will turn the lock nut, the foot (see Figure 14). q After leveling the unit from side to back. Loosen...

Pedestal Installation Instructions - Page 7

...before its completion, then the door may be tightened firmly to minimize vibration and movement of laundry in place by aligning it to keep it from moving during operation. 4. Slide the ball ...is satisfactorily raised or lowered, lock the height-adjustable feet in the machine, starting it locks tightly against the pedestal. For problems with a pair of the appliance to securely tighten ...

Pedestal Installation Instructions - Page 8

...to the Operating, Care and Installation Instructions" that came with the washer or dryer that is available by contacting the retailer where the Pedestal was purchased. In the..., when this pedestal is installed with the listed washer or dryer and operated according to the instructions provided in the washer or dryer Operating, Care and Installation Instructions", supplier will repair or replace...

Operating, Care, Installation (all languages) - Page 2

... table 16 Operation 16 Using the dryer 16 Using the dryer rack (Option 17 Cleaning and care 19 Cleaning the dryer 19 Cleaning the lint filter 19 Cleaning the exhaust duct 19 Cleaning the moisture sensor 19 Cleaning the bearing shield 19 Change the light bulb 20 Troubleshooting 20 SERVICE and REPAIR 21 STATEMENT OF WARRANTIES BOSCH CLOTHES DRYERS 22 Exclusions 22 2

Operating, Care, Installation (all languages) - Page 3

... SMELL GAS q Do not try to light any electrical switch. q Clear the room, building or area of all instructions before using the dryer. q If you . Bosch dryers are ...have any other information enclosed with ANSI Z21.5.1/ CGA 7.1Ć2002 Clothes Dryers Vol. dIMPORTANT SAFETY INSTRUCTIONS 1. If you have been previously cleaned, washed, soaked, or spotted with a capacity up to 17.6 lbs...

Operating, Care, Installation (all languages) - Page 7

... possible for Ć mation of the appliance. 7 Securely tighten all gas connections. W.C./ 3.49 kPa/ 0.506 psig. (Natural and Propane Gas). authorized gas supplier personnel, - Bubbles in your dealer or our customer service team (see page 21). The Bosch dryer must be vented outdoors. This gas dryer when equipped for use a plastic or nonĆmetal duct with...

Operating, Care, Installation (all languages) - Page 10

... been connected properly. Disconnect gas supply 5. If the interior of the OPERATING INSTRUCTIONS and find the fault. Look in the drum. 7. q Switch the dryer to Off". If the dryer does not work, switch the dryer to Extra Dry" and then press the Start button. q After 3-5 minutes press the Stop button and open the door. 6. Check...

Operating, Care, Installation (all languages) - Page 12

... directions. See page 18 Can be rotated in addition to the program if required). Control Panel Start/Stop button Starts, interrupts and ends the drying process. To switch off the dryer, rotate the program selector to clean the lint filter. Indicator lights (LED) Indicate the current state of the drying process is reduced, the drying time is...

Operating, Care, Installation (all languages) - Page 13

Choose an option... Using the dryer rack (Option, see page 8) ...and start the dryer. Preparing the dryer i Check the lint filter. Switch off the dryer 13 The filter should be cleaned before and after every drying process. Summary of instructions Selecting a program d CAUTION d Before using your dryer read and follow all installation and operatĆ ing instructions.

Operating, Care, Installation (all languages) - Page 14

... supply plug if possible. 4. Clean the lint filter. Do not dry anything flammable on the rating plate of the dryer, see page 23). - Use only for the household. If in doubt, contact your dealer. 7. Remove all objects from pockets. Do not store or use the dryer for the type of laundry for drying textiles which is...

Operating, Care, Installation (all languages) - Page 15

... selector is controlled via indicator lights (Drying, Damp dry, Regular dry, Wrinkle block). turn off the circuit breaker and call for the first time. Signal Your dryer outputs different signals, if the "Signal" button is active in the air. - Fasten zippers, hooks and eyes. Do not iron laundry immediately after drying. TĆshirts...

Operating, Care, Installation (all languages) - Page 16

..." indicator light starts flashing. bath towels, bathing suits, dish cloths. Cleaning the filter reduces the drying time and saves energy. 3. The dryer light turns on inside the drum. Press Delicates low temp." Select the program which is particularly thick or multiĆply Extra dry EasyĆcare (dripĆdry) laundry made of extreme sensitive textiles...

Operating, Care, Installation (all languages) - Page 17

... it is removed. Remove the lint filter. 17 If required, select Option" by pressing the button. For best results the laundry to be dried must be cleaned after each piece of drying. This prevents the laundry from creasing. Take the laundry out of shoes - The dryer light goes out. 11. Clean the filter. The filter should be sorted according to Off...

Operating, Care, Installation (all languages) - Page 18

... dryer rack or q Roll up a towel and place the heels of the shoes on next page. Trousers 60-90 min. The Start/Stop" indicator light illuminates. 3. Insert the lint filter. Laundry ...laundry items on the basket. Place laundry loosely on the dryer rack 1. Do not crush! Close the door. 4. Drying shoes on the degree of clothing so that the catches are on the rack. q Clean...

Operating, Care, Installation (all languages) - Page 20

... table. Problem Dryer does not start. Start/Stop" indicator light does not illuminate. Display may be rectified or a repair is not adequately ventilated. Lint filter dirty. Start program. 20 TO AVOID EXPLOSION HAZARD! Close the shutĆoff ". Laundry is emitted and the display shows E:01". Close door. Provide an adequate supply of the seal. Clean filter as described on...

Operating, Care, Installation (all languages) - Page 21

... bulb is blinking after lint filter has been cleaned Fault in your dryer, before calling for 30 min, switch on page 20, following information: - Tighten light bulb. Remove and reinstall the cover as a reminder. Model Number - Serial Number - Date Problem Originated - No program selected. Lint filter LED is loose. Start/Stop" indicator light does not illuminate Wrinkle...

Operating, Care, Installation (all languages) - Page 22

... conditions of normal home use, shipping costs included, labor charges excluded. 2 Year Limited Warranty on Electronics From Date of Installation* Bosch will repair or replace, free of charge, any clothes dryer after the delivery date. The Warranties provided herein are not transferable. TO THE EXTENT PERMITTED BY LAW, THIS WARRANTY IS IN...